Date: Fri, 13 Jul 2001 18:35:13 -0700 (PDT) From: John Doe <rhamming2001@yahoo.com> To: alpha@FreeBSD.ORG Subject: Re: Hmm...another panic Message-ID: <20010714013513.55978.qmail@web14801.mail.yahoo.com> In-Reply-To: <Pine.BSF.4.21.0107131413050.74809-100000@beppo>
next in thread | previous in thread | raw e-mail | index | archive | help
HEHE, what are you talkin gabout matt ;)..i am not running linux :) bruce\ --- Matthew Jacob <mjacob@feral.com> wrote: > > Is that actually a DDB trace? > > How up to date are you? There were a lot of ip6 problems that were fixed over > he last couple of days... > > I see you've been booting linux too, you bad, bad, boy! > > On Fri, 13 Jul 2001, John Doe wrote: > > > Mounting root from ufs:/dev/da0a > > SMP: AP CPU #1 Launched! > > pid 41225 (conftest), uid 0: exited on signal 11 (core dumped) > > pid 41226 (conftest), uid 0: exited on signal 11 (core dumped) > > fxp0: promiscuous mode enabled > > pid 55810 (tcpdump), uid 0: exited on signal 11 (core dumped) > > fxp0: promiscuous mode disabled > > panic: mutex Giant not owned at /usr/src/sys/vm/vm_map.c:2473 > > cpuid = 0; panic > > panic: from debugger > > cpuid = 0; panic > > -- > > > > <sighs> i tried running tcpdump(8) ...and tcpdump core dumped and then the machine panicked > > :)..anyone have this problem ? here is the dmesg > > > > Unrecognized boot flag '0'. > > Copyright (c) 1992-2001 The FreeBSD Project. > > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > > The Regents of the University of California. All rights reserved. > > FreeBSD 5.0-CURRENT #0: Thu Jul 12 14:10:49 GMT 2001 > > root@bcast.bgmulti.com:/usr/obj/usr/src/sys/TEST > > ST6600 > > AlphaPC 264DP 500 MHz, 500MHz > > 8192 byte page size, 2 processors. > > CPU: EV6 (21264) major=8 minor=4 extensions=0x303<BWX,FIX,MVI,PRECISE> > > OSF PAL rev: 0x200290002012d > > real memory = 534233088 (521712K bytes) > > avail memory = 513982464 (501936K bytes) > > smp_start_secondary: can't send START command > > FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs > > Preloaded elf kernel "kernel" at 0xfffffc000078a000. > > tsunami0: <21271 Core Logic chipset> > > pcib0: <21271 PCI host bus adapter> on tsunami0 > > pci0: <PCI bus> on pcib0 > > isab0: <PCI-ISA bridge> at device 5.0 on pci0 > > isa0: <ISA bus> on isab0 > > atapci0: <Cypress 82C693 ATA controller> port 0x10200-0x1020f,0x3f4-0x3f7,0x1f0- > > 0x1f7 irq 238 at device 5.1 on pci0 > > ata0: at 0x1f0 irq 14 on atapci0 > > ata0: interrupting at ISA irq 14 > > ata1: at 0x170 irq 15 on atapci0 > > ata1: interrupting at ISA irq 15 > > atapci1: <Cypress 82C693 ATA controller> port 0x374-0x377,0x170-0x177 irq 239 at > > device 5.2 on pci0 > > atapci1: Busmastering DMA not configured > > pci0: <serial bus, USB> at 5.3 (no driver attached) > > ahc0: <Adaptec aic7895 Ultra SCSI adapter> port 0x10000-0x100ff mem 0x2321000-0x > > 2321fff irq 19 at device 6.0 on pci0 > > aic7895C: Ultra Wide Channel A, SCSI Id=7, 255 SCBs > > ahc0: interrupting at TSUNAMI irq 19 > > ahc1: <Adaptec aic7895 Ultra SCSI adapter> port 0x10100-0x101ff mem 0x2322000-0x > > 2322fff irq 18 at device 6.1 on pci0 > > aic7895C: Ultra Wide Channel B, SCSI Id=7, 255 SCBs > > ahc1: interrupting at TSUNAMI irq 18 > > pcib2: <PCI-PCI bridge> at device 7.0 on pci0 > > pci1: <PCI bus> on pcib2 > > pci1: <display, VGA> at 4.0 (no driver