Date: Fri, 13 Sep 2002 22:38:06 -0700 (Pacific Daylight Time) From: "Peter Gatsoulis" <pg@eth1.com> To: <freebsd-questions@FreeBSD.ORG> Subject: cdrecord mystery, seems to burn but doesn't Message-ID: <3D82CB3E.00000B.09919@kjw98se.ne.mediaone.net>
next in thread | raw e-mail | index | archive | help
PLS ALSO REPLY TO ME, pg@eth1.com
CDRECORD MYSTERY
runnin 4.6
burncd works fine with this machine's ide burner designated to burncd as
/dev/acd0c, however cdrecord reports it's working just fine as
well and it even finishes and fixates the disk. But when i pull out the
finished CD-R it doesn't look burned and i put it into another machine
and sure enough it's not...
can anyone help w/ thsi mystery
the reason cdrecord over burncd
burncd w/ thsi machine has been flaky, every 3rd-4th burn i have to try
resetting this ide burner and usually end up doing a reboot.
On this 4.6 box i dnloaded Soren's CDRTOOLS-ATA where i got this version of
cdrecord that works w/ ide burners.
I checked for /dev/ata on this 4.6 box and it does exist. reason i say this
is because of note below about building cdrecord on other box and then
copying onto this box, both boxes are 4.6 machines.
as you see below "cdrecord -scanbus" also works.
NOW the 4.6 machine that CDRTOOLS-ATA was built and this machine ARE
diffrent boxes i simply copied cdrecord, once it was built on other 4.6 box,
to this 4.6 box.
Here's the relevant output, note that cdrecord ends as if successfull but it
s NOT. tried burning at 4 speed 8 speed 12 speed etc, always
the same end, seeming as if successfull.
[root@DFY lk1] # cdrecord -v speed=4 dev=1,0,0 -data DNX.iso
Cdrecord 1.10 (i386-unknown-freebsd5.0) Copyright (C)
1995-2001 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '1,0,0'
scsibus: 1 target: 0 lun: 0
Using libscg version 'schily-0.5'
FreeBSD ATA/ATAPI backend - Copyright (C) 2000-2002
Søren Schmidt ('v1.0 ').
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 1
Vendor_info : 'CDWriter'
Identifikation : 'IDE128 '
Revision : '1.01'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : SWABAUDIO
Drive buf size : 1359872 = 1328 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 160 MB
Total size: 184 MB (18:17.41) = 82306 sectors
Lout start: 184 MB (18:19/31) = 82306 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, low Beta category (A-) (2)
ATIP start of lead in: -11634 (97:26/66)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359849 Blocks current: 359849 Blocks
remaining: 277543
Starting to write CD/DVD at speed 4 in write mode for single session.
Last chance to quit, starting real write in 0 seconds.
Operation starts.
Waiting for reader process to fill input buffer ...
input buffer ready.
Performing OPC...
Starting new track at sector: 0
Track 01: 160 of 160 MB written (fifo 100%).
Track 01: Total bytes read/written:
168558592/168558592 (82304 sectors).
Writing time: 299.393s
Fixating...
Fixating time: 189.780s
cdrecord: fifo had 2655 puts and 2655 gets.
cdrecord: fifo was 0 times empty and 2580 times full, min fill was 95%.
NOTE: CHECKED CD AND NOT BURNED THO ????
[root@DFY lk1] # dmesg
cut it out of here
then later on that day;
[root@DFY lk1] # /usr/sbin/burncd -f /dev/acd0c -s 8
data ./DNX.iso fixate
next writeable LBA 0
writing from file ./DNX.iso size 164608 KB
written this track 164608 KB (100%) total 164608 KB
fixating CD, please wait..
NOTE, pulled out the CD-R here, looked burned
allright, put it into other machine and sure enough it
reads fine.
[root@DFY lk1] #
[root@DFY lk1] # cdrecord -scanbus
Cdrecord 1.10 (i386-unknown-freebsd5.0) Copyright (C)
1995-2001 Jörg Schilling
Using libscg version 'schily-0.5'
FreeBSD ATA/ATAPI backend - Copyright (C) 2000-2002
Søren Schmidt ('v1.0
').
scsibus0:
0,0,0 0) 'ADAPTEC ' 'ACB-5500 '
'FAKE' NON CCS Disk
0,1,0 1) 'ADAPTEC ' 'ACB-5500 '
'FAKE' NON CCS Disk
0,2,0 2) *
0,3,0 3) *
0,4,0 4) *
0,5,0 5) *
0,6,0 6) *
0,7,0 7) *
scsibus1:
1,0,0 100) 'CDWriter' 'IDE128 '
'1.01' Removable CD-ROM
1,1,0 101) 'ADAPTEC ' 'ACB-5500 '
'FAKE' NON CCS Disk
1,2,0 102) *
1,3,0 103) *
1,4,0 104) *
1,5,0 105) *
1,6,0 106) *
1,7,0 107) *
[root@DFY lk1] #
[root@DFY lk1] $ cdrecord -version
Cdrecord 1.10 (i386-unknown-freebsd5.0) Copyright (C)
1995-2001 Jörg Schilling
note here; this is really Soren's CDRTOOLS-ATA
cdrecord version just dnloaded fr his site;
# uname -a
FreeBSD somemachine.baims.com 4.6-RELEASE FreeBSD
4.6-RELEASE #0: Tue Jun 18 00:34:38 EDT 2002
root@BSD1.verizon.net:/usr/src/sys/compile/ARRINEA
i386
# dmesg|grep acd
acd0: CD-RW <IDE128 CDWriter> at ata1-master PIO4
ANy help sought
thanx
PLS ALSO REPLY TO ME, pg@eth1.com
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3D82CB3E.00000B.09919>