Date: Sat, 17 Aug 1996 12:08:07 -0400 (EDT) From: Chuck Robey <chuckr@glue.umd.edu> To: Thomas Sparrevohn <staff@kyklopen.ping.dk> Cc: freebsd-current@freebsd.org Subject: Re: 82439HX registerdump patch Message-ID: <Pine.OSF.3.95.960817120652.12807A-100000@professor.eng.umd.edu> In-Reply-To: <Pine.BSI.3.95.960817171857.2351A-100000@kyklopen>
next in thread | previous in thread | raw e-mail | index | archive | help
On Sat, 17 Aug 1996, Thomas Sparrevohn wrote: > > > I just finished writing the registerdump for the 82439HX (Triton II) > chipset. Would anyone with a Triton II based motherboard help me > test it. Sure. I rebooted -v, hoping it might give you more info, here's the dmesg: _setup(1): mode 1 addr port (0x0cf8) is 0x8000005c pcibus_setup(1a): mode1res=0x80000000 (0x80000000) pcibus_check: device 0 is there (id=12508086) Probing for devices on PCI bus 0: configuration mode 1 allows 32 devices. chip0 <Intel 82439HX (Triton II) PCI cache memory controller> rev 1 on pci0:0 DRAM ECC/Parity: Parity, ECC Test disabled, Shutdown to Port 92 disabled, Dual Processor NA# disabled, Peer Concurrency disabled, SERR# Output Type: Open drain output, Global TXC disabled Cache: 512K pipelined-burst, NA Disable: disabled, Extended Cacheability disabled, SCFMI disabled, L1 enabled Speculative Leadoff enabled, Turn-around Insertion enabled, Memory Address Drive Strength: 12mA/12mA, 64 Mbit mode disabled Hole: None, EDO Detect mode disabled, DRAM Refrest Rate 66Mhz Turbo Read Leadoff disabled, DRAM Read Burst Timing: x-4-4-4/x-4-4-4, DRAM Write Burst Timing: x-4-4-4, Fast RAS to CAS Delay: 3 clocks, DRAM leadoff Timing: Read 7, Write 6, Precharge 4, Refresh 5 chip1 <generic PCI bridge (vendor=8086 device=7000 subclass=1)> rev 0 on pci0:7:0 pci0:7:1: Intel Corporation, device=0x7010, class=storage (ide) [no driver assigned] map(20): io(3000) vga0 <VGA-compatible display device> rev 83 int a irq 11 on pci0:19 mapreg[10] type=0 addr=f0000000 size=4000000. ncr0 <ncr 53c825 wide scsi> rev 17 int a irq 10 on pci0:20 mapreg[10] type=1 addr=00006000 size=0100. mapreg[14] type=0 addr=f4000000 size=0100. mapreg[18] type=0 addr=f4001000 size=1000. reg20: virtual=0xf5266000 physical=0xf4000000 size=0x100 ncr0: restart (scsi reset). ncr0 scanning for targets 0..6 and 8..15 (V2 pl23 95/09/07) ncr0 waiting for scsi devices to settle (ncr0:0:0): "CONNER CP30200 SUN0207 4234" type 0 fixed SCSI 2 sd0(ncr0:0:0): Direct-Access sd0(ncr0:0:0): 200ns (5 Mb/sec) offset 8. 203MB (416108 512 byte sectors) sd0(ncr0:0:0): with 2123 cyls, 4 heads, and an average 49 sectors/track (ncr0:1:0): "DEC DSP3210S 442A" type 0 fixed SCSI 2 sd1(ncr0:1:0): Direct-Access sd1(ncr0:1:0): FAST SCSI-2 100ns (10 Mb/sec) offset 8. 2047MB (4194303 512 byte sectors) sd1(ncr0:1:0): with 3045 cyls, 16 heads, and an average 86 sectors/track (ncr0:2:0): "DEC DSP3210D 442J" type 0 fixed SCSI 2 sd2(ncr0:2:0): Direct-Access sd2(ncr0:2:0): FAST SCSI-2 100ns (10 Mb/sec) offset 8. 2047MB (4194303 512 byte sectors) sd2(ncr0:2:0): with 3045 cyls, 16 heads, and an average 86 sectors/track pci0: uses 67113216 bytes of memory from f0000000 upto f4001fff. pci0: uses 256 bytes of I/O space from 6000 upto 60ff. Probing for devices on the ISA bus: sc0 at 0x60-0x6f irq 1 on motherboard sc0: VGA color <16 virtual consoles, flags=0x0> ed0 at 0x280-0x29f irq 15 maddr 0xd8000 msize 16384 on isa ed0: address 00:00:c0:9c:70:48, type WD8013EPC (16 bit) bpf: ed0 attached sio0 at 0x3f8-0x3ff irq 4 on isa sio0: type 16550A sio1 at 0x2f8-0x2ff irq 3 on isa sio1: type 16550A sio2 at 0x100-0x107 flags 0x905 on isa sio2: type 16550A (multiport) sio3 at 0x108-0x10f flags 0x905 on isa sio3: type 16550A (multiport) sio4 at 0x110-0x117 flags 0x905 on isa sio4: type 16550A (multiport) sio5 at 0x118-0x11f flags 0x905 on isa sio5: type 16550A (multiport) sio6 at 0x120-0x127 flags 0x905 on isa sio6: type 16550A (multiport) sio7 at 0x128-0x12f flags 0x905 on isa sio7: type 16550A (multiport) sio8 at 0x130-0x137 flags 0x905 on isa sio8: type 16550A (multiport) sio9 at 0x138-0x13f irq 5 flags 0x905 on isa sio9: type 16550A (multiport master) lpt0 at 0x378-0x37f irq 7 on isa lpt0: Interrupt-driven port lp0: TCP/IP capable interface bpf: lp0 attached fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa fdc0: NEC 72065B fd0: 1.2MB 5.25in fd1: 1.44MB 3.5in npx0 on motherboard npx0: INT 16 interface gus0 at 0x220 irq 12 drq 1 flags 0x3 on isa gus0: <Gravis UltraSound MAX (1024k)> gus0: <GUS MAX (CS4231)> imasks: bio c0000440, tty c00300ba, net c0028000 Device configuration finished. Considering FFS root f/s. configure() finished. bpf: tun0 attached bpf: lo0 attached sd1s1: type 0xa5, start 63, end = 4191263, size 4191201 : OK sd2s1: type 0xa5, start 63, end = 4191263, size 4191201 : OK ----------------------------+----------------------------------------------- Chuck Robey | Interests include any kind of voice or data chuckr@eng.umd.edu | communications topic, C programming, and Unix. 9120 Edmonston Ct #302 | Greenbelt, MD 20770 | I run Journey2 and n3lxx, both FreeBSD (301) 220-2114 | version 2.2 current -- and great FUN! ----------------------------+-----------------------------------------------
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.OSF.3.95.960817120652.12807A-100000>