Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 23 Jul 2010 23:19:39 -0400
From:      Roger Hammerstein <cheeky.m@live.com>
To:        <freebsd-current@freebsd.org>
Subject:   Re: [CFT] ZFS v15 patch (version 3)
Message-ID:  <BAY147-w50C68F7A858F4E0F66424BF9A40@phx.gbl>

next in thread | raw e-mail | index | archive | help

Forwarding to the list.

I put the patch on a Sun blade 100 with 256 megs of ram
and no issues so far.  (sparc64 architecture)

sunburn# uname -a
FreeBSD sunburn 8.1-PRERELEASE FreeBSD=20
8.1-PRERELEASE #6: Tue Jul  6 20:59:09 UTC 2010    =20
root@sunburn:/usr/obj/usr/src/sys/GENERIC  sparc64
sunburn#


This
 machine only has 256 megs of memory=2C but i made two 100 megabyte memory
 disks=2C=20
mirrored them=2C wrote some stuff=2C offlined each one=20
individually=2C and it all worked okay.

sunburn# zpool status
 =20
pool: tank
 state: ONLINE
 scrub: scrub completed after 0h0m with 0
 errors on Wed Jul  7 19:26:25 2010
config:

       =20
NAME        STATE     READ WRITE CKSUM
        tank       =20
ONLINE       0     0     0
          mirror    ONLINE       0    =20
0     0
            md101   ONLINE       0     0     0
          =20
 md102   ONLINE       0     0     0

errors: No known data errors
sunburn#

sunburn# zfs list
NAME   USED  AVAIL  REFER  MOUNTPOINT
tank  37.8M  25.7M  37.6M  /tank




