Date: Mon, 9 Feb 2004 14:59:56 +1100 From: Peter Jeremy <peter.jeremy@alcatel.com.au> To: freebsd-stable@freebsd.org Subject: HP DL380 lockup using 4.9-RELEASE-p1 Message-ID: <20040209035956.GA97435@gsmx07.alcatel.com.au>
next in thread | raw e-mail | index | archive | help
I have an HP DL380 that has taken to locking up hard (no messages and
no response to keyboard, mouse or network) since I installed 4.9p1.
Previously it had 4.8p7 and had been running for a couple of months
without problem (though without anyone using it either). There's
nothing obvious going on to trigger the lockup - last time it locked
up after about an hour but it had previously run for several days.
I'm running the same software (except for CPUTYPE differences) on a
couple of HP P1850R's without problem.
Does any of this ring a bell with anyone? I have a couple of straws
to grasp but if someone else has seen this behaviour (and knows the
cause), I'd be interested in the details.
The only non-standard driver is a back-port of digi(4) from -current.
I did have some problems in 4.8p7 with IRQ clashes but after giving
the DigiBoard a non-shared IRQ that went away.
Unfortunately, the system is about 3000km away from me and the only
remote access is via a modem attached to it. This makes debugging
very painful.
I don't have a current dmesg at present but an old dmesg is below.
The difference is the OS version, USB has been disabled in the BIOS
and the DigiBoard has been moved from irq15 to irq7 (via the BIOS).
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.8-RELEASE-p7 #6: Fri Sep 19 14:14:55 EST 2003
root@aalp03.alcatel.com.au:/mnt/obj/mnt/rpc/src/sys/rpc
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 2388773052 Hz
CPU: Intel(R) Xeon(TM) CPU 2.40GHz (2388.77-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0xf29 Stepping = 9
Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
Hyperthreading: 2 logical CPUs
real memory = 536846336 (524264K bytes)
avail memory = 519188480 (507020K bytes)
Preloaded elf kernel "kernel" at 0xc031f000.
VESA: v2.0, 8128k memory, flags:0x0, mode table:0xc02c4c22 (1000022)
VESA: ATI MACH64
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pci0: <ATI Mach64-GR graphics accelerator> at 3.0
pci0: <unknown card> (vendor=0x0e11, dev=0xb203) at 4.0 irq 3
pci0: <unknown card> (vendor=0x0e11, dev=0xb204) at 4.2 irq 5
isab0: <PCI to ISA bridge (vendor=1166 device=0201)> at device 15.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <ServerWorks CSB5 ATA100 controller> port 0x2000-0x200f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 15.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <OHCI USB controller> at 15.2 irq 7
pcib1: <Host to PCI bridge> on motherboard
pci1: <PCI bus> on pcib1
ciss0: <Compaq Smart Array 5i> port 0x3000-0x30ff mem 0xf75f0000-0xf75f3fff,0xf76c0000-0xf76fffff irq 10 at device 3.0 on pci1
ciss0: using 256 of 1024 available commands
ciss0: 1 logical drive configured
ciss0: firmware 2.36
ciss0: 2 SCSI channels
ciss0: signature 'CISS'
ciss0: valence 1
ciss0: supported I/O methods 0xe<simple,performant,MEMQ>
ciss0: active I/O method 0x3<simple>
ciss0: 4G page base 0x00000000
ciss0: interrupt coalesce delay 1000us
ciss0: interrupt coalesce count 16
ciss0: max outstanding commands 1024
ciss0: bus types 0x2<ultra3>
ciss0: server name ''
ciss0: heartbeat 0x3000003b
ciss0: 1 logical drive
ciss0: logical drive 1: RAID 0, 69120MB online
pcib2: <Host to PCI bridge> on motherboard
pci2: <PCI bus> on pcib2
bge0: <Broadcom BCM5703X Gigabit Ethernet, ASIC rev. 0x1002> mem 0xf77f0000-0xf77fffff irq 11 at device 1.0 on pci2
bge0: Ethernet address: 00:0b:cd:d3:51:51
miibus0: <MII bus> on bge0
brgphy0: <BCM5703 10/100/1000baseTX PHY> on miibus0
brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 1000baseTX-FDX, auto
bge1: <Broadcom BCM5703X Gigabit Ethernet, ASIC rev. 0x1002> mem 0xf77e0000-0xf77effff irq 15 at device 2.0 on pci2
bge1: Ethernet address: 00:0b:cd:d3:51:50
miibus1: <MII bus> on bge1
brgphy1: <BCM5703 10/100/1000baseTX PHY> on miibus1
brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 1000baseTX-FDX, auto
pcib3: <Host to PCI bridge> on motherboard
pci3: <PCI bus> on pcib3
pci3: <unknown card> (vendor=0x114f, dev=0x0004) at 1.0 irq 15
pcib4: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
pci4: <PCI bus> on pcib4
pcib6: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
pci6: <PCI bus> on pcib6
pci6: <unknown card> (vendor=0x0e11, dev=0xa0f7) at 30.0 irq 11
pcib5: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
pci5: <PCI bus> on pcib5
pcib7: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
pci7: <PCI bus> on pcib7
orm0: <Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xcbfff,0xee000-0xeffff on isa0
sc0: <System console> on isa0
sc0: VGA <12 virtual consoles, flags=0x200>
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A
ciss0: *** Cache enabled
DUMMYNET initialized (011031)
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to deny, logging limited to 100 packets/entry by default
ata0-slave: ATA identify retries exceeded
acd0: CDROM <COMPAQ CD-ROM SN-124> at ata0-master PIO4
Mounting root from ufs:/dev/da0s4a
da0 at ciss0 bus 0 target 0 lun 0
da0: <COMPAQ RAID 0 VOLUME OK> Fixed Direct Access SCSI-0 device
da0: 135.168MB/s transfers
da0: 69459MB (142253280 512 byte sectors: 255H 32S/T 17433C)
--
Peter Jeremy
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040209035956.GA97435>