From owner-freebsd-bugs Fri Oct 27 22:10:04 1995 Return-Path: owner-bugs Received: (from root@localhost) by freefall.freebsd.org (8.6.12/8.6.6) id WAA13404 for bugs-outgoing; Fri, 27 Oct 1995 22:10:04 -0700 Received: (from gnats@localhost) by freefall.freebsd.org (8.6.12/8.6.6) id WAA13391 ; Fri, 27 Oct 1995 22:10:02 -0700 Resent-Date: Fri, 27 Oct 1995 22:10:02 -0700 Resent-Message-Id: <199510280510.WAA13391@freefall.freebsd.org> Resent-From: gnats (GNATS Management) Resent-To: freebsd-bugs Resent-Reply-To: FreeBSD-gnats@freefall.FreeBSD.org, uhclem@fw.ast.com Received: from ast.com (irvine.ast.com [165.164.128.2]) by freefall.freebsd.org (8.6.12/8.6.6) with SMTP id WAA13252 for ; Fri, 27 Oct 1995 22:07:41 -0700 Received: from fw.ast.com by ast.com with SMTP id AA03099 (5.67b/IDA-1.5 for ); Fri, 27 Oct 1995 22:08:50 -0700 Received: from nemesis by fw.ast.com with uucp (Smail3.1.29.1 #4) id m0t93PY-000083C; Sat, 28 Oct 95 00:02 CDT Received: by nemesis.lonestar.org (Smail3.1.27.1 #19) id m0t93Kr-000IvJC; Fri, 27 Oct 95 23:57 WET DST Message-Id: Date: Fri, 27 Oct 95 23:57 WET DST From: uhclem%nemesis@fw.ast.com Reply-To: uhclem@fw.ast.com To: FreeBSD-gnats-submit@freebsd.org X-Send-Pr-Version: 3.2 Subject: bin/797: X probeonly during install gets Not Found error FDIV037 Sender: owner-bugs@freebsd.org Precedence: bulk >Number: 797 >Category: bin >Synopsis: X probeonly during install gets Not Found error FDIV037 >Confidential: no >Severity: non-critical >Priority: high >Responsible: freebsd-bugs >State: open >Class: sw-bug >Submitter-Id: current-users >Arrival-Date: Fri Oct 27 22:10:01 PDT 1995 >Last-Modified: >Originator: Frank Durda IV >Organization: >Release: FreeBSD 2.1.0-951026-SNAP >Environment: 1026 system freshly installed and still running from boot floppy (not yet rebooted.) >Description: After a successful installation, if you have installed X and elect to configure X, at one point it asks if you would like to set up a Symlink X to start X. I answered "yes". A few dozen questions later when configuring my video board, I was offered the chance to test the clock settings by doing a probeonly. When this was attempted, I get a "X: Command not found.", so the probeonly is not performed. It appears the symlink is not yet in place or is not in the right place for where the X configuration is looking. >How-To-Repeat: See above. >Fix: >Audit-Trail: >Unformatted: