Date: Sun, 24 Feb 2013 22:19:20 -0500 From: Chris Ross <cross+freebsd@distal.com> To: "freebsd-sparc64@freebsd.org" <freebsd-sparc64@freebsd.org> Subject: Problems booting 9.1-STABLE on Netra X1 Message-ID: <CE371F2B-CF62-4695-A9F0-B56995BA3CC6@distal.com>
next in thread | raw e-mail | index | archive | help
So, as discussed in an earlier thread, I am looking to install FreeBSD =
on a Sun Netra X1.
Given that I don't currently have any USB loadable media, or any =
confidence that it will work,
I started working on setting up a netboot. I have it netbooting via a =
loader and kernel via
tftp. However, there seems to be a problem
After getting through some/most of autoconf, it says:
Power Failure Detected: Shutting down NOW.
At which point, it goes silent. The console doesn't respond to input, =
including a break
(which would normally drop back to OBP).
Does anyone have any idea what might be going on here? Some =
miscommunication
about the clock or power management systems in this hardware?
Thanks. Boot output below, and any more details available if needed, =
and specific
guidance to get the details is appreciated. :-)
- Chris
/boot/kernel/kernel data=3D0xb9f5d8+0xc6980 =
syms=3D[0x8+0xc7110+0x8+0xb8713]
jumping to kernel entry at 0xc0098000.
Copyright (c) 1992-2013 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights =
reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 9.1-STABLE #2: Sun Feb 24 00:07:34 EST 2013
cross@build.distal.com:/usr/obj/usr/src/sys/GENERIC sparc64
real memory =3D 671088640 (640 MB)
avail memory =3D 630849536 (601 MB)
cpu0: Sun Microsystems UltraSparc-IIe Processor (500.00 MHz CPU)
kbd0 at kbdmux0
nexus0: <Open Firmware Nexus device>
pcib0: <U2P UPA-PCI bridge> mem =
0x1fe00000000-0x1fe0000ffff,0x1fe01000000-0x1fe010000ff irq =
2032,2030,2031,2021 on nexus0
pcib0: Sabre, impl 0, version 0, IGN 0x1f, bus A, 66MHz
pcib0: DVMA map: 0x60000000 to 0x63ffffff 8192 entries
pcib0: [GIANT-LOCKED]
pci0: <OFW PCI bus> on pcib0
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
pci0: <old, non-VGA display device> at device 3.0 (no driver attached)
dc0: <Davicom DM9102A 10/100BaseTX> port 0x10000-0x100ff mem 0-0xff at =
device 12.0 on pci0
miibus0: <MII bus> on dc0
amphy0: <DM9102 10/100 media interface> PHY 1 on miibus0
amphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
dc0: Ethernet address: 00:03:ba:05:e4:7a
dc1: <Davicom DM9102A 10/100BaseTX> port 0x10100-0x101ff mem =
0x2000-0x20ff at device 5.0 on pci0
miibus1: <MII bus> on dc1
amphy1: <DM9102 10/100 media interface> PHY 1 on miibus1
amphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
dc1: Ethernet address: 00:03:ba:05:e4:7a
ohci0: <AcerLabs M5237 (Aladdin-V) USB controller> mem =
0x1000000-0x1000fff at device 10.0 on pci0
usbus0 on ohci0
atapci0: <AcerLabs M5229 UDMA66 controller> port =
0x10200-0x10207,0x10218-0x1021b,0x10210-0x10217,0x10208-0x1020b,0x10220-0x=
1022f at device 13.0 on pci0
atapci0: using PIO transfers above 137GB as workaround for 48bit DMA =
access bug, expect reduced performance
ata2: <ATA channel> at channel 0 on atapci0
ata3: <ATA channel> at channel 1 on atapci0
nexus0: <syscons> type unknown (no driver attached)
rtc0: <Real-Time Clock> at port 0x70-0x71 on isa0
uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 43 on isa0
uart0: console (9600,n,8,1)
uart1: <16550 or compatible> at port 0x2e8-0x2ef irq 43 on isa0
ctl: CAM Target Layer loaded
Timecounter "tick" frequency 500000000 Hz quality 1000
Event timer "tick" frequency 500000000 Hz quality 1000
Timecounters tick every 1.000 msec
Power Failure Detected: Shutting down NOW.
[halt sent]
[halt sent]
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?CE371F2B-CF62-4695-A9F0-B56995BA3CC6>