Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 22 May 1995 17:18:25 -0700 (PDT)
From:      "Rodney W. Grimes" <rgrimes@gndrsh.aac.dev.com>
To:        mmead@Glock.COM (matthew c. mead)
Cc:        hackers@FreeBSD.org
Subject:   Re: Diagnostics for a hanging machine?
Message-ID:  <199505230018.RAA06382@gndrsh.aac.dev.com>
In-Reply-To: <199505222027.QAA10490@Glock.COM> from "matthew c. mead" at May 22, 95 04:27:40 pm

next in thread | previous in thread | raw e-mail | index | archive | help
> 
> On Mon, May 22, 1995 at 11:23:49 (-0700), Rodney W. Grimes wrote:
> 
>  > I think I spotted your problem in your response to Mycroft, it looked
>  > like you where using the aha driver for the bt card.  Could you please
>  > send me the output of dmesg from booting this box with FreeBSD?  If
>  > infact you are using the aha driver it would explain a *lot* of the
>  > problem.
> 
> 	Well, I spend about an hour with the machine trying to figure out
> how to get it to recognize the controller as bt0.  No go.  How do I get the
> BT742 into NON Adaptec 1542 mode?  I have it at 0x330, irq 12, and the bt0
> device does *not* recognize it.  Once it's probed and fails, it picks it up
> as aha0.  Any ideas?  Thanks for the help!

Does it have an enhanced mode in the setup screen for it???? Can you
send me the !BTxxxx.xxx EISA config file for it, I can probably figure
it out from that.



-- 
Rod Grimes                                      rgrimes@gndrsh.aac.dev.com
Accurate Automation Company                   Custom computers for FreeBSD



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199505230018.RAA06382>