Skip site navigation (1)Skip section navigation (2)
Date:      Mon, 22 May 1995 21:22:17 -0400 (EDT)
From:      CMU Mail Archive <archive@cps.cmich.edu>
To:        "matthew c. mead" <mmead@Glock.COM>
Cc:        "Rodney W. Grimes" <rgrimes@gndrsh.aac.dev.com>, hackers@FreeBSD.org
Subject:   Re: Diagnostics for a hanging machine?
Message-ID:  <Pine.SUN.3.91.950522212037.2356B-100000@cps201>
In-Reply-To: <199505222027.QAA10490@Glock.COM>

next in thread | previous in thread | raw e-mail | index | archive | help
On Mon, 22 May 1995, matthew c. mead wrote:

> On Mon, May 22, 1995 at 11:23:49 (-0700), Rodney W. Grimes wrote:
> 
>  > I think I spotted your problem in your response to Mycroft, it looked
>  > like you where using the aha driver for the bt card.  Could you please
>  > send me the output of dmesg from booting this box with FreeBSD?  If
>  > infact you are using the aha driver it would explain a *lot* of the
>  > problem.
> 
> 	Well, I spend about an hour with the machine trying to figure out
> how to get it to recognize the controller as bt0.  No go.  How do I get the
> BT742 into NON Adaptec 1542 mode?  I have it at 0x330, irq 12, and the bt0
> device does *not* recognize it.  Once it's probed and fails, it picks it up
> as aha0.  Any ideas?  Thanks for the help!
> 
Take the board to 0x334 and recompile the kernel assuming you can get 
that far. We had a similar problem with ours we ended up putting in an 
adaptec to install on then recompiled the kernel and reinstalled the 
BusLogic.
Hope that helps. 



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.SUN.3.91.950522212037.2356B-100000>