From owner-freebsd-sparc Sat Mar 30 19: 9: 2 2002 Delivered-To: freebsd-sparc@freebsd.org Received: from beppo.feral.com (beppo.feral.com [192.67.166.79]) by hub.freebsd.org (Postfix) with ESMTP id 1FF4A37B400 for ; Sat, 30 Mar 2002 19:08:53 -0800 (PST) Received: from mailhost.feral.com (mjacob@mailhost.feral.com [192.67.166.1]) by beppo.feral.com (8.11.3/8.11.3) with ESMTP id g2V38cf49946; Sat, 30 Mar 2002 19:08:42 -0800 (PST) (envelope-from mjacob@feral.com) Date: Sat, 30 Mar 2002 19:08:38 -0800 (PST) From: Matthew Jacob X-Sender: mjacob@beppo Reply-To: mjacob@feral.com To: Thomas Moestl Cc: freebsd-sparc@freebsd.org Subject: much, much better..... thanks! In-Reply-To: Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-sparc@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org { I haven't seen any changes show up via cvsup, but by having a stripped down kernel, I was able to boot && run.. ][ Much, much, better.... I had to do some fairly massive cleanup of my bus_dma usage, but that was because I'd been lazy before hand... I'll see if I can't do the same for an SBus version sometime this upcoming week. This stuff will get checked into the main CVS repository for -current after a couple days of alpha && i386 testing- probably midweek. Lemme know if you want patches before then. ... Copyright (c) 1992-2002 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.0-CURRENT #13: Sat Mar 30 18:51:31 PST 2002 mjacob@slinx:/usr/src/sys/sparc64/compile/SLINX Preloaded elf kernel "/boot/kernel/kernel" at 0x80310000. Timecounter "tick" frequency 300000000 Hz cpu0: Sun Microsystems UltraSparc-IIi Processor (300.00 MHZ CPU) nexus0: pcib0: on nexus0 pcib0: SUNW,sabre: impl 0, version 0: ign 7c0 bus range 0 to 2; PCI bus 0 DVMA map: 0xc0000000 to 0xdfffffff ... isp0: port 0x800-0x8ff mem 0x4000-0x4fff irq 20 at device 2.0 on pci1 isp0: Board Type 2200, Chip Revision 0x5, loaded F/W Revision 2.1.36 isp0: Firmware Attributes = 0x17 isp0: 985 max I/O commands supported isp0: NVRAM Port WWN 0x200100a080002301 isp0: NVRAM Node WWN 0x200000a080002301 isp0: NVRAM: maxfrmlen 1024 execthrottle 16 fwoptions 0x0 isp0: Setting ICB Node 0x200000a080002301 Port 0x200100a080002301 isp0: isp_fibre_init: fwoptions 0x100 ... isp0: LIP freeze simq isp0: LIP Received isp0: Loop UP isp0: Port Database Changed isp0: kthread checking FC state isp0: Firmware State Ready> isp0: Loop ID 0, AL_PA 0xef, Port ID 0xef, Loop State 0x2, Topology 'Private Loop' isp0: Target 0 (Loop 0x0) Port ID 0xef (role Initiator) Arrived Port WWN 0x200100a080002301 Node WWN 0x200000a080002301 isp0: Target 32 (Loop 0x20) Port ID 0xb2 (role Target) Arrived Port WWN 0x2100002037113f14 Node WWN 0x2000002037113f14 isp0: Target 33 (Loop 0x21) Port ID 0xb1 (role Target) Arrived Port WWN 0x21000020371140c0 Node WWN 0x20000020371140c0 isp0: Target 34 (Loop 0x22) Port ID 0xae (role Target) Arrived Port WWN 0x2100002037113fa3 Node WWN 0x2000002037113fa3 isp0: Target 35 (Loop 0x23) Port ID 0xad (role Target) Arrived Port WWN 0x2100002037113ec3 Node WWN 0x2000002037113ec3 isp0: Target 38 (Loop 0x26) Port ID 0xaa (role Target) Arrived Port WWN 0x21000020370828db Node WWN 0x20000020370828db isp0: Target 45 (Loop 0x2d) Port ID 0x9e (role Target) Arrived Port WWN 0x5080020000029501 Node WWN 0x5080020000029500 isp0: kthread up release simq ad0: 2014MB [4092/16/63] at ata2-master WDMA2 ad1: 3020MB [6136/16/63] at ata2-slave WDMA2 acd0: CDROM at ata3-master PIO4 isp0: (0.32.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0 isp0: (0.33.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0 isp0: (0.34.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0 isp0: (0.35.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0 isp0: (0.38.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0 pass5 at isp0 bus 0 target 45 lun 0 pass5: Fixed Enclosure Services SCSI-3 device pass5: 100.000MB/s transfers da0 at isp0 bus 0 target 32 lun 0 da0: Fixed Direct Access SCSI-2 device da0: 100.000MB/s transfers, Tagged Queueing Enabled da0: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C) da1 at isp0 bus 0 target 33 lun 0 da1: Fixed Direct Access SCSI-2 device da1: 100.000MB/s transfers, Tagged Queueing Enabled da1: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C) da2 at isp0 bus 0 target 34 lun 0 da2: Fixed Direct Access SCSI-2 device da2: 100.000MB/s transfers, Tagged Queueing Enabled da2: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C) da3 at isp0 bus 0 target 35 lun 0 da3: Fixed Direct Access SCSI-2 device da3: 100.000MB/s transfers, Tagged Queueing Enabled da3: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C) da4 at isp0 bus 0 target 38 lun 0 da4: Fixed Direct Access SCSI-2 device da4: 100.000MB/s transfers, Tagged Queueing Enabled da4: 8625MB (17664229 512 byte sectors: 255H 63S/T 1099C) -matt To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-sparc" in the body of the message