From owner-freebsd-current Fri Sep 18 10:19:39 1998 Return-Path: Received: (from majordom@localhost) by hub.freebsd.org (8.8.8/8.8.8) id KAA23820 for freebsd-current-outgoing; Fri, 18 Sep 1998 10:19:39 -0700 (PDT) (envelope-from owner-freebsd-current@FreeBSD.ORG) Received: from atlrel1.hp.com (atlrel1.hp.com [156.153.255.210]) by hub.freebsd.org (8.8.8/8.8.8) with ESMTP id KAA23804 for ; Fri, 18 Sep 1998 10:19:36 -0700 (PDT) (envelope-from michaelc@hpbbse.bbn.hp.com) Received: from hpbbse.bbn.hp.com (hpbbse.bbn.hp.com [15.136.26.26]) by atlrel1.hp.com (8.8.6/8.8.5tis) with ESMTP id NAA06349 for ; Fri, 18 Sep 1998 13:18:35 -0400 (EDT) Received: from localhost (michaelc@localhost) by hpbbse.bbn.hp.com with SMTP (8.7.6/8.7.3) id TAA20741 for ; Fri, 18 Sep 1998 19:19:04 +0200 (METDST) Date: Fri, 18 Sep 1998 19:19:04 +0200 (METDST) From: Michael Class To: current@FreeBSD.ORG Subject: ncr and CAM still dont work for me Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Content-Transfer-Encoding: 8bit X-MIME-Autoconverted: from QUOTED-PRINTABLE to 8bit by hub.freebsd.org id KAA23812 Sender: owner-freebsd-current@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG Hello, I am still unable to get my system up and running with cam. Even with ncr.c rev. 1.129 the system hangs with probe0(ncr0:0:0:0) extaneous data discarded probe0(ncr0:0:0:0) COMMAND FAILED (9 0) @f086f600 ncr0: timeout nccb = f086XXXX (skip) (lots of these lines follow) and after a couple of minutes: da0:ncr0:0:0:0 READ CAPACITY CDB: 25 0 0 0 0 0 0 0 0 0 da0:ncr0:0:0:0 error code 51 and that's it. (I have the messages written on paper, so there might be some typos) The system is a P6, 200Mhz, 64MB Ram and a 810 and 875 SCSI-Controller. But even if I removed the 810 and all devices but the Micropolis Disk, I am getting the same error. Enclosed is the relevant output of a boot from a pre-cam kernel. Any suggestions? Michael ------------------------------------------------------------------------- michael class, viktor-renner str. 39, 72074 tuebingen, frg E-Mail: michael_class@hp.com Phone: +49 7031 14-3707 (work) +49 7071 81950 (private) ------------------------------------------------------------------------- ncr0: rev 0x03 int a irq 12 on pci0.11.0 ncr0: minsync=12, maxsync=137, maxoffs=16, 128 dwords burst, large dma fifo ncr0: single-ended, open drain IRQ driver, using on-chip SRAM ncr0: restart (scsi reset). ncr0 scanning for targets 0..6 and 8..15 (V2 pl24 96/12/14) ncr0: waiting for scsi devices to settle scbus0 at ncr0 bus 0 sd0 at scbus0 target 0 lun 0 sd0: type 0 fixed SCSI 2 sd0: Direct-Access sd0: NCR quirks=0x2 sd0: WIDE SCSI (16 bit) enabled sd0: 40.0 MB/s (50 ns, offset 15) sd0: M_DISCONNECT received, but datapointer not saved: data=35e590 save=f88006b0 goal=f88006d4. 8681MB (17780058 512 byte sectors) sd0: with 4811 cyls, 22 heads, and an average 167 sectors/track sd1 at scbus0 target 1 lun 0 sd1: type 0 fixed SCSI 2 sd1: Direct-Access sd1: NCR quirks=0x2 sd1: WIDE SCSI (16 bit) enabled sd1: 20.0 MB/s (100 ns, offset 15) 4101MB (8399520 512 byte sectors) sd1: with 3907 cyls, 20 heads, and an average 107 sectors/track st0 at scbus0 target 3 lun 0 st0: type 1 removable SCSI 2 st0: Sequential-Access st0: NCR quirks=0x2 st0: 10.0 MB/s (100 ns, offset 16) density code 0x24, drive empty found-> vendor=0x1000, dev=0x0001, revid=0x01 class=00-00-00, hdrtype=0x00, mfdev=0 intpin=a, irq=11 map[0]: type 4, range 32, base 0000d400, size 8 map[1]: type 1, range 32, base f8000000, size 8 ncr1: rev 0x01 int a irq 11 on pci0.12.0 ncr1: minsync=25, maxsync=206, maxoffs=8, 16 dwords burst, normal dma fifo ncr1: single-ended, open drain IRQ driver ncr1: restart (scsi reset). ncr1 scanning for targets 0..6 (V2 pl24 96/12/14) ncr1: waiting for scsi devices to settle scbus1 at ncr1 bus 0 worm0 at scbus1 target 3 lun 0 worm0: type 5 removable SCSI 2 worm0: Write-Once uk0 at scbus1 target 4 lun 0 uk0: type 6 fixed SCSI 2 uk0: Unknown scbus1 target 4 lun 1: NCR quirks=0x2 uk1 at scbus1 target 4 lun 1 uk1: type 6 fixed SCSI 2 uk1: Unknown uk2 at scbus1 target 4 lun 2 uk2: type 6 fixed SCSI 2 uk2: Unknown uk3 at scbus1 target 4 lun 3 uk3: type 6 fixed SCSI 2 uk3: Unknown uk4 at scbus1 target 4 lun 4 uk4: type 6 fixed SCSI 2 uk4: Unknown uk5 at scbus1 target 4 lun 5 uk5: type 6 fixed SCSI 2 uk5: Unknown uk6 at scbus1 target 4 lun 6 uk6: type 6 fixed SCSI 2 uk6: Unknown uk7 at scbus1 target 4 lun 7 uk7: type 6 fixed SCSI 2 uk7: Unknown cd0 at scbus1 target 5 lun 0 cd0: type 5 removable SCSI 2 cd0: CD-ROM cd0: NCR quirks=0x2 cd0: 4.0 MB/s (250 ns, offset 8) cd present [296150 x 2048 byte records] ___________________________________________________________________________ Michael Class E-Mail: michael_class@hp.com E-Business Solutions Center Phone: +49 7031 14-3707 EBSO-SERC Fax: +49 7031 14-4196 ___________________________________________________________________________ Hewlett-Packard GmbH, PO Box 1430, 71004 Boeblingen Sitz der Gesellschaft: Böblingen, Amtsgericht Böblingen HRB 4081 Geschäftsführer: Jörg Menno Harms (Vorsitzender), Heribert Schmitz, Rudi Speier, Fritz Schuller, Hans-Günter Hohmann ___________________________________________________________________________ To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message