attached) > > fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0x1000-0x101f mem 0x2000000-0x20fff > > ff,0x2230000-0x2230fff irq 30 at device 5.0 on pci1 > > fxp0: interrupting at TSUNAMI irq 30 > > fxp0: Ethernet address 00:06:2b:00:76:2d > > inphy0: <i82555 10/100 media interface> on miibus0 > > inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > > pcib1: <21271 PCI host bus adapter> on tsunami0 > > pci2: <PCI bus> on pcib1 > > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > > atkbd0: <AT Keyboard> irq 1 on atkbdc0 > > atkbd0: interrupting at ISA irq 1 > > atkbd1: <AT Keyboard> irq 1 on atkbdc0 > > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > > fdc0: interrupting at ISA irq 6 > > fdc0: FIFO enabled, 8 bytes threshold > > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > > fd1: <1440-KB 3.5" drive> on fdc0 drive 0 > > mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0 > > ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0 > > ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode > > plip0: cannot reserve interrupt, failed. > > lpt0: <Printer> on ppbus0 > > lpt0: Polled port > > ppi0: <Parallel I/O> on ppbus0 > > ppc0: interrupting at ISA irq 7 > > sc0: <System console> on isa0 > > sc0: VGA <16 virtual consoles, flags=0x200> > > sio0 at port 0x3f8-0x3ff irq 4 on isa0 > > sio0: type 16550A > > sio0: interrupting at ISA irq 4 > > sio1: reserved for low-level i/o > > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > > fdc1: cannot reserve I/O port range (6 ports) > > sio3: reserved for low-level i/o > > ppc1: cannot reserve I/O port range > > Timecounter "i8254" frequency 1193182 Hz > > Waiting 15 seconds for SCSI devices to settle > > pass3 at ahc0 bus 0 target 6 lun 0 > > pass3: <COMPAQ 54-2565x-* 0.01> Fixed Processor SCSI-2 device > > pass3: 3.300MB/s transfers > > da0 at ahc0 bus 0 target 0 lun 0 > > da0: <SEAGATE ST39102LC 7B04> Fixed Direct Access SCSI-2 device > > da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled > > da0: 8678MB (17773524 512 byte sectors: 255H 63S/T 1106C) > > da1 at ahc0 bus 0 target 1 lun 0 > > da1: <SEAGATE ST39102LC 7B04> Fixed Direct Access SCSI-2 device > > da1: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled > > da1: 8678MB (17773524 512 byte sectors: 255H 63S/T 1106C) > > da2 at ahc0 bus 0 target 2 lun 0 > > da2: <COMPAQ BD00911934 3B00> Fixed Direct Access SCSI-2 device > > da2: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled > > da2: 8678MB (17773524 512 byte sectors: 255H 63S/T 1106C) > > Mounting root from ufs:/dev/da0a > > WARNING: / was not properly dismounted > > lock order reversal > > 1st 0xfffffc0000701830 clk @ /usr/src/sys/alpha/alpha/clock.c:702 > > 2nd 0xfffffc00006fa248 callout @ /usr/src/sys/kern/kern_timeout.c:184 > > > > Bruce\ > > > > __________________________________________________ > > Do You Yahoo!? > > Get personalized email addresses from Yahoo! Mail > > http://personal.mail.yahoo.com/ > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > > with "unsubscribe freebsd-alpha" in the body of the message > > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-alpha" in the body of the message __________________________________________________ Do You Yahoo!? Get personalized email addresses from Yahoo! Mail http://personal.mail.yahoo.com/ To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010714013513.55978.qmail>