Date: Mon, 27 Sep 2004 15:40:09 +0200 From: Hendrik Scholz <hscholz@raisdorf.net> To: freebsd-sparc64@FreeBSD.org Subject: 5.3-BETA 5 and 6 install problem Message-ID: <41581839.8080209@raisdorf.net>
next in thread | raw e-mail | index | archive | help
Hi! I'm trying to install FreeBSD 5.3-BETA6 on a Sun Netra T1. Everything works fine until the installation writes files to the disk: Write failure on transfer! (wrote -1 bytes of 1425408 bytes) There was no error message from newfs but apparently it formatted 18GB in just a few seconds so I guess there's the problem. 5.2.1-REL installs and runs fine. I've tested 5.3-BETA5 and it shows the same error message as 5.3-BETA6 does. Is there a quick way to enable debugging for the install process? Did anybody else encounter this problem? It's been reported in http://docs.freebsd.org/cgi/getmsg.cgi?fetch=0+0+archive/2004/freebsd-sparc64/20040926.freebsd-sparc64 Hendrik dmesg grabbed via tip/typescript: Copyright (c) 1992-2004 The FreeBSD Project.^M^M Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994^M^M The Regents of the University of California. All rights reserved.^M^M FreeBSD 5.3-BETA6 #0: Sun Sep 26 09:57:18 UTC 2004^M^M root@bobbi.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC^M^M Timecounter "tick" frequency 440023625 Hz quality 0^M^M real memory = 536870912 (512 MB)^M^M avail memory = 501342208 (478 MB)^M^M cpu0: Sun Microsystems UltraSparc-IIi Processor (440.02 MHz CPU)^M^M nexus0: <Open Firmware Nexus device>^M^M pcib0: <U2P UPA-PCI bridge> on nexus0^M^M pcib0: Sabre, impl 0, version 0, ign 0x7c0, bus A^M^M pcib0: [FAST]^M^M pcib0: [GIANT-LOCKED]^M^M pcib0: [FAST]^M^M pcib0: [GIANT-LOCKED]^M^M pcib0 dvma: DVMA map: 0xc0000000 to 0xc3ffffff^M^M pci0: <OFW PCI bus> on pcib0^M^M pcib1: <APB PCI-PCI bridge> at device 1.1 on pci0^M^M pci1: <OFW PCI bus> on pcib1^M^M ebus0: <PCI-EBus2 bridge> mem 0xf1000000-0xf17fffff,0xf0000000-0xf0ffffff at device 1.0 on pci1^M^M ebus0: <auxio> addr 0x140072f000-0x140072f003,0x140072c000-0x140072c003,0x140072a000-0x140072a003,0x1400728000-0x1400728003,0x1400726000-0x1400726003 (no driver attached)^M^M ebus0: <power> addr 0x1400724000-0x1400724003 irq 37 (no driver attached)^M^M ebus0: <SUNW,pll> addr 0x1400504000-0x1400504002 (no driver attached)^M^M ebus0: <su> addr 0x14003803f8-0x14003803ff irq 28 (no driver attached)^M^M ebus0: <su> addr 0x14003602f8-0x14003602ff irq 20 (no driver attached)^M^M ebus0: <ecpp> addr 0x1400700000-0x140070000f,0x140030015c-0x140030015d,0x1400340278-0x1400340287 irq 34 (no driver attached)^M^M ebus0: <fdthree> addr 0x1400720000-0x1400720003,0x1400706000-0x140070600f,0x14003203f0-0x14003203f7 irq 39 (no driver attached)^M^M eeprom0: <EEPROM/clock> addr 0x1400000000-0x1400001fff on ebus0^M^M eeprom0: model mk48t59^M^M eeprom0: hostid 80f9ec2a^M^M ebus0: <flashprom> addr 0x1000000000-0x10000fffff (no driver attached)^M^M ebus0: <watchdog> addr 0x1400200000-0x140020003f irq 4 (no driver attached)^M^M ebus0: <display7seg> addr 0x1400200040 (no driver attached)^M^M ebus0: <beeper> addr 0x1400722000-0x1400722003 (no driver attached)^M^M ebus0: <flashprom> addr 0x1000400000-0x10005fffff (no driver attached)^M^M ebus0: <flashprom> addr 0x1000800000-0x10009fffff (no driver attached)^M^M ebus0: <i2c> addr 0x1400600000-0x1400600003 irq 40 (no driver attached)^M^M ebus0: <i2c> addr 0x1400100000-0x1400100003 irq 27 (no driver attached)^M^M ebus0: <SUNW,lom> addr 0x1400400000-0x1400400063 (no driver attached)^M^M hme0: <Sun HME 10/100 Ethernet> mem 0xe0000000-0xe0007fff at device 1.1 on pci1^M^M miibus0: <MII bus> on hme0^M^M ukphy0: <Generic IEEE 802.3u media interface> on miibus0^M^M ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto^M^M ukphy1: <Generic IEEE 802.3u media interface> on miibus0^M^M ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto^M^M hme0: Ethernet address: 08:00:20:f9:ec:2a^M^M hme0: if_start running deferred for Giant^M^M hme0: [GIANT-LOCKED]^M^M sym0: <875> port 0xc00000-0xc000ff mem 0xe000a000-0xe000afff,0xe0008000-0xe00080ff at device 2.0 on pci1^M^M sym0: No NVRAM, ID 7, Fast-20, SE, parity checking^M^M sym0: [GIANT-LOCKED]^M^M hme1: <Sun HME 10/100 Ethernet> mem 0xe0010000-0xe0017fff at device 3.1 on pci1^M^M miibus1: <MII bus> on hme1^M^M ukphy2: <Generic IEEE 802.3u media interface> on miibus1^M^M ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto^M^M hme1: Ethernet address: 08:00:20:f9:ec:2a^M^M hme1: if_start running deferred for Giant^M^M hme1: [GIANT-LOCKED]^M^M pcib2: <APB PCI-PCI bridge> at device 1.0 on pci0^M^M pci2: <OFW PCI bus> on pcib2^M^M pcib3: <OFW PCI-PCI bridge> at device 1.0 on pci2^M^M pci3: <OFW PCI bus> on pcib3^M^M atapci0: <CMD 646 WDMA2 controller> port 0x1020-0x102f,0x1018-0x101b,0x1010-0x1017,0x1008-0x100b,0x1000-0x1007 at device 14.0 on pci3^M^M ata2: channel #0 on atapci0^M^M ata3: channel #1 on atapci0^M^M Timecounters tick every 10.000 msec^M^M md0: Preloaded image </boot/mfsroot> 4194304 bytes at 0xc048ff00^M^M ATAPI_RESET time = 30us^M^M acd0: CDRW <TOSHIBA CD-ROM XM-7002Bc/1107> at ata3-master WDMA2^M^M Waiting 15 seconds for SCSI devices to settle^M^M da0 at sym0 bus 0 target 0 lun 0^M^M da0: <IBM DDYST1835SUN18G S96H> Fixed Direct Access SCSI-3 device ^M^M da0: 40.000MB/s transfers (20.000MHz, offset 16, 16bit), Tagged Queueing Enabled^M^M da0: 17274MB (35378533 512 byte sectors: 255H 63S/T 2202C)^M^M Mounting root from ufs:/dev/md0^M^M /stand/sysinstall running as init on serial console^M -- Hendrik Scholz - <hscholz@raisdorf.net> - http://www.wormulon.net/ drag me, drop me - treat me like an object
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?41581839.8080209>