From owner-freebsd-hackers Sat May 3 00:48:17 1997 Return-Path: Received: (from root@localhost) by hub.freebsd.org (8.8.5/8.8.5) id AAA17864 for hackers-outgoing; Sat, 3 May 1997 00:48:17 -0700 (PDT) Received: from sax.sax.de (sax.sax.de [193.175.26.33]) by hub.freebsd.org (8.8.5/8.8.5) with SMTP id AAA17859 for ; Sat, 3 May 1997 00:48:15 -0700 (PDT) Received: (from uucp@localhost) by sax.sax.de (8.6.12/8.6.12-s1) with UUCP id JAA03452 for hackers@FreeBSD.ORG; Sat, 3 May 1997 09:48:13 +0200 Received: (from j@localhost) by uriah.heep.sax.de (8.8.5/8.8.5) id JAA03383; Sat, 3 May 1997 09:29:32 +0200 (MET DST) Message-ID: <19970503092932.MV50905@uriah.heep.sax.de> Date: Sat, 3 May 1997 09:29:32 +0200 From: j@uriah.heep.sax.de (J Wunsch) To: hackers@FreeBSD.ORG Subject: Re: WD and SD drives with NCR 53C400 card References: <19970502203633.45646@hydrogen.nike.efn.org> X-Mailer: Mutt 0.60_p2-3,5,8-9 Mime-Version: 1.0 X-Phone: +49-351-2012 669 X-PGP-Fingerprint: DC 47 E6 E4 FF A6 E9 8F 93 21 E0 7D F9 12 D6 4E Reply-To: joerg_wunsch@uriah.heep.sax.de (Joerg Wunsch) In-Reply-To: <19970502203633.45646@hydrogen.nike.efn.org>; from John-Mark Gurney on May 2, 1997 20:36:33 -0700 Sender: owner-hackers@FreeBSD.ORG X-Loop: FreeBSD.org Precedence: bulk As John-Mark Gurney wrote: > it should work fine... just use the nca device driver... the T130B is an > 8bit board based on the NCR53C400 or Zilog chips right? > > I had a similar board that I used for scsi before I got a real scsi card... I never had any luck using the cheap NCR 53C400-based boards that accompany HP ScanJets. This might be a question of finding the correct IO port number for them, since these boards are undocumented. Does anybody have a list of IO addresses for them? At least, the usual port numbers mentioned in GENERIC didn't work. (The boards are no doubt 53C400, so the nca driver should work.) -- cheers, J"org joerg_wunsch@uriah.heep.sax.de -- http://www.sax.de/~joerg/ -- NIC: JW11-RIPE Never trust an operating system you don't have sources for. ;-)