From owner-freebsd-net Sun Mar 11 19:47:13 2001 Delivered-To: freebsd-net@freebsd.org Received: from samar.sasi.com (samar.sasken.com [164.164.56.2]) by hub.freebsd.org (Postfix) with ESMTP id 8205237B718 for ; Sun, 11 Mar 2001 19:46:59 -0800 (PST) (envelope-from sseth@sasken.com) Received: from samar (samar.sasi.com [164.164.56.2]) by samar.sasi.com (8.9.3/8.9.3) with SMTP id JAA15792; Mon, 12 Mar 2001 09:16:38 +0530 (IST) Received: from suns3.sasi.com ([10.0.36.3]) by samar.sasi.com; Mon, 12 Mar 2001 09:16:37 +0000 (IST) Received: from localhost (sseth@localhost) by suns3.sasi.com (8.9.3/8.9.3) with ESMTP id JAA02257; Mon, 12 Mar 2001 09:16:43 +0530 (IST) Date: Mon, 12 Mar 2001 09:16:43 +0530 (IST) From: Satyajeet Seth To: Julian Elischer Cc: , Subject: Re: Ping Problem In-Reply-To: <3AAC1D58.221D06F2@elischer.org> Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-net@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org Hi Please see my comments below. > > I have configured pseudo ethernet interfaces with the following > > requirements: > > 1. There is a ethernet interface fxp0 having MAC address MAC0. It also > > receives packets with destination MAC address MAC1 and MAC2. > > 2. The packets with destination MAC address MAC1 are sent to pseudo > > interface 1, nge0 and packets with destination MAC address MAC2 are sent > > to pseudo interface 2, nge1. > > > > This has been done using netgraph as follows: > > fxp0: <--> bpf <--> bpf <--> interface0 > > \ \ > > \ ------>interface1 > > \ > > \------------>interface2 > > > > I have used ng_eiface nodes impemented by Vitaly > > (available at http://www.riss-telecom.ru/~vitaly/) for interface1/2. I > > What revision of FreeBSD? eiface is now in -current. (but not built by default) > > have set fxp0 in promiscuous mode. > > > > Could you suggest why I am unable to ping the pseudo ethernet interface > > IP addresses from any of the LAN machines? > > > > Is it because fxp0 is capable of sending packets only with its own MAC address and not MAC > > addresses of nge0 and nge1? > > It's not impossible, but then bridging should fail to work too I would > think. hmm maybe not.. Does another machine see any packets on the wire > at all? If you insert a 'tee' between the bpf and the fxp do you see > outgoing packets? I am using FreeBSD 4.1. I followed Roger's suggestion about "autosrc 0" message. But "autosrc" message is not available in ng_ether. I have tried commenting bcopy((IFP2AC(priv->ifp))->ac_enaddr, eh->ether_shost, 6); in ng_ether_rcv_lower in ng_ether.c with the effect that fxp0 is able to send packets with pseudo ethernet interface MAC address. I have tried the following setup for pinging from nge0 to some machine on LAN. on pcs130 (Machine with pseudo ethernet interfaces, see output of "ifconfig -a" below) ============================== 1. #route change -host 10.0.36.134 -ifp nge0 Now arp starts to print messages like: arp: 'IP addr' is on fxp0 but got response from 'MAC address' on nge0. 2. #ping 10.0.36.134 This does not work. on pcs134(some machine on lan) ============================== Using tee's I found that 10.0.36.134 receives ethernet frames with src MAC address of nge0 and dest MAC address of 10.0.36.134. pcs134 response frames are sent to MAC address of default router 10.0.32.1. But pcs130 does not receive these frames. Thanks Satya > > My ifconfig settings and routing table entries are given below. > > > > pcs130# ifconfig -a > > fxp0: flags=8843 mtu 1500 > > inet 10.0.36.130 netmask 0xfffff000 broadcast 10.0.47.255 > > inet6 fe80::2d0:b7ff:febd:711%fxp0 prefixlen 64 scopeid 0x1 > > ether 00:d0:b7:bd:07:11 > > media: autoselect (100baseTX ) status: active > > supported media: autoselect 100baseTX 100baseTX 10baseT/UT > > P 10baseT/UTP > > lp0: flags=8810 mtu 1500 > > sl0: flags=c010 mtu 552 > > ppp0: flags=8010 mtu 1500 > > lo0: flags=8049 mtu 16384 > > inet6 fe80::1%lo0 prefixlen 64 scopeid 0x5 > > inet6 ::1 prefixlen 128 > > inet 127.0.0.1 netmask 0xff000000 > > gif0: flags=8010 mtu 1280 > > gif1: flags=8010 mtu 1280 > > gif2: flags=8010 mtu 1280 > > gif3: flags=8010 mtu 1280 > > faith0: flags=8000 mtu 1500 > > nge0: flags=8843 mtu 1500 > > inet 10.0.137.157 netmask 0xffffffff broadcast 10.0.137.157 > > inet6 fe80::211:22ff:fe33:4455%nge0 prefixlen 64 scopeid 0xb > > ether 00:11:22:33:44:55 > > nge1: flags=8843 mtu 1500 > > inet 10.0.198.158 netmask 0xffffffff broadcast 10.0.198.158 > > inet6 fe80::2d0:b7ff:febd:711%nge1 prefixlen 64 scopeid 0xc > > ether 11:22:33:44:55:66 > > pcs130# netstat -rn > > Routing tables > > Internet: > > Destination Gateway Flags Netif Expire > > default 10.0.32.1 UGSc 0 0 fxp0 > > 10.0.32/20 link#1 UC 0 0 fxp0 => > > 10.0.32.1 link#1 UHLW 1 0 fxp0 => > > 10.0.36.130 0:d0:b7:bd:7:11 UHLW 0 40 lo0 > > 10.0.137.157/32 link#11 UC 0 0 nge0 => > > 10.0.198.158/32 link#12 UC 0 0 nge1 => > > 127.0.0.1 127.0.0.1 UH 0 4 lo0 > > Internet6: > > Destination Gateway Flags Netif > > Expire > > ::1 ::1 UH lo0 > > fe80::%fxp0/64 link#1 UC fxp0 > > fe80::%lo0/64 fe80::1%lo0 Uc lo0 > > fe80::%nge0/64 link#11 UC nge0 > > fe80::%nge1/64 link#12 UC nge1 > > ff01::/32 ::1 U lo0 > > ff02::%fxp0/32 link#1 UC fxp0 > > ff02::%lo0/32 fe80::1%lo0 UC lo0 > > ff02::%nge0/32 link#11 UC nge0 > > ff02::%nge1/32 link#12 UC nge1 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-net" in the body of the message