Date: Tue, 30 Oct 2012 13:10:37 -0400 From: Tom Judge <tom@tomjudge.com> To: Garrett Cooper <yanegomi@gmail.com> Cc: "freebsd-net@freebsd.org" <freebsd-net@freebsd.org>, Adam McDougall <mcdouga9@egr.msu.edu> Subject: Re: bxe + if_lagg Message-ID: <50900A0D.7080502@tomjudge.com> In-Reply-To: <D4C7E4E8-AD7C-4893-9DBA-3CAC14C9788E@gmail.com> References: <508FF0F9.9020105@freebsd.org> <508FFC57.6040302@egr.msu.edu> <50900415.8060602@tomjudge.com> <D4C7E4E8-AD7C-4893-9DBA-3CAC14C9788E@gmail.com>
next in thread | previous in thread | raw e-mail | index | archive | help
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On 30/10/2012 12:51, Garrett Cooper wrote: > On Oct 30, 2012, at 9:45 AM, Tom Judge <tom@tomjudge.com> wrote: > >> -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 >> >> On 30/10/2012 12:12, Adam McDougall wrote: >>> On 10/30/12 11:23, Tom Judge wrote: >>>> -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 >>>> >>>> >>>> >>>> I am trying to get if_lagg working in an HP blade for >>>> failover between the 2 in chassis cisco switches, but it >>>> would seem that the link state is not being propagated up to >>>> the lagg device. >>>> >>>> Any hints/ideas? >>>> >>>> >>>> >>>> dmesg: bxe1: <Broadcom NetXtreme II BCM57711E 10GbE (A0) BXE >>>> v:1.5.52 bxe1: Ethernet address: 00:25:b3:a8:76:e4 bxe1: >>>> ASIC (0x16500000); Rev (A0); Bus (PCIe x4, 5Gbps); Flags >>>> (MSI-X); Queues (RSS:16); BD's (RX:510,TX:255); Firmware >>>> (5.2.13); Bootcode (4.8.0) >>>> >>>> >>>> >>>> bxe1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> >>>> metric 0 mtu 1500 >>>> options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4> >> >>>> ether 00:25:b3:a8:76:e4 >>>> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> media: >>>> Ethernet autoselect (10Gbase-SR <full-duplex>) status: >>>> active >>>> >>>> lagg0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> >>>> metric 0 mtu 1500 >>>> options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4> >> >>>> ether 00:25:b3:a8:76:e4 >>>> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> media: >>>> Ethernet autoselect status: no carrier laggproto failover >>>> laggport: bxe1 flags=1<MASTER> >>> >>> Do you need two physical interfaces configured for failover >>> mode to do any good? >> >> Forgot to mention this is 9.0-RELEASE. >> >> No, a single interface should set status active: >> >> bce0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 >> mtu 1500 >> options=c01bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,VLAN_HWTSO,LINKSTATE> >> >> ether 00:1e:0b:c4:00:a2 >> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> media: >> Ethernet autoselect (1000baseSX <full-duplex>) status: active >> >> lagg0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric >> 0 mtu 1500 >> options=c01bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,VLAN_HWTSO,LINKSTATE> >> >> ether 00:1e:0b:c4:00:a2 >> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> media: >> Ethernet autoselect status: active laggproto failover laggport: >> bce0 flags=5<MASTER,ACTIVE> > > Have you tried ifconfig up'ing the lagg? Shouldn't have to if > things were functioning properly, but you might have to. > > If that works, then assigning an address to the interface or adding > an ifconfig up in rc.local might workaround the issue. > Nope these don't resolve the issue, its almost like lagg cant see the link state of the members. Tom -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.12 (Darwin) Comment: Using GnuPG with Mozilla - http://www.enigmail.net/ iQEcBAEBAgAGBQJQkAoNAAoJEEJSM9yB4iIWyKEH/05lgpN4U7UzNuhLCXq5Wi33 GlpGX3yFWVS/eFo3HYv5aMh6KyF8THrlfiqWA+PYjdk7qHwa9iwLbOrr/XwtqbbV ZtKYFYPWd/gVGEwvE273u/tqQGHHn7FtoY1wQUCry1F3WcVjbY00ZjtOYzqnHZcd NYY/VhkViqh2MaD3CmIWUARRwTjm1k/km6NcUmjsb49FcMT6XpkVQYRkLJc7SQtI li4HnppzU2LIJaI1PaPGlFHEJXYX5qkiH19hA8AFxxXCyB8MA+SZN1JY2nX7OE3N mvy/FlmBkbb/V5TnPCksjaZne2Rkw/xugi7NTG2MWeLtGOmxBmDZU78ZJmAd4GA= =7lbT -----END PGP SIGNATURE-----
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?50900A0D.7080502>