From owner-freebsd-questions Thu May 25 4:39:36 2000 Delivered-To: freebsd-questions@freebsd.org Received: from styx.astrom.net (astrom.net [193.15.98.30]) by hub.freebsd.org (Postfix) with ESMTP id 6E86C37BE14 for ; Thu, 25 May 2000 04:39:17 -0700 (PDT) (envelope-from patrik@astrom.net) Received: from localhost (astrom@localhost) by styx.astrom.net (8.9.3/8.9.3) with ESMTP id NAA34926 for ; Thu, 25 May 2000 13:39:10 +0200 (CEST) Date: Thu, 25 May 2000 13:39:10 +0200 (CEST) From: Patrik Astrom X-Sender: astrom@styx.astrom.net To: freebsd-questions@freebsd.org Subject: Unable to install on Compaq ProLiant 1850 w. Array 221 card. Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG Hi! Im trying to install FreeBSD 4.0-Release (From Walnutcreek cdrom) on a Compaq ProLiant 1850 with a Compaq SmartArray 221 RAID controller. My problem is that when FreeBSD boots from the cd and I have done the Visual config and begin to boot the system the system crashes and says: sym0: <875> at devuce 6.0 on pcib0 sym0: failed to allocate MMIO resources Fatal trap 12: Page fault while in kernel mode. fault virtual adress = 0x0 fault code = supervisor read, page not present. instruction pointer = 0x8:0xc0229eed stack pointer = 0x10:0xc05fbce8 frame pointer = 0x10:0xc05fbcf8 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enables, resume, IOPL = 0 current proccess = 0 (swapper) interrupt mask = net tty bio cam trap numer = 12 panic: page fault Uptime: 0s This is on a Compaq ProLiant 1850R with 2x500 Mhz PII with 512 MB of ram, the Array is configured using the SmartStart CD and is configured with 3x9,1 Gb Ultra2 disk. Using 2 for a mirror and the last as "Hot standby". I have done this before using FBSD 3.4 but needed to make a custom bootdisk, under FBSD 4.0 it seems like "ida" array with disks are found without this. I have also tried to make a custom install disk without the sym0 driver and when I did that I was able to install FBSD 4.0 without problems, but when Im trying to boot the new system the bootloader says: Unable to load kernel: Aborted! / can't load 'kernel' Do I need to do something special to be able to boot from the Array ?, on 3.4 you needed to fool the bootloader to think that the IDA array was a IDE drive, must I do this on 4.0 too ?, and if so how do I do this ?. I was unable to find any info off this in /sys/i386/conf/LINT. Regards Patrik Astrom, Stockholm To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message