From owner-aic7xxx Thu May 17 1:22:38 2001 Delivered-To: aic7xxx@freebsd.org Received: from hmljs.rzs-hm.si (hmljs.rzs-hm.si [193.2.208.10]) by hub.freebsd.org (Postfix) with ESMTP id 6A16437B42C for ; Thu, 17 May 2001 01:22:27 -0700 (PDT) (envelope-from metod.kozelj@rzs-hm.si) Received: from hmljhp.rzs-hm.si (hmljhp.rzs-hm.si [193.2.208.12]) by rzs-hm.si (PMDF V5.2-31 #39364) with ESMTP id <01K3NWQBJHFS000D7J@rzs-hm.si> for aic7xxx@FreeBSD.ORG; Thu, 17 May 2001 08:22:24 GMT Received: from localhost by hmljhp with SMTP (8.7.1/8.7.1) id KAA07549; Thu, 17 May 2001 10:22:23 +0200 (CEST) Date: Thu, 17 May 2001 10:22:23 +0200 (CEST) From: Metod Kozelj Subject: Re: Weird problem In-reply-to: To: "Justin T. Gibbs" Cc: aic7xxx@FreeBSD.ORG Message-id: MIME-version: 1.0 Content-type: TEXT/PLAIN; charset=US-ASCII Sender: owner-aic7xxx@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org Hello, On Thu, 17 May 2001, I wrote: > > Does the driver report any messages to the console? If so, run with > > "aic7xxx=verbose" and send me the messages. You may need to setup a > > serial console to acurately capture the messages. > > The output from different tries was different every time: Well, I forgot to send you typical boot-up messages, just in case they are interesting. See below. Regards, Metod Metod Kozelj mailto:Metod.Kozelj@rzs-hm.si /\ Ne posiljajte mi smeti ker grizem! http://www.rzs-hm.si/ / \ Don't spam me for I bite! _______________________________________/ \__________________________________ ---- perl -e 'print $i=pack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(115),10);' ----------------------- Linux version 2.4.4 (metodk@fractus) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #2 Thu May 17 07:22:46 CEST 2001 Booting on EB164 variation SX164 using machine vector SX164 from SRM Command line: root=/dev/sda4 console=ttyS0 aic7xxx=verbose memcluster 0, usage 1, start 0, end 256 memcluster 1, usage 0, start 256, end 16374 memcluster 2, usage 1, start 16374, end 16384 freeing pages 256:1024 freeing pages 1288:16374 PCA56 MVI set enabled pci: cia revision 1 (pyxis) On node 0 totalpages: 16384 zone(0): 16384 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/sda4 console=ttyS0 aic7xxx=verbose Using epoch = 1952 Console: colour VGA+ 80x25 Calibrating delay loop... 1057.24 BogoMIPS Memory: 124616k/130992k available (1178k kernel code, 4328k reserved, 289k data, 256k init) Dentry-cache hash table entries: 16384 (order: 5, 262144 bytes) Buffer-cache hash table entries: 1024 (order: 0, 8192 bytes) Page-cache hash table entries: 16384 (order: 4, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 131072 bytes) VFS: Diskquotas version dquot_6.4.0 initialized POSIX conformance testing by UNIFIX pci: passed tb register update test pci: passed sg loopback i/o read test pci: passed tbia test pci: passed pte write cache snoop test pci: failed valid tag invalid pte reload test (mcheck; workaround available) pci: passed pci machine check test got res[8000:80ff] for resource 0 of Adaptec AIC-7881U got res[8400:847f] for resource 0 of 3Com Corporation 3c905B 100BaseTX [Cyclone] got res[8480:848f] for resource 4 of Contaq Microsystems 82c693 (#2) got res[9000000:9ffffff] for resource 0 of Matrox Graphics, Inc. MGA 2164W [Millennium II] got res[a000000:a7fffff] for resource 2 of Matrox Graphics, Inc. MGA 2164W [Millennium II] got res[a800000:a81ffff] for resource 6 of 3Com Corporation 3c905B 100BaseTX [Cyclone] got res[a820000:a82ffff] for resource 6 of Matrox Graphics, Inc. MGA 2164W [Millennium II] got res[a830000:a83ffff] for resource 6 of Adaptec AIC-7881U got res[a840000:a84ffff] for resource 4 of Contaq Microsystems 82c693 (#3) got res[a850000:a853fff] for resource 1 of Matrox Graphics, Inc. MGA 2164W [Millennium II] got res[a854000:a854fff] for resource 1 of Adaptec AIC-7881U got res[a855000:a855fff] for resource 0 of Contaq Microsystems 82c693 (#4) got res[a856000:a85607f] for resource 1 of 3Com Corporation 3c905B 100BaseTX [Cyclone] PCI enable device: (Matrox Graphics, Inc. MGA 2164W [Millennium II]) cmd reg 0x7 PCI enable device: (Adaptec AIC-7881U) cmd reg 0x7 PCI enable device: (Contaq Microsystems 82c693) cmd reg 0x7 PCI enable device: (Contaq Microsystems 82c693 (#2)) cmd reg 0x5 PCI enable device: (Contaq Microsystems 82c693 (#3)) cmd reg 0x7 