Date: Wed, 20 May 1998 19:46:32 -0700 From: robert t tan <rotan@cs.pdx.edu> To: freebsd-questions@FreeBSD.ORG Subject: Adaptec 2940 controller Message-ID: <199805210246.TAA21446@sirius.cs.pdx.edu>
next in thread | raw e-mail | index | archive | help
When I am trying to install FreeBSD I am getting the following messages: Probing for devices on PCI bus 0, chip0 <Intel 82437FX PCI cache memory controller> rev2 on pci0:0 chip1 <Intel 82371FB PCI-ISA bridge> rev2 on pci0:7:0 chip2 <Intel 82371FB IDE interface> rev2 on pci0:7:1 ahc0: <Adaptec 2940 Ultra SCSI host adapter> rev1 int a irq 11 on pci0:17 ahc0: aic7880 Wide channel, SCSI Id = 7, 16 SCBs ahc0: waiting for SCSI devices to settle ahc0: board is not responding (ahc0:0:0): SