From owner-freebsd-hardware Sun Apr 28 3:42:21 2002 Delivered-To: freebsd-hardware@freebsd.org Received: from twinlark.arctic.org (twinlark.arctic.org [208.44.199.239]) by hub.freebsd.org (Postfix) with ESMTP id 9782537B41E for ; Sun, 28 Apr 2002 03:42:11 -0700 (PDT) Received: (qmail 18054 invoked by uid 1347); 28 Apr 2002 10:42:01 -0000 Date: 28 Apr 2002 10:42:01 -0000 Message-ID: <20020428104201.18053.qmail@twinlark.arctic.org> From: atk2@arctic.org To: atk2@arctic.org, scott.mitchell@mail.com Subject: Re: checking hard disk -- hdparm like tool? Cc: freebsd-hardware@freebsd.org, freebsd-questions@FreeBSD.ORG In-Reply-To: <20020428113034.A20049@fishballoon.dyndns.org> Sender: owner-freebsd-hardware@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org The motherboard is an A7V333 (new board) that has a VT8233a for south bridge which supports ata133 (aka UDMA 6). The bios indicates the drive is UDMA 6 enabled. My original email suggested that maybe FreeBSD doesn't detect/understand the VT8233a and is reverting to UDMA 2 - could this be the case? the atapci0 line reads: Apr 27 18:48:34 pc1 /kernel: atapci0: port 0xb400-0xb40f irq 0 at device 17.1 on pci 0 I am 100% sure there is an 80pin cable in. I tried a 40pin cable and the bios immediately detected the difference. I also tried another OS. Oh well any/all suggestions would be useful... Alan ||From scott.mitchell@mail.com Sun Apr 28 03:30:37 2002 ||On Sat, Apr 27, 2002 at 09:36:50PM -0000, atk2@arctic.org wrote: ||> Ok -- I checked again what it has is ||> ||> ad0: 57259MB ... ata0-master WDMA2 (not sure what the 'W' is) ||> ||> If I unplug the dvd as several suggested I get ||> ||> ad0: 57259MB [116336/16/63] at ata0-master WDMA2 ||> ||> ||> (aka same thing) ||> Any suggestions on how to get it up to UDMA 5 (what is the 'W' before the DMA2? ||>From the ATA manpage, WDMA2 == DMA2 == 16MB/s. ||What motherboard and ATA controller do you have? The 'atapci0' line from ||the boot messages would be useful here. ||It might be worth checking the BIOS settings for the drive. I had a ||problem last week with an older UDMA33-capable motherboard that was putting ||everything in PIO mode when using the 'auto detect' setting. Windows and ||Debian both believed what the BIOS was telling them, which did not make for ||a good CD-burning experience :-( ||Again, if you want anything more than UDMA33 to work, you'll need the right ||cable. Are you sure you have an 80-wire cable in there? || Scott To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-hardware" in the body of the message