Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 31 Oct 2007 18:18:06 +0100
From:      "Moretti Filippo" <gunnut@2ainfo.it>
To:        Florent Thoumie <flz@xbsd.org>
Cc:        freebsd-x11@freebsd.org
Subject:   Re: Problem with xorg in PRERELEASE 7
Message-ID:  <20071031171806.4431.qmail@mail1.2ainfo.it>
In-Reply-To: <1193761576.69136.3.camel@mayday.esat.net>
References:  <20071029133914.16976.qmail@mail1.2ainfo.it> <1193761576.69136.3.camel@mayday.esat.net>

next in thread | previous in thread | raw e-mail | index | archive | help
Florent Thoumie scrive: 

> On Mon, 2007-10-29 at 14:39 +0100, Moretti Filippo wrote:
> 		
>> I cannot find a port to install fbdevhw any help really appreciated.
>> Sincerely 
> 
> Just remove the "Load fbdevhw" line from your xorg.conf file. You may
> want to start with a newly generated one (Xorg -configure). 
> 
I did not have load fbdevhw it must be in the default.
I run Xorg -configure and with the newly generated file
I get the following error 

X.Org X Server 1.4.0
Release Date: 5 September 2007
X Protocol Version 11, Revision 0
Build Operating System: FreeBSD 7.0-PRERELEASE i386
Current Operating System: FreeBSD sting.2ainfo.it 7.0-PRERELEASE FreeBSD 
7.0-PRE
RELEASE #1: Sat Oct 20 05:31:38 CEST 2007     
root@sting.2ainfo.it:/usr/obj/usr/
src/sys/STING i386
Build Date: 30 October 2007  08:51:49PM 

       Before reporting problems, check http://wiki.x.org
	        to make sure that you have the latest version.
		Module Loader present
		Markers: (--) probed, (**) from config file, (==) default setting,
		        (++) from command line, (!!) notice, (II) informational,
			        (WW) warning, (EE) error, (NI) not implemented, (??) unknown.
				(==) Log file: "/var/log/Xorg.0.log", Time: Wed Oct 31 18:10:09 2007
				(++) Using config file: "/root/xorg.conf.new"
				(II) Module "ramdac" already built-in
				
				Fatal server error:
				Caught signal 11.  Server aborting
				
				Segmentation fault: 11 (core dumped)
				X
There is no module ramdac in the xorg.conf.new
I did by the way rebuild all program from ports.
Sincerely
Filippo 

> -- 
> Florent Thoumie
> flz@FreeBSD.org
> FreeBSD Committer 
> 
 



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20071031171806.4431.qmail>