Date: Tue, 23 Jun 1998 10:30:01 -0700 (PDT) From: Torbjorn Granlund <tege@matematik.su.se> To: freebsd-bugs@FreeBSD.ORG Subject: Re: kern/6964: Problems with cam-980520 code in FreeBSD-stable Message-ID: <199806231730.KAA00895@freefall.freebsd.org>
next in thread | raw e-mail | index | archive | help
The following reply was made to PR kern/6964; it has been noted by GNATS. From: Torbjorn Granlund <tege@matematik.su.se> To: Stefan Esser <se@freebsd.org> Cc: Subject: Re: kern/6964: Problems with cam-980520 code in FreeBSD-stable Date: Tue, 23 Jun 1998 19:20:19 +0200 > (probe17:ncr0:0:1:0): COMMAND FAILED (6 ff) @f07ea200 > (probe16:ncr0:0:1:0): COMMAND FAILED (6 ff) @f07ea800 > (probe15:ncr0:0:0:0): COMMAND FAILED (6 ff) @f07eae00 There should have been more specific error messages before these lines. The error code "6" indicates a SCSI bus reset occured. But there is not enough information available to understand what's causing this ... There are no error messages before thos messages, except for a few lines that are very similar to those lines. Seems that probing the SCSI bus connected to the NCR chip took a very long time and only found the one drive on it after the kernel tried to mount the root partition. Perhaps. Note the NCR contrller works fine with plain 2.2.6. Did you change anything else (i.e. did the system ever run with the old SCSI code) ? Yes. But then only the NCR controller were used, sine this new Adaptec controller isn't supported with the old SCSI code. Torbjorn To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-bugs" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199806231730.KAA00895>