Date: Thu, 03 Jun 2004 03:59:23 -0700 From: JBL <jbl@tegatai.com> To: freebsd-mobile@freebsd.org Subject: Dell Latitude D600 fully supported Message-ID: <1086260350.41784.14.camel@reload.subterrain.net>
next in thread | raw e-mail | index | archive | help
Fully supported! Dell Latitude D600, 1GB RAM, USB 2.0, AC'97 Audio, Broadcom GbE, 1400x1050, 200mw Prism2. Very nice. ;) Copyright (c) 1992-2004 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.2.1-RELEASE-p5 #4: Sun May 2 23:00:39 PDT 2004 jbl@booyaka.subterrain.net:/usr/obj/usr/src/sys/RESPECT Preloaded elf kernel "/boot/kernel/kernel" at 0xc097e000. Preloaded elf module "/boot/kernel/acpi.ko" at 0xc097e1cc. Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Intel(R) Pentium(R) M processor 1700MHz (1694.51-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x695 Stepping = 5 Features=0xa7e9f9bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,TM,PBE> real memory = 1073405952 (1023 MB) avail memory = 1033244672 (985 MB) Pentium Pro MTRR support enabled npx0: [FAST] npx0: <math processor> on motherboard npx0: INT 16 interface acpi0: <DELL CPi R > on motherboard pcibios: BIOS version 2.10 Using $PIR table, 9 entries at 0xc00fc590 Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000 acpi_timer0: <24-bit timer at 3.579545MHz> port 0x808-0x80b on acpi0 acpi_cpu0: <CPU> on acpi0 acpi_tz0: <Thermal Zone> on acpi0 acpi_acad0: <AC Adapter> on acpi0 acpi_cmbat0: <Control Method Battery> on acpi0 acpi_cmbat1: <Control Method Battery> on acpi0 acpi_lid0: <Control Method Lid Switch> on acpi0 acpi_button0: <Power Button> on acpi0 acpi_button1: <Sleep Button> on acpi0 pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0 pci0: <ACPI PCI bus> on pcib0 pcib0: slot 29 INTA is routed to irq 11 pcib0: slot 29 INTB is routed to irq 11 pcib0: slot 29 INTC is routed to irq 11 pcib0: slot 29 INTD is routed to irq 11 pcib0: slot 31 INTB is routed to irq 11 pcib0: slot 31 INTB is routed to irq 11 agp0: <Intel 82855 host to AGP bridge> mem 0xe0000000-0xe7ffffff at device 0.0 on pci0 pcib1: <ACPI PCI-PCI bridge> at device 1.0 on pci0 pci1: <ACPI PCI bus> on pcib1 pcib1: slot 0 INTA is routed to irq 11 pci1: <display, VGA> at device 0.0 (no driver attached) uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0xbf80-0xbf9f irq 11 at device 29.0 on pci0 usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhci1: <Intel 82801DB (ICH4) USB controller USB-B> port 0xbf40-0xbf5f irq 11 at device 29.1 on pci0 usb1: <Intel 82801DB (ICH4) USB controller USB-B> on uhci1 usb1: USB revision 1.0 uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered uhci2: <Intel 82801DB (ICH4) USB controller USB-C> port 0xbf20-0xbf3f irq 11 at device 29.2 on pci0 usb2: <Intel 82801DB (ICH4) USB controller USB-C> on uhci2 usb2: USB revision 1.0 uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub2: 2 ports with 2 removable, self powered pci0: <serial bus, USB> at device 29.7 (no driver attached) pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0 pci2: <ACPI PCI bus> on pcib2 pcib2: slot 0 INTA is routed to irq 11 pcib2: slot 3 INTA is routed to irq 11 bge0: <Broadcom BCM5702 Gigabit Ethernet, ASIC rev. 0x1002> mem 0xfaff0000-0xfaffffff irq 11 at device 0.0 on pci2 bge0: Ethernet address: 00:0d:56:78:7e:7d miibus0: <MII bus> on bge0 brgphy0: <BCM5703 10/100/1000baseTX PHY> on miibus0 brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 1000baseTX-FDX, auto cbb0: <PCI-CardBus Bridge> at device 1.0 on pci2 cardbus0: <CardBus bus> on cbb0 pccard0: <16-bit PCCard bus> on cbb0 pcib2: slot 1 INTA is routed to irq 11 cbb0: [MPSAFE] cbb1: <PCI-CardBus Bridge> at device 1.1 on pci2 cardbus1: <CardBus bus> on cbb1 pccard1: <16-bit PCCard bus> on cbb1 pcib2: slot 1 INTA is routed to irq 11 cbb1: [MPSAFE] pci2: <network> at device 3.0 (no driver attached) isab0: <PCI-ISA bridge> at device 31.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel ICH4 UDMA100 controller> port 0xbfa0-0xbfaf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 31.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata0: [MPSAFE] ata1: at 0x170 irq 15 on atapci0 ata1: [MPSAFE] pci0: <multimedia, audio> at device 31.5 (no driver attached) pci0: <simple comms> at device 31.6 (no driver attached) atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model GlidePoint, device ID 0 sio0 port 0x3f8-0x3ff irq 4 on acpi0 sio0: type 16550A ppc0 port 0x778-0x77b,0x378-0x37f irq 7 drq 1 on acpi0 ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode ppc0: FIFO with 16/16/8 bytes threshold ppbus0: <Parallel port bus> on ppc0 plip0: <PLIP network interface> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port ppi0: <Parallel I/O> on ppbus0 orm0: <Option ROM> at iomem 0xc0000-0xcffff on isa0 pmtimer0 on isa0 fdc0: ready for input in output fdc0: cmd 3 failed at out byte 1 of 3 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio1: configured irq 3 not in bitmap of probed irqs 0 sio1: port may not be enabled vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 Timecounter "TSC" frequency 1694511986 Hz quality 800 Timecounters tick every 10.000 msec acpi_cpu: throttling enabled, 8 steps (100% to 12.5%), currently 100.0% acpi_cpu0: Performance states changed wi0: <INTERSIL HFA384x/IEEE> at port 0x100-0x13f irq 11 function 0 config 1 on pccard0 wi0: 802.11 address: 00:02:6f:32:aa:00 wi0: using RF:PRISM2.5 MAC:ISL3873 wi0: Intersil Firmware: Primary (1.1.0), Station (1.4.9) wi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps pccard1: <unknown card> (manufacturer=0xffff, product=0x0001) at function 0 pccard1: CIS info: O2Micro, SmartCardBus Reader, V1.0 GEOM: create disk ad0 dp=0xc6b87b60 ad0: 76319MB <IC25N080ATMR04-0> [155061/16/63] at ata0-master UDMA100 acd0: CDRW <HL-DT-STCD-RW/DVD-ROM GCC-4241N> at ata1-master PIO4 GEOM: create disk cd0 dp=0xc6995e00 cd0 at ata1 bus 0 target 0 lun 0 cd0: <HL-DT-ST RW/DVD GCC-4241N A100> Removable CD-ROM SCSI-0 device cd0: 16.000MB/s transfers cd0: cd present [198466 x 2048 byte records] Mounting root from ufs:/dev/ad0s3a pflog: $Name: VERSION_2_03 $ pfsync: $Name: VERSION_2_03 $ in6_ifattach: pflog0 is not multicast capable, IPv6 not enabled in6_ifattach: pfsync0 is not multicast capable, IPv6 not enabled pflog0: promiscuous mode enabled pf: $Name: VERSION_2_03 $
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?1086260350.41784.14.camel>