Date: Wed, 09 May 2018 00:41:55 +0100 From: Justin Clift <justin@postgresql.org> To: Grzegorz Junka <list1@gjunka.com> Cc: freebsd-infiniband@freebsd.org, freebsd-net@freebsd.org, owner-freebsd-infiniband@freebsd.org Subject: Re: Unrecognized Inifiniband HCA Message-ID: <7218e2c4b23ebf4553a352633fe49e72@postgresql.org> In-Reply-To: <169976f0-2159-9ef0-d956-b13e717ef783@gjunka.com> References: <169976f0-2159-9ef0-d956-b13e717ef783@gjunka.com>
next in thread | previous in thread | raw e-mail | index | archive | help
On 2018-05-08 21:59, Grzegorz Junka wrote: > Hi All, > > pciconf -lv > > gives me > > none1@pci0:3:0:0: class=0x0c0600 card=0x000315b3 chip=0x634015b3 > rev=0xa0 hdr=0x00 > vendor = 'Mellanox Technologies' > device = 'MT25408 [ConnectX VPI - IB SDR / 10GigE]' > class = serial bus > > Does it mean that my card is unrecognized? It supposed to be 10GB x 2 > Infiniband PCI-E HCA 500EX-D Dual-Port Card Mellanox Firmware. > Currently the card doesn't show when doing ifconfig. What should I do > to have the proper device name instead of none1 or for the card to > appear in ifconfig? > > # kldstat > Id Refs Address Size Name > 1 28 0xffffffff80200000 1f67a88 kernel > 2 1 0xffffffff82169000 316708 zfs.ko > 3 2 0xffffffff82480000 cb78 opensolaris.ko > 4 1 0xffffffff8248d000 42c28 mps.ko > 5 1 0xffffffff82621000 bdb0 if_lagg.ko > 6 1 0xffffffff8262d000 3650 ums.ko > 7 1 0xffffffff82631000 6679 nullfs.ko > 8 1 0xffffffff82638000 bdfe unionfs.ko > 9 2 0xffffffff82644000 2094f mlx5.ko > 10 2 0xffffffff82665000 103e1 linuxkpi.ko > 11 1 0xffffffff82676000 15965 mlx5en.ko That's probably a ConnectX (series 1) Mellanox card. Those can operate in either Infiniband mode, or Ethernet mode. Which mode are you wanting it to run in? :) As a thought, the FreeBSD wiki page has a bit of info: https://wiki.freebsd.org/InfiniBand For that card to be recognised at all, it'll need the mlx4 driver(s) to load. I don't remember the exact one off hand (it's been a while), but some searching online for mlx4 and FreeBSD should turn up the right bits. Hope that helps. :) Regards and best wishes, Justin Clift
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?7218e2c4b23ebf4553a352633fe49e72>