PCI enable device: (Contaq Microsystems 82c693 (#4)) cmd reg 0x6 PCI enable device: (3Com Corporation 3c905B 100BaseTX [Cyclone]) cmd reg 0x7 SMC37c669 Super I/O Controller found @ 0x3f0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Starting kswapd v1.8 pty: 256 Unix98 ptys configured block: queued sectors max/low 82560kB/27520kB, 256 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx CY82C693: IDE controller on PCI bus 00 dev 41 CY82C693: chipset revision 0 CY82C693: not 100% native mode: will probe irqs later CY82C693U driver v0.34 99-13-12 Andreas S. Krebs (akrebs@altavista.net) ide0: BM-DMA at 0x8480-0x8487, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0x8488-0x848f, BIOS settings: hdc:DMA, hdd:DMA hda: FUJITSU MPD3043AT, ATA DISK drive ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx hdc: IOMEGA ZIP 100 ATAPI, ATAPI FLOPPY drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 8448300 sectors (4326 MB) w/512KiB Cache, CHS=8940/15/63, (U)DMA Partition check: hda: hda1 hda2 hda3 hda8 Serial driver version 5.05a (2001-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A rtc: Digital UNIX epoch (1952) detected Real Time Clock Driver v1.10d SCSI subsystem driver Revision: 1.00 ahc_pci:0:6:0: Reading SEEPROM...done. ahc_pci:0:6:0: internal 50 cable is present, internal 68 cable is present ahc_pci:0:6:0: external cable not present ahc_pci:0:6:0: BIOS eeprom is present ahc_pci:0:6:0: High byte termination Enabled ahc_pci:0:6:0: Downloading Sequencer Program... 436 instructions downloaded scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.13 aic7880: Ultra Wide Channel A, SCSI Id=7, 16/255 SCBs Vendor: SEAGATE Model: ST34572N Rev: 0784 Type: Direct-Access ANSI SCSI revision: 02 Vendor: DEC Model: RZ28D (C) DEC Rev: 0008 Type: Direct-Access ANSI SCSI revision: 02 Vendor: NEC Model: CD-ROM DRIVE:465 Rev: 1.03 Type: CD-ROM ANSI SCSI revision: 02 (scsi0:A:0): 3.300MB/s transfers scsi0:0:0:0: Tagged Queuing enabled. Depth 253 (scsi0:A:1): 3.300MB/s transfers scsi0:0:1:0: Tagged Queuing enabled. Depth 253 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0 (scsi0:A:0:0): Sending SDTR period c, offset f (scsi0:A:0:0): Received SDTR period c, offset f Filtered to period c, offset f (scsi0:A:0): 20.000MB/s transfers (20.000MHz, offset 15) scsi0: target 0 synchronous at 20.0MHz, offset = 0xf (scsi0:A:0:0): Sending SDTR period c, offset f (scsi0:A:0:0): Received SDTR period c, offset f Filtered to period c, offset f SCSI device sda: 8888924 512-byte hdwr sectors (4551 MB) sda: sda1 sda2 sda3 sda4 sda5 (scsi0:A:1:0): Sending WDTR 1 (scsi0:A:1:0): Received WDTR 1 filtered to 1 (scsi0:A:1): 6.600MB/s transfers (16bit) scsi0: target 1 using 16bit transfers (scsi0:A:1:0): Sending SDTR period c, offset 8 (scsi0:A:1:0): Received SDTR period 19, offset 8 Filtered to period 19, offset 8 (scsi0:A:1): 20.000MB/s transfers (10.000MHz, offset 8, 16bit) scsi0: target 1 synchronous at 10.0MHz, offset = 0x8 (scsi0:A:1:0): Sending WDTR 1 (scsi0:A:1:0): Received WDTR 1 filtered to 1 (scsi0:A:1): 6.600MB/s transfers (16bit) scsi0: target 1 using asynchronous transfers (scsi0:A:1:0): Sending SDTR period 19, offset 8 (scsi0:A:1:0): Received SDTR period 19, offset 8 Filtered to period 19, offset 8 (scsi0:A:1): 20.000MB/s transfers (10.000MHz, offset 8, 16bit) scsi0: target 1 synchronous at 10.0MHz, offset = 0x8 SCSI device sdb: 4110480 512-byte hdwr sectors (2105 MB) sdb: sdb1 sdb3 sdb8 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 256k freed Adding Swap: 270992k swap-space (priority 10) Adding Swap: 118864k swap-space (priority 5) Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996 SB 4.13 detected OK (220) at 0x220 irq 10 dma 1,5 at 0x330 irq 10 dma 0,0 3c59x.c:LK1.1.13 27 Jan 2001 Donald Becker and others. http://www.scyld.com/network/vortex.html See Documentation/networking/vortex.txt eth0: 3Com PCI 3c905B Cyclone 100baseTx at 0x8400, 00:50:04:66:df:0b, IRQ 24 product code 544e rev 00.9 date 02-10-99 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface. MII transceiver found at address 24, status 782d. Enabling bus-master transmits and whole-frame receives. eth0: scatter/gather enabled. h/w checksums enabled eth0: using NWAY device table, not 8 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe aic7xxx" in the body of the message