From owner-freebsd-mobile Mon May 6 23:11:58 2002 Delivered-To: freebsd-mobile@freebsd.org Received: from zibbi.icomtek.csir.co.za (zibbi.icomtek.csir.co.za [146.64.24.58]) by hub.freebsd.org (Postfix) with ESMTP id 1431737B405 for ; Mon, 6 May 2002 23:11:47 -0700 (PDT) Received: (from jhay@localhost) by zibbi.icomtek.csir.co.za (8.11.6/8.11.6) id g47654P81869; Tue, 7 May 2002 08:05:04 +0200 (SAT) (envelope-from jhay) From: John Hay Message-Id: <200205070605.g47654P81869@zibbi.icomtek.csir.co.za> Subject: Re: ok then stupid question about IBSS mode In-Reply-To: <3CD72255.A1120623@acm.org> from "Mark A-J. Raught" at "May 6, 2002 08:39:49 pm" To: mraught@acm.org (Mark A-J. Raught) Date: Tue, 7 May 2002 08:05:04 +0200 (SAT) Cc: freebsd-mobile@FreeBSD.ORG X-Mailer: ELM [version 2.4ME+ PL54 (25)] MIME-Version: 1.0 Content-Type: text/plain; charset=US-ASCII Content-Transfer-Encoding: 7bit Sender: owner-freebsd-mobile@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org > > > > > > So we have an IBSS master and IBSS slaves. > > > > > > To setup a master then > > > > > > wicontrol -p 1 > > > wicontrol -c 1 > > > wicontrol -n "irulethelink" > > > > > > so non-masters are what then: ?! > > > > Just a note: Those commands are only valid for Lucent/Orinoco firmware. > > The Intersil and Symbol firmware each have their own way. :-) > > > > With Lucent firmware to be a ibss slave, you configure it the same as for > > BSS station mode (to connect to an AP). You can also configure them all > > as ibss masters and all but the first will fall back to slave mode. > > So excuse my ignorance, but how would you set up master or slave on > a linksys wpc11? I read about hostap mode, I even saw someone (Warner I > think it was) is using this same card. But the leds just blink when I > try to set it up with the above type of setup. If the wpc11 use the Intersil firmware, you should do "wicontrol -p 0" and the rest should be the same. (I do not have a card with Intersil firmware yet, but this is what I learned when merging the OpenBSD "mediaopt ibss" stuff.) If it is using Symbol firmware, you need to use "wicontrol -p 4" and it can't be a master so the "-c 1" is useless. John -- John Hay -- John.Hay@icomtek.csir.co.za / jhay@FreeBSD.org To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-mobile" in the body of the message