From owner-freebsd-scsi Thu Aug 30 0: 0:25 2001 Delivered-To: freebsd-scsi@freebsd.org Received: from smtp4.ihug.co.nz (smtp4.ihug.co.nz [203.109.252.5]) by hub.freebsd.org (Postfix) with ESMTP id 1A59937B408 for ; Thu, 30 Aug 2001 00:00:19 -0700 (PDT) (envelope-from kluckie@ihug.co.nz) Received: from neoprene (203-173-203-136.nzwide.ihug.co.nz [203.173.203.136]) by smtp4.ihug.co.nz (8.9.3/8.9.3/Debian 8.9.3-21) with SMTP id TAA27985 for ; Thu, 30 Aug 2001 19:00:15 +1200 X-Authentication-Warning: smtp4.ihug.co.nz: Host 203-173-203-136.nzwide.ihug.co.nz [203.173.203.136] claimed to be neoprene Message-ID: <002701c13121$5159dc90$0a00a8c0@neoprene> From: "Matthew Luckie" To: References: <003201c130e4$1819b820$0a00a8c0@neoprene> <20010829182812.A41417@panzer.kdm.org> Subject: Re: aic6360 Date: Thu, 30 Aug 2001 18:58:55 +1200 MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit X-Priority: 3 X-MSMail-Priority: Normal X-Mailer: Microsoft Outlook Express 5.50.4522.1200 X-MimeOLE: Produced By Microsoft MimeOLE V5.50.4522.1200 Sender: owner-freebsd-scsi@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org > camcontrol negotiate da0 -T disable -a -v > > There are two basic possibilities here. The first is that that drive > doesn't handle tagged queueing very well. The second is that the driver > isn't doing the right thing. > > This may fix it in either case. it seems to be working a lot better: i put /usr/src on there, and cvsup'd my source and did a make buildworld. /usr/obj is on another disk. however, at a portion through the build process the build froze, and an inspection of the dmesg shows this: Aug 30 18:27:56 lycra /kernel: (da0:aic0:0:6:0): ccb 0xc0a8e400 - timed out, phase 0xe6, state 4 Aug 30 18:28:01 lycra /kernel: (da0:aic0:0:6:0): ccb 0xc0a8e400 - timed out, phase 0xf6, state 4 Aug 30 18:29:16 lycra /kernel: (da0:aic0:0:6:0): ccb 0xc0a8e400 - timed out, phase 0xa6, state 4 Aug 30 18:29:21 lycra /kernel: (da0:aic0:0:6:0): ccb 0xc0a8e400 - timed out, phase 0xa6, state 4 at the time i was about to have dinner, so i left it and when i came back 20 minutes later the build process was going again. bash-2.05# camcontrol negotiate da0 Current Parameters: (pass0:aic0:0:6:0): sync parameter: 50 (pass0:aic0:0:6:0): frequency: 5.000MHz (pass0:aic0:0:6:0): offset: 8 (pass0:aic0:0:6:0): bus width: 8 bits (pass0:aic0:0:6:0): disconnection is enabled (pass0:aic0:0:6:0): tagged queueing is disabled is there anything else to try? its going, but these messages are a little unsettling. its probably bad (old) hardware. Matthew To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-scsi" in the body of the message