From owner-freebsd-alpha Fri Apr 5 16:55:20 2002 Delivered-To: freebsd-alpha@freebsd.org Received: from skywalker.systec.no (skywalker.systec.no [80.64.196.212]) by hub.freebsd.org (Postfix) with ESMTP id 3441537B404 for ; Fri, 5 Apr 2002 16:55:15 -0800 (PST) Received: from skywalker.systec.no (skywalker.systec.no [192.168.100.3]) by relay.systec.no (8.11.6/8.11.6) with ESMTP id g35EZjZ39547; Fri, 5 Apr 2002 16:35:47 +0200 (CEST) (envelope-from oystein.andreassen@systec.no) Received: by skywalker.systec.no with Internet Mail Service (5.5.2653.19) id ; Fri, 5 Apr 2002 16:29:25 +0200 Message-ID: From: =?iso-8859-1?Q?=D8ystein_Andreassen?= To: "'Roberto de Iriarte'" Cc: "FreeBSD Alpha (E-mail)" Subject: RE: Problem with MyLex KZPAC PCI RAID controller Date: Fri, 5 Apr 2002 16:29:24 +0200 MIME-Version: 1.0 X-Mailer: Internet Mail Service (5.5.2653.19) Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable Sender: owner-freebsd-alpha@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org Hello! I'll try to tell you a little about the config, but if I leave = something out you have to ask (I'm new sorta to alpha:). The console version is v6.0-4 dated 10-MAY-2001 The controller's FW version is now 2.73 (updated this after I recived = you mail. Still the same problem though). From a 'show config' command i can read this about the controller: Name/type: MyLex DAC960 Slot:4 Type:14069 Rev:0002 I can also tell you the following: It is a KZPAC (DEC/Compaq's name for = the controller I think) / DAC960PU (MyLex' name for it) with 8 MB RAM. It = has 7x18,2 disks attached, 4x on ch0 and 3x on ch2. The RAID is configured = with the 2 first disks on ch0 in RAID1, the two next are hotspare and the = three disks on ch2 is a RAID5 with 32768MB configured. Controller options: Automatic Rebuild Management: Disabled Storageworks Fault Management: Disabled Rebuild Rate: 50 Controller Read Ahead: Disabled Stripe Size: 64K All 3 buses: -- Scsi Transfer Rate: 20MHz Command tagging: Enabled Scsi data bus width: 16Bit -- Disk spinup: Automatic Spin devices: 1 (Spin device) Delay: 6 In DOS the BIOS is version 1.41 dated 15 May 96 I have tried to update the firmware to 3.x but the controller only has = a 128K EEPROM. (I even tried to put another 128K from another controller = in the spare slot... Didn't work! :) Hmm...I think thats all... =D8ystein To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-alpha" in the body of the message