Date: Sat, 30 Mar 2002 19:08:38 -0800 (PST) From: Matthew Jacob <mjacob@feral.com> To: Thomas Moestl <tmoestl@gmx.net> Cc: freebsd-sparc@freebsd.org Subject: much, much better..... thanks! Message-ID: <Pine.BSF.4.21.0203301902110.47530-100000@beppo> In-Reply-To: <Pine.BSF.4.21.0203291435210.43015-100000@beppo>
next in thread | previous in thread | raw e-mail | index | archive | help
{ I haven't seen any changes show up via cvsup, but by having a stripped
down kernel, I was able to boot && run.. ][
Much, much, better.... I had to do some fairly massive cleanup of my bus_dma
usage, but that was because I'd been lazy before hand... I'll see if I can't
do the same for an SBus version sometime this upcoming week.
This stuff will get checked into the main CVS repository for -current after a
couple days of alpha && i386 testing- probably midweek. Lemme know if you want
patches before then.
...
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #13: Sat Mar 30 18:51:31 PST 2002
mjacob@slinx:/usr/src/sys/sparc64/compile/SLINX
Preloaded elf kernel "/boot/kernel/kernel" at 0x80310000.
Timecounter "tick" frequency 300000000 Hz
cpu0: Sun Microsystems UltraSparc-IIi Processor (300.00 MHZ CPU)
nexus0: <OpenFirmware Nexus device>
pcib0: <U2P UPA-PCI bridge> on nexus0
pcib0: SUNW,sabre: impl 0, version 0: ign 7c0 bus range 0 to 2; PCI bus 0
DVMA map: 0xc0000000 to 0xdfffffff
...
isp0: <Qlogic ISP 2200 PCI FC-AL Adapter> port 0x800-0x8ff mem 0x4000-0x4fff irq
20 at device 2.0 on pci1
isp0: Board Type 2200, Chip Revision 0x5, loaded F/W Revision 2.1.36
isp0: Firmware Attributes = 0x17
isp0: 985 max I/O commands supported
isp0: NVRAM Port WWN 0x200100a080002301
isp0: NVRAM Node WWN 0x200000a080002301
isp0: NVRAM: maxfrmlen 1024 execthrottle 16 fwoptions 0x0
isp0: Setting ICB Node 0x200000a080002301 Port 0x200100a080002301
isp0: isp_fibre_init: fwoptions 0x100
...
isp0: LIP freeze simq
isp0: LIP Received
isp0: Loop UP
isp0: Port Database Changed
isp0: kthread checking FC state
isp0: Firmware State <Config Wait->Ready>
isp0: Loop ID 0, AL_PA 0xef, Port ID 0xef, Loop State 0x2, Topology 'Private
Loop'
isp0: Target 0 (Loop 0x0) Port ID 0xef (role Initiator) Arrived
Port WWN 0x200100a080002301
Node WWN 0x200000a080002301
isp0: Target 32 (Loop 0x20) Port ID 0xb2 (role Target) Arrived
Port WWN 0x2100002037113f14
Node WWN 0x2000002037113f14
isp0: Target 33 (Loop 0x21) Port ID 0xb1 (role Target) Arrived
Port WWN 0x21000020371140c0
Node WWN 0x20000020371140c0
isp0: Target 34 (Loop 0x22) Port ID 0xae (role Target) Arrived
Port WWN 0x2100002037113fa3
Node WWN 0x2000002037113fa3
isp0: Target 35 (Loop 0x23) Port ID 0xad (role Target) Arrived
Port WWN 0x2100002037113ec3
Node WWN 0x2000002037113ec3
isp0: Target 38 (Loop 0x26) Port ID 0xaa (role Target) Arrived
Port WWN 0x21000020370828db
Node WWN 0x20000020370828db
isp0: Target 45 (Loop 0x2d) Port ID 0x9e (role Target) Arrived
Port WWN 0x5080020000029501
Node WWN 0x5080020000029500
isp0: kthread up release simq
ad0: 2014MB <ST32122A> [4092/16/63] at ata2-master WDMA2
ad1: 3020MB <WDC AC33100H> [6136/16/63] at ata2-slave WDMA2
acd0: CDROM <CRD-8240B> at ata3-master PIO4
isp0: (0.32.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0
isp0: (0.33.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0
isp0: (0.34.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0
isp0: (0.35.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0
isp0: (0.38.0): FIN dl20 resid 20 STS 0x2 SKEY 6 XS_ERR=0x0
pass5 at isp0 bus 0 target 45 lun 0
pass5: <SUN SENA 1.07> Fixed Enclosure Services SCSI-3 device
pass5: 100.000MB/s transfers
da0 at isp0 bus 0 target 32 lun 0
da0: <SEAGATE ST118273FC 6208> Fixed Direct Access SCSI-2 device
da0: 100.000MB/s transfers, Tagged Queueing Enabled
da0: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da1 at isp0 bus 0 target 33 lun 0
da1: <SEAGATE ST118273FC 6208> Fixed Direct Access SCSI-2 device
da1: 100.000MB/s transfers, Tagged Queueing Enabled
da1: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da2 at isp0 bus 0 target 34 lun 0
da2: <SEAGATE ST118273FC 6208> Fixed Direct Access SCSI-2 device
da2: 100.000MB/s transfers, Tagged Queueing Enabled
da2: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da3 at isp0 bus 0 target 35 lun 0
da3: <SEAGATE ST118273FC 6208> Fixed Direct Access SCSI-2 device
da3: 100.000MB/s transfers, Tagged Queueing Enabled
da3: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da4 at isp0 bus 0 target 38 lun 0
da4: <SEAGATE ST39102F CLAR09 SG0C> Fixed Direct Access SCSI-2 device
da4: 100.000MB/s transfers, Tagged Queueing Enabled
da4: 8625MB (17664229 512 byte sectors: 255H 63S/T 1099C)
-matt
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-sparc" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.21.0203301902110.47530-100000>