Date: Sun, 18 May 2003 21:37:48 -0400 From: Bob K <melange@yip.org> To: freebsd-mobile@freebsd.org Subject: Franklin (Starfish) REX - which driver? Message-ID: <3EC8356C.3090307@yip.org>
next in thread | raw e-mail | index | archive | help
Please cc: me in any replies; I'm not on the list.
I'm trying to get a Franklin REX-3 (an ancient organizer built into a
type II PCMCIA card, later versions came under the banner of Xircom) to
sync under FreeBSD 4.8-STABLE. I'm at the point where I'm trying to
figure out which driver to put in my pccard.conf. Here's the results of
pccardc dumpcis:
Configuration data for card in slot 0
Tuple #1, code = 0x1 (Common memory descriptor), length = 3
000: 6a 0c ff
Common memory device information:
Device number 1, type SRAM, WPS = ON
Speed = 200nS, Memory block size = 128Kb, 2 units
Tuple #2, code = 0x15 (Version 1 info), length = 27
000: 04 01 53 74 61 72 66 69 73 68 2c 20 49 6e 63 2e
010: 00 52 45 58 2d 33 30 30 30 00 ff
Version = 4.1, Manuf = [Starfish, Inc.], card vers = [REX-3000]
Tuple #3, code = 0x17 (Attribute memory descriptor), length = 4
000: 17 3a 00 ff
Attribute memory device information:
Device number 1, type Mask ROM, WPS = OFF
Speed = 3.0 x 100 ns, Memory block size = 512b, 1 units
Tuple #4, code = 0xff (Terminator), length = 0
2 slots found
The documentation for the Starfish TrueSync Connectivity Pack for Linux
wants it to bind to the linux memory_cs driver, which is documented
here: http://www.linux-mtd.infradead.org/
Which finally brings me to my questions: Is there an equivalent driver
in FreeBSD? Can I use the fla (DiskOnChip) driver? Am I asking the
wrong list?
Thanks in advance for any pointers.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3EC8356C.3090307>