Date: Mon, 6 Oct 1997 04:42:27 -0700 From: John-Mark Gurney <gurney_j@efn.org> To: FreeBSD Current <freebsd-current@freebsd.org> Subject: current on notebook (as of Oct 3) Message-ID: <19971006044227.01139@hydrogen.nike.efn.org>
next in thread | raw e-mail | index | archive | help
well.. I'm running into some interesting problems... every other reboot
just before it prints the type of pcic chip it does (the PC-Card Intel line):
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0x80000008
fault code = supervisor read, page not present
instruction pointer = 0x8:0xf023dfd0
stack pointer = 0x10:0xf023def8
frame pointer = 0x10:0xf023df48
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 ()
interrupt mask =
trap number = 12
panic: page fault
after the panic, the next boot will complete successfully... this
is actually beyond the end of the kernel... the last bit of nm /kernel
| sort is:
f023119c B _tcpstat
f023128c B _end
ffc00000 A _APTmap
fffff000 A _APTD
next, I would like to know how to get 80x30 on my notebook back..
right now when I try to set the mode, vidcontrol reports:
Cannot set videomode: Device not configured
well... the code that would unwedge the harddrive in 970128 or so
would successfully get my hard drive to resume, and I don't think I
included the sleep-hack to it.. but now my hard drive will not resume
from sleeping unless I turn off multi-block mode... if multi-block mode
isn't even on, the hard drive has no problem resuming...
I will try the new code to resume cards once I update my tree and do a
buildworld... I felt that running a 8-9 month old version of -current
on my notebook was to old, and I might as well test new code...
ok.. a bit about the machine... it's a Toshiba Satellite T1960CS...
I has a base of 4megs w/ a 8meg ram card, one pcmcia slot, 340meg hd,
dual-scan passive, std vga video controller (no SVGA, it's only on the
CT/active matrix version)...
here is the dmesg from a successful boot -v:
Copyright (c) 1992-1997 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 3.0-CURRENT #2: Mon Oct 6 04:23:17 PDT 1997
jmg@hydrogen.nike.efn.org:/a/home/johng/FreeBSD-checkout/current/src/sys/compile/note
Calibrating clock(s) ... i8254 clock: 1193188 Hz
CLK_USE_I8254_CALIBRATION not specified - using default frequency
CPU: i486 DX2 (486-class CPU)
Origin = "GenuineIntel" Id = 0x435 Stepping=5
Features=0x3<FPU,VME>
real memory = 12845056 (12544K bytes)
Physical memory chunk(s):
0x00001000 - 0x0009efff, 647168 bytes (158 pages)
0x0023e000 - 0x00c3dfff, 10485760 bytes (2560 pages)
avail memory = 10735616 (10484K bytes)
Other BIOS signatures found:
ACPI: 00000000
$PnP: 00000000
Probing for devices on the ISA bus:
sc0: the current keyboard controller command byte 0047
kbdio: DIAGNOSE status:0055
kbdio: TEST_KBD_PORT status:0000
kbdio: RESET_KBD return code:00fa
kbdio: RESET_KBD status:00aa
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: BIOS video mode:3
sc0: VGA registers upon power-up
50 18 10 00 10 00 03 00 02 67 5f 4f 50 82 55 81
bf 1f 00 4f 0d 0e 00 00 05 00 9c 8e 8f 28 1f 96
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff
sc0: video mode:24
sc0: VGA color <16 virtual consoles, flags=0x0>
pccard driver sio added
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16450
sio1 not found at 0x2f8
sio2 not found at 0x3e8
sio3 not found at 0x3e8
sio4 not found at 0x3e8
lpt0 at 0x378-0x37f irq 7 on isa
lpt0: Interrupt-driven port
lp0: TCP/IP capable interface
psm0: current command byte:0047
kbdio: TEST_AUX_PORT status:0000
kbdio: RESET_AUX return code:00fe
kbdio: RESET_AUX return code:00fe
kbdio: RESET_AUX return code:00fe
kbdio: DIAGNOSE status:0055
kbdio: TEST_KBD_PORT status:0000
psm0: failed to reset the aux device.
psm0 not found at 0x60
pca0 on isa
pca0: PC speaker audio driver
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <TOSHIBA MK2326FC>
wd0: 324MB (664734 sectors), 969 cyls, 14 heads, 49 S/T, 512 B/S
wd0: ATA INQUIRE valid = 0001, dmamword = 0000, apio = 0000, udma = 0000
pccard driver ep added
ep0 not found at 0x300
npx0 on motherboard
npx0: INT 16 interface
apm0 on isa
apm: found APM BIOS version 1.0
imasks: bio c0084040, tty c0070092, net c0070092
device combination doesn't support shared irq4
intr_connect(irq4) failed, result=-1
device combination doesn't support shared irq7
intr_connect(irq7) failed, result=-1
device combination doesn't support shared irq14
intr_connect(irq14) failed, result=-1
PC-Card Intel 82365 (5 mem & 2 I/O windows)
pcic: controller irq 3
BIOS Geometries:
0:03c70d31 0..967=968 cylinders, 0..13=14 heads, 1..49=49 sectors
0 accounted for
Device configuration finished.
new masks: bio c0084040, tty c0070092, net c0070092
Considering FFS root f/s.
Card inserted, slot 0
wd0s1: type 0xa5, start 340942, end = 664733, size 323792 : OK
wd0s2: type 0x6, start 49, end = 340941, size 340893 : OK
wd0s1: type 0xa5, start 340942, end = 664733, size 323792 : OK
wd0s2: type 0x6, start 49, end = 340941, size 340893 : OK
WARNING: / was not properly dismounted.
Card removed, slot 0
Card inserted, slot 0
ep0: utp/bnc[*UTP*] address 00:20:af:c7:0d:6d
--
John-Mark Gurney Modem/FAX: +1 541 683 6954
Cu Networking
Live in Peace, destroy Micro$oft, support free software, run FreeBSD
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?19971006044227.01139>