Date: Thu, 28 Jun 2001 00:30:38 +0200 From: Sebastiaan van Erk <sebster@sebster.com> To: rodolfo edelmann <rodolfo_edelmann@hotmail.com> Cc: freebsd-questions@freebsd.org Subject: Re: ? Message-ID: <20010628003038.A4711@sebster.com> In-Reply-To: <OE25PPzhBmhwaGlemhx000022a9@hotmail.com>; from rodolfo_edelmann@hotmail.com on Wed, Jun 27, 2001 at 06:43:18PM -0300 References: <OE25PPzhBmhwaGlemhx000022a9@hotmail.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi there, It's been on the list quite a lot. Check the archives. Other than that, check your cables and make sure you have IDE cables with 80 little wires instead of 40. Also make sure the cables aren't too long or damaged. In the worst case run in lower ATA modes or in PIO mode. Greetings, Sebastiaan van Erk > Script started on Wed Jun 27 16:41:01 2001 > > Lixa# uname -a > FreeBSD Lixa.infovia.com.ar 4.3-RELEASE FreeBSD 4.3-RELEASE #0: Sat Apr 21 10:54:49 GMT 2001 jkh@narf.osd.bsdi.com:/usr/src/sys/compile/GENERIC i386 > Lixa# > > Script done on Wed Jun 27 16:45:58 2001 > > ---------------------------------------------------------------------------------------------------------------------------------------------------- > > ---THIS IS THE PROBLEM I HAVE, FREEBSD SAY EVERYTIME THAT WHEN I WRITE IN MY HARD DISK---- > > > Lixa# ad0s2f: UDMA ICRC error writing fsbn 57387386 of 4136752-4136783 > (ad0s2 bn 57387386; cn 3572 tn 50 sn 56) retrying > ad0s2f: UDMA ICRC error writing fsbn 66958778 of 8922448-8922703 (ad0s2 bn 66958778; cn 4167 tn 252 sn 47) retrying > ad0s2f: UDMA ICRC error writing fsbn 54003066 of 2444592-2444847 (ad0s2 bn 54003066; cn 3361 tn 136 sn 33) retrying > Jun 27 16:48:31 Lixa /kernel: ad0s2f: UDMA ICRC error writing fsbn 57387386 of 4136752-4136783 (ad0s2 bn 57387386; cn 3572 tn 50 sn 56) retrying > Jun 27 16:48:31 Lixa /kernel: ad0s2f: UDMA ICRC error writing fsbn 57387386 of 4136752-4136783 (ad0s2 bn 57387386; cn 3572 tn 50 sn 56) retrying > Jun 27 16:48:31 Lixa /kernel: ad0s2f: UDMA ICRC error writing fsbn 66958778 of 8922448-8922703 (ad0s2 bn 66958778; cn 4167 tn 252 sn 47) retrying > Jun 27 16:48:31 Lixa /kernel: ad0s2f: UDMA ICRC error writing fsbn 66958778 of 8922448-8922703 (ad0s2 bn 66958778; cn 4167 tn 252 sn 47) retrying > > --------------------------------------------------------------------------------------------------------------------------------------------------- > > ---I CHECK IT BUT EVERITHING GO OK---- > > Script started on Wed Jun 27 16:55:27 2001 > Lixa# fsck > ** /dev/ad0s2a (NO WRITE) > ** Last Mounted on / > ** Root file system > ** Phase 1 - Check Blocks and Sizes > ** Phase 2 - Check Pathnames > ** Phase 3 - Check Connectivity > ** Phase 4 - Check Reference Counts > ** Phase 5 - Check Cyl groups > 1095 files, 29072 used, 169327 free (599 frags, 21091 blocks, 0.3% fragmentation) > ** /dev/ad0s2f (NO WRITE) > ** Last Mounted on /usr > ** Phase 1 - Check Blocks and Sizes > ** Phase 2 - Check Pathnames > ** Phase 3 - Check Connectivity > ** Phase 4 - Check Reference Counts > ** Phase 5 - Check Cyl groups > 98706 files, 739133 used, 4544991 free (43447 frags, 562693 blocks, 0.8% fragmentation) > ** /dev/ad0s2e (NO WRITE) > ** Last Mounted on /var > ** Phase 1 - Check Blocks and Sizes > ** Phase 2 - Check Pathnames > ** Phase 3 - Check Connectivity > ** Phase 4 - Check Reference Counts > ** Phase 5 - Check Cyl groups > 171 files, 926 used, 98257 free (9 frags, 12281 blocks, 0.0% fragmentation) > Lixa# exit > > Script done on Wed Jun 27 16:56:34 2001 > > -------------------------------------------------------------------------------------------------------------------------------------------------- > > ---THIS IS THE KERNEL START UP--- > > Script started on Wed Jun 27 16:49:23 2001 > > Lixa# dmesg > Copyright (c) 1992-2001 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD 4.3-RELEASE #0: Sat Apr 21 10:54:49 GMT 2001 > jkh@narf.osd.bsdi.com:/usr/src/sys/compile/GENERIC > Timecounter "i8254" frequency 1193182 Hz > CPU: AMD Athlon(tm) Processor (698.65-MHz 686-class CPU) > Origin = "AuthenticAMD" Id = 0x621 Stepping = 1 > Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR> > AMD Features=0xc0400000<AMIE,DSP,3DNow!> > real memory = 134152192 (131008K bytes) > config> di sn0 > config> di lnc0 > config> di ie0 > config> di fe0 > config> di ed0 > config> di cs0 > config> di bt0 > config> di aic0 > config> di aha0 > config> di adv0 > config> en npx0 > config> po npx0 0xf0 > config> ir npx0 13 > config> f npx0 0 > config> q > avail memory = 126226432 (123268K bytes) > Preloaded elf kernel "kernel" at 0xc044d000. > Preloaded userconfig_script "/boot/kernel.conf" at 0xc044d09c. > Pentium Pro MTRR support enabled > md0: Malloc disk > npx0: <math processor> on motherboard > npx0: INT 16 interface > pcib0: <AMD-751 host to PCI bridge> on motherboard > pci0: <PCI bus> on pcib0 > pcib1: <AMD-751 PCI-PCI (AGP) bridge> at device 1.0 on pci0 > pci1: <PCI bus> on pcib1 > pci1: <NVidia model 0110 graphics accelerator> at 5.0 irq 11 > isab0: <VIA 82C686 PCI-ISA bridge> at device 7.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <VIA 82C686 ATA66 controller> port 0xffa0-0xffaf at device 7.1 on pci0 > ata0: at 0x1f0 irq 14 on atapci0 > ata1: at 0x170 irq 15 on atapci0 > uhci0: <VIA 83C572 USB controller> port 0xd400-0xd41f irq 10 at device 7.2 on pci0 > usb0: <VIA 83C572 USB controller> on uhci0 > usb0: USB revision 1.0 > uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > chip1: <VIA 82C686 ACPI interface> at device 7.4 on pci0 > pci0: <unknown card> (vendor=0x1102, dev=0x0002) at 9.0 irq 11 > pci0: <unknown card> (vendor=0x1102, dev=0x7002) at 9.1 > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > fdc0: FIFO enabled, 8 bytes threshold > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 > kbd0 at atkbd0 > psm0: <PS/2 Mouse> irq 12 on atkbdc0 > psm0: model NetMouse/NetScroll Optical, device ID 0 > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > sc0: <System console> at flags 0x100 on isa0 > sc0: VGA <16 virtual consoles, flags=0x300> > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > sio0: type 16550A > sio1: configured irq 3 not in bitmap of probed irqs 0 > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 > ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode > ppbus0: IEEE1284 device found /NIBBLE > Probing for PnP devices on ppbus0: > ppbus0: <Canon BJC-4400/1.01> PRINTER BJ,LQ,BJL,BJRaster,BSCC > plip0: <PLIP network interface> on ppbus0 > lpt0: <Printer> on ppbus0 > lpt0: Interrupt-driven port > ppi0: <Parallel I/O> on ppbus0 > ad0: 29312MB <Maxtor 33073H3> [59556/16/63] at ata0-master UDMA66 <--------------------------MY HARD DISK > acd0: DVD-ROM <Pioneer DVD-ROM ATAPIModel DVD-105S 0122> at ata1-master using PIO4 > Mounting root from ufs:/dev/ad0s2a > > Script done on Wed Jun 27 16:49:43 2001 > > ----------------------------------------------------------------------------------------------------- > > PLEASE ANSWER ME, I HAVE THIS PROBLEM FOR LAST 1 YEAR AND I NEVER GET AN ANSWER > > MY E-MAIL IS : > rodolfo_edelmann@hotmail.com > > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010628003038.A4711>