From owner-freebsd-questions Wed Dec 18 6:48:11 2002 Delivered-To: freebsd-questions@freebsd.org Received: from mx1.FreeBSD.org (mx1.freebsd.org [216.136.204.125]) by hub.freebsd.org (Postfix) with ESMTP id ADF7337B401 for ; Wed, 18 Dec 2002 06:48:09 -0800 (PST) Received: from vms4.rit.edu (vms4.isc.rit.edu [129.21.3.15]) by mx1.FreeBSD.org (Postfix) with ESMTP id B1AFC43EDE for ; Wed, 18 Dec 2002 06:48:08 -0800 (PST) (envelope-from bjm1287@ritvax.isc.rit.edu) Received: from dogbert ([129.21.129.47]) by ritvax.isc.rit.edu (PMDF V5.2-32 #40294) with ESMTPA id <01KQ68OEX8IURJKG33@ritvax.isc.rit.edu> for freebsd-questions@FreeBSD.ORG; Wed, 18 Dec 2002 09:46:07 EST Date: Wed, 18 Dec 2002 09:45:20 -0500 From: Brian McCann Subject: RE: My Cisco Problem In-reply-to: <20021218093905.S281-100000@gemini.fixx.co.za> To: 'Wayne Swart' Cc: freebsd-questions@FreeBSD.ORG Message-id: <002401c2a6a4$17825520$1500a8c0@dogbert> MIME-version: 1.0 X-MIMEOLE: Produced By Microsoft MimeOLE V6.00.2800.1106 X-Mailer: Microsoft Outlook, Build 10.0.2616 Content-type: text/plain; charset=us-ascii Content-transfer-encoding: 7BIT Importance: Normal X-Priority: 3 (Normal) X-MSMail-priority: Normal Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.ORG I set up several of these every few months (I teach at a college where we teach students to configure serial lines on 2500s). The most common problems I see are encapsulation mismatch, no clockrate set or set wrong, and I've even seen line protocol down when there is no IP configured...but I think that was a PEBKAC problem. Chances are your line is fine, and you have to take this up with your ISP. I'd email them or read them your config for that interface and have them confirm that it's right, and have them double check theirs. Hope I Helped, --Brian -----Original Message----- From: owner-freebsd-questions@FreeBSD.ORG [mailto:owner-freebsd-questions@FreeBSD.ORG] On Behalf Of Wayne Swart Sent: Wednesday, December 18, 2002 2:41 AM To: FreeBSD Mailing list Subject: My Cisco Problem Lo, tis me again :) I not placed the NTU (terminating unit) on my side in loopback mode. Now i get: Serial1/7 is up, line protocol is down (looped) Do i take it the problem is on my router then hey? thnks wayne To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message