Copyright
 (c) 1992-2010 The FreeBSD Project.
Copyright (c) 1979=2C 1980=2C 1983=2C=20
1986=2C 1988=2C 1989=2C 1991=2C 1992=2C 1993=2C 1994
        The Regents of the=20
University of California. All rights reserved.
FreeBSD is a=20
registered trademark of The FreeBSD Foundation.
FreeBSD=20
8.1-PRERELEASE #6: Tue Jul  6 20:59:09 UTC 2010
   =20
root@sunburn:/usr/obj/usr/src/sys/GENERIC sparc64
real memory  =3D=20
268435456 (256 MB)
avail memory =3D 243982336 (232 MB)
cpu0: Sun=20
Microsystems UltraSparc-IIe Processor (502.00 MHz CPU)
ispfw:=20
registered firmware <isp_1000>
ispfw: registered firmware=20
<isp_1040>
ispfw: registered firmware <isp_1040_it>
ispfw:
 registered firmware <isp_1080>
ispfw: registered firmware=20
<isp_1080_it>
ispfw: registered firmware <isp_12160>
ispfw:
 registered firmware <isp_12160_it>
ispfw: registered firmware=20
<isp_2100>
ispfw: registered firmware <isp_2200>
ispfw:
 registered firmware <isp_2300>
ispfw: registered firmware=20
<isp_2322>
ispfw: registered firmware <isp_2400>
ispfw:
 registered firmware <isp_2400_multi>
ispfw: registered=20
firmware <isp_2500>
ispfw: registered firmware=20
<isp_2500_multi>
kbd0 at kbdmux0
nexus0: <Open Firmware=20
Nexus device>
pcib0: <U2P UPA-PCI bridge> mem=20
0x1fe00000000-0x1fe0000ffff=2C0x1fe01000000-0x1fe010000ff irq=20
2032=2C2030=2C2031=2C2021 on nexus0
pcib0: Hummingbird compatible=2C impl 0=2C=20
version 0=2C IGN 0x1f=2C bus A=2C 33MHz
pcib0: DVMA map: 0xc0000000 to=20
0xc3ffffff 8192 entries
pcib0: [FILTER]
pcib0: [FILTER]
pcib0:=20
[GIANT-LOCKED]
pcib0: [ITHREAD]
pcib0: [FILTER]
pci0: <OFW=20
PCI bus> on pcib0
ebus0: <PCI-EBus3 bridge> mem=20
0xf0000000-0xf0ffffff=2C0xf1000000-0xf17fffff at device 12.0 on pci0
ebus0:
 <idprom>: incomplete
ebus0: <flashprom> addr 0-0xfffff=20
(no driver attached)
eeprom0: <EEPROM/clock> addr=20
0x100000000-0x100001fff on ebus0
eeprom0: model mk48t59
isab0:=20
<PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on
 isab0
gem0: <Sun ERI 10/100 Ethernet> mem 0x400000-0x41ffff at
 device 12.1 on pci0
miibus0: <MII bus> on gem0
ukphy0:=20
<Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0:=20
 10baseT=2C 10baseT-FDX=2C 100baseTX=2C 100baseTX-FDX=2C auto
gem0: 2kB RX=20
FIFO=2C 2kB TX FIFO
gem0: Ethernet address: xx:xx:xx:xx:xx
gem0:=20
[ITHREAD]
fwohci0: <Sun PCIO-2> mem=20
0x420000-0x4207ff=2C0x422000-0x4227ff at device 12.2 on pci0
fwohci0:=20
[ITHREAD]
fwohci0: OHCI version 1.0 (ROM=3D0)
fwohci0: No. of=20
Isochronous channels is 4.
fwohci0: EUI64 00:03:ba:ff:fe:0c:de:34
fwohci0:
 Phy 1394a available S400=2C 2 ports.
fwohci0: Link S400=2C max_rec 2048=20
bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
dcons_crom0:
 <dcons configuration ROM> on firewire0
dcons_crom0: bus_addr=20
0xc1128000
fwe0: <Ethernet over FireWire> on firewire0
if_fwe0:
 Fake Ethernet address: 02:03:ba:0c:de:34
fwe0: Ethernet address:=20
02:03:ba:0c:de:34
fwip0: <IP over FireWire> on firewire0
fwip0:
 Firewire address: 00:03:ba:ff:fe:0c:de:34 @ 0xfffe00000000=2C S400=2C=20
maxrec 2048
fwohci0: Initiate bus reset
fwohci0: fwohci_intr_core:
 BUS reset
fwohci0: fwohci_intr_core: node_id=3D0x00000000=2C SelfID=20
Count=3D1=2C CYCLEMASTER mode
ohci0: <Sun PCIO-2 USB controller>=20
mem 0x2000000-0x2007fff at device 12.3 on pci0
ohci0: [ITHREAD]
usbus0:
 <Sun PCIO-2 USB controller> on ohci0
pci0: <old=2C non-VGA=20
display device> at device 3.0 (no driver attached)
pci0:=20
<multimedia=2C audio> at device 8.0 (no driver attached)
atapci0:
 <AcerLabs M5229 UDMA66 controller> port=20
0xa00-0xa07=2C0xa18-0xa1b=2C0xa10-0xa17=2C0xa08-0xa0b=2C0xa20-0xa2f at devi=
ce=20
13.0 on pci0
atapci0: [ITHREAD]
atapci0: using PIO transfers above
 137GB as workaround for 48bit DMA access bug=2C expect reduced=20
performance
ata2: <ATA channel 0> on atapci0
ata2: [ITHREAD]
ata3:
 <ATA channel 1> on atapci0
ata3: [ITHREAD]
machfb0: <ATI
 Rage XL> port 0xb00-0xbff mem 0x3000000-0x3ffffff=2C0x426000-0x426fff=20
at device 19.0 on pci0
machfb0: 8 MB aperture at 0xce376000 swapped
machfb0:
 8188 KB SDRAM 114.765 MHz=2C maximum RAMDAC clock 230 MHz=2C DSP
machfb0:
 resolution 1152x900 at 8 bpp
pcib1: <OFW PCI-PCI bridge> at=20
device 5.0 on pci0
pci1: <OFW PCI bus> on pcib1
syscons0:=20
<System console> on nexus0
syscons0: Unknown <16 virtual=20
consoles=2C flags=3D0x100>
uart0: <16550 or compatible> at port=20
0x3f8-0x3ff irq 43 on isa0
uart0: [FILTER]
uart0: console=20
(9600=2Cn=2C8=2C1)
uart1: <16550 or compatible> at port 0x2e8-0x2ef=20
irq 43 on isa0
uart1: [FILTER]
Timecounter "tick" frequency=20
502000000 Hz quality 1000
Timecounters tick every 1.000 msec
firewire0:
 1 nodes=2C maxhop <=3D 0 cable IRM irm(0)  (me)
firewire0: bus=20
manager 0
usbus0: 12Mbps Full Speed USB v1.0
ad0: 8223MB=20
<Seagate ST38410A 3.13> at ata2-master UDMA66
ugen0.1:=20
<SUN> at usbus0
uhub0: <SUN OHCI root HUB=2C class 9/0=2C rev=20
1.00/1.00=2C addr 1> on usbus0
acd0: CDROM <LTN486S/YSU1> at=20
ata2-slave PIO4
GEOM: ad0: adding VTOC8 information.
uhub0: 4=20
ports with 4 removable=2C self powered
Trying to mount root from=20
ufs:/dev/ad0a
ZFS NOTICE: Prefetch is disabled by default if less=20
than 4GB of RAM is present=3B
            to enable=2C add=20
"vfs.zfs.prefetch_disable=3D0" to /boot/loader.conf.
ZFS WARNING:=20
Recommended minimum RAM size is 512MB=3B expect unstable behavior.
ZFS=20
WARNING: Recommended minimum kmem_size is 512MB=3B expect unstable=20
behavior.
             Consider tuning vm.kmem_size and=20
vm.kmem_size_max
             in /boot/loader.conf.
ZFS filesystem
 version 4
ZFS storage pool version 15




 		 	   		 =20
Hotmail is redefining busy with tools for the New Busy. Get more from your =
inbox. See how. 		 	   		 =20
_________________________________________________________________
Hotmail has tools for the New Busy. Search=2C chat and e-mail from your inb=
ox.
http://www.windowslive.com/campaign/thenewbusy?ocid=3DPID28326::T:WLMTAGL:O=
N:WL:en-US:WM_HMP:042010_1=



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?BAY147-w50C68F7A858F4E0F66424BF9A40>