Date: Wed, 20 Feb 2002 13:33:30 -0800 (PST) From: Vinod <geekvinod@yahoo.com> To: freebsd_mail@yahoo.com Cc: freebsd-mobile@freebsd.org Subject: Re: reassigning irq's Message-ID: <20020220213330.87550.qmail@web21104.mail.yahoo.com> In-Reply-To: <200202201324120465.00EDFDED@smtp.mail.yahoo.com>
next in thread | previous in thread | raw e-mail | index | archive | help
actually my pccard is a pci card inserted into a pci slot(i dont have any isa slots).so what best can be done in the present circumstances? --- Greg Smith <freebsd_mail@yahoo.com> wrote: > Vinod, > > OK. I don't know if this qualifies as "an irq > conflict". Your pccard > is being attached as a PCI device, so it is getting > the same PCI > interrupt as your PCI sound card and your PCI PCIC: > > >pcm0: <AudioPCI ES1371-A> port 0xfc40-0xfc7f irq 10 > at > > >pcic0: <TI PCI-1410 PCI-CardBus Bridge> irq 10 at > > >wi0: <WaveLAN/IEEE 802.11> at port 0x240-0x27f irq > 10 > > Windows normally works just find under the same > circumstances. If the > wi driver in FreeBSD is unable to work this way you > might switch to ISA > for your pccards and then you could put it on > whatever free IRQ you > wish. > > Greg > > -----Original Message----- > > >actually i had actually made this change but wasnt > >sure what i was doing so had asked.no this doesnt > seem > >to reassign my wi irq.both now use irq "10". > > > >here is the change i had made in /etc/pccard.conf > >----------------------------------------------------- > >Lucent WaveLAN/IEEE > >card "Lucent Technologies" "WaveLAN/IEEE" > > config 0x1 "wi" 5 > ># config auto "wi" ? > > insert /etc/pccard_ether $device start > > remove /etc/pccard_ether $device stop > >------------------------------------------------------ > > > >here's the dmesg too > >------------------------------------------------------- > >Features=0x80f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,C > MOV,MMX> > >real memory = 67108864 (65536K bytes) > >avail memory = 60432384 (59016K bytes) > >Preloaded elf kernel "kernel" at 0xc04cd000. > >Pentium Pro MTRR support enabled > >md0: Malloc disk > >Using $PIR table, 7 entries at 0xc00fdf50 > >npx0: <math processor> on motherboard > >npx0: INT 16 interface > >pcib0: <Intel 82443LX (440 LX) host to PCI bridge> > on > >motherboard > >pci0: <PCI bus> on pcib0 > >pcib1: <Intel 82443LX (440 LX) PCI-PCI (AGP) > bridge> > >at device 1.0 on > >pci0 > >pci1: <PCI bus> on pcib1 > >isab0: <Intel 82371AB PCI to ISA bridge> at device > 7.0 > >on pci0 > >isa0: <ISA bus> on isab0 > >atapci0: <Intel PIIX4 ATA33 controller> port > >0xfcd0-0xfcdf at device > >7.1 on pci0 > >ata0: at 0x1f0 irq 14 on atapci0 > >ata1: at 0x170 irq 15 on atapci0 > >uhci0: <Intel 82371AB/EB (PIIX4) USB controller> > port > >0xfce0-0xfcff irq > >9 at device 7.2 on pci0 > >usb0: <Intel 82371AB/EB (PIIX4) USB controller> on > >uhci0 > >usb0: USB revision 1.0 > >uhub0: Intel UHCI root hub, class 9/0, rev > 1.00/1.00, > >addr 1 > >uhub0: 2 ports with 2 removable, self powered > >chip1: <Intel 82371AB Power management controller> > >port 0x7000-0x700f > >at device 7.3 on pci0 > >pci0: <ATI Mach64-GU graphics accelerator> at 13.0 > >tx0: <SMC EtherPower II 10/100> port 0xf400-0xf4ff > mem > > > >0xfedfe000-0xfedfefff irq 11 at device 14.0 on pci0 > >miibus0: <MII bus> on tx0 > >qsphy0: <QS6612 10/100 media interface> on miibus0 > >qsphy0: 10baseT, 10baseT-FDX, 100baseTX, > >100baseTX-FDX, auto > >tx0: address 00:e0:29:11:6d:85, type SMC9432TX > >pcm0: <AudioPCI ES1371-A> port 0xfc40-0xfc7f irq 10 > at > >device 15.0 on > >pci0 > >pci_cfgintr_search: linked (63) to configured irq > 10 > >at 0:15:0 > >pci_cfgintr: 0:16 INTA routed to irq 10 > >pcic0: <TI PCI-1410 PCI-CardBus Bridge> irq 10 at > >device 16.0 on pci0 > >pcic0: PCI Memory allocated: 0x44000000 > >pcic0: TI12XX PCI Config Reg: [pwr save][CSC > parallel > >isa irq] > >pccard0: <PC Card bus (classic)> on pcic0 > >orm0: <Option ROMs> at iomem > >0xc0000-0xc7fff,0xe8000-0xeffff on isa0 > >fdc0: <NEC 72065B or clone> at port > 0x3f0-0x3f5,0x3f7 > >irq 6 drq 2 on > >isa0 > >fdc0: FIFO enabled, 8 bytes threshold > >fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > >atkbdc0: <Keyboard controller (i8042)> at port > >0x60,0x64 on isa0 > >atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 > >kbd0 at atkbd0 > >psm0: <PS/2 Mouse> irq 12 on atkbdc0 > >psm0: model IntelliMouse, device ID 3 > >vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem > >0xa0000-0xbffff on > >isa0 > >sc0: <System console> at flags 0x100 on isa0 > >sc0: VGA <16 virtual consoles, flags=0x300> > >sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > >sio0: type 16550A > >sio1 at port 0x2f8-0x2ff irq 3 on isa0 > >sio1: type 16550A > >ppc0: <Parallel port> at port 0x378-0x37f irq 7 on > >isa0 > >ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE > mode > >plip0: <PLIP network interface> on ppbus0 > >lpt0: <Printer> on ppbus0 > >lpt0: Interrupt-driven port > >ppi0: <Parallel I/O> on ppbus0 > >ad0: 4112MB <WDC AC24300L> [8912/15/63] at > ata0-master > >UDMA33 > >acd0: CDROM <TOSHIBA CD-ROM XM-6102B> at > ata1-master > >using PIO3 > >Mounting root from ufs:/dev/ad0s2a > >pccard: card inserted, slot 0 > >wi0: <WaveLAN/IEEE 802.11> at port 0x240-0x27f irq > 10 > >slot 0 on pccard0 > >wi0: Ethernet address: 00:02:2d:3c:66:c2 > >------------------------------------------------------ > > > > > > > > > > > >--- John Utz <john@utzweb.net> wrote: > >> edit your /etc/pccard.conf to remove the irq that > >> your soundcard is using > >> from the list of available irq's > >> > >> On Wed, 20 Feb 2002, Vinod wrote: > >> > >> > i had an earlier posting about wi0 watchdog > >> timeout(on > >> > doing ifconfig).i have an irq conflict between > my > >> > sound card and my wi0(orinoco on frbsd 4.4).i > am > >> new > >> > to freebsd and dont know much about finding > which > >> > irq's are free how can i reassign a free irq to > my > >> > wi0.Can anyone help me with some advice? > >> > Vinod > >> > > >> > > __________________________________________________ > >> > Do You Yahoo!? > >> > Yahoo! Sports - Coverage of the 2002 Olympic > Games > >> > http://sports.yahoo.com > >> > > >> > To Unsubscribe: send mail to > majordomo@FreeBSD.org > >> > with "unsubscribe freebsd-mobile" in the body > of > >> the message > >> > > >> > >> -- > >> > >> John L. Utz III > >> john@utzweb.net > >> > === message truncated === __________________________________________________ Do You Yahoo!? Yahoo! Sports - Coverage of the 2002 Olympic Games http://sports.yahoo.com To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020220213330.87550.qmail>