Date: Tue, 1 Jul 2008 22:01:44 +1200 From: "Rohit Grover" <rgrover1@gmail.com> To: Volker <volker@vwsoft.com> Cc: freebsd-embedded@freebsd.org Subject: Re: having trouble receiving serial data using my USB->serial adaptor Message-ID: <426bed110807010301j132a75f4q1c85fce62ca85188@mail.gmail.com> In-Reply-To: <4869337C.6050105@vwsoft.com> References: <426bed110806300025j5a92080bx59cdb2248c77b8c0@mail.gmail.com> <4869337C.6050105@vwsoft.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi, Thanks for the response. I stumbled upon the solution quite by chance. My USB->serial adaptor has a NULL modem built into it, so attaching an external NULL modem was un-necessary and incorrect. It is a wonder that the devices survived this treatment. thanks again. regards, > > > I am having trouble getting my BAFO 810 USB->serial adaptor to > > work. I have built the uplcom and ucom drivers into the kernel, > > and my USB->serial adaptor is recognized at boot, as can be > > inferred from the following lines from /var/run/dmesg.boot: > > > > ucom0: <Prolific Technology Inc. USB-Serial Controller, class > > 0/0, rev 1.10/3.\ 00, addr 2> on uhub3 > > > > I am using minicom to drive /dev/cuaU0 at 115200 8N1. > > > > If I connect the Tx and Rx lines (pins 2 and 3) of the DB9 > > connector, I can get echoes of my keystrokes on the minicom > > terminal. > > > > Unfortunately, I am unable to connect to an embedded device which > > supports serial connections at 115200 8N1. When I plug the serial > > output connector of my adaptor to a NULL modem and then to the > > target embedded system, I don't see any serial output from the > > device on my minicom terminal. This same device communicates > > correctly with the serial port of my linux desktop with minicom > > and 115200 8N1. > > > > As a further experiment, I manually connected pins 2,3, and 5 of > > the serial end of my adaptor to pins 3,2, and 5 respectively of > > the embedded device, but still no luck. > > > > What am I missing? > > > > regards, > > > > > Rohit, > > hard to tell on the distance but if you're able to receive (using a > loopback adapter), it sounds like either side is most likely requiring > hardware handshake (DSR/DTR, RTS/CTS). > > Sometimes it helps to short cut the DCD line (to RTS/DSR), as some > device refuse to send if DCD is not set. If you're owning a break out > box, it should be snap to figure that out. At least you should check > using a serial line tester (those little tools signaling line status > using LEDs or use a Voltmeter to check for correct line status). > > Volker >
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?426bed110807010301j132a75f4q1c85fce62ca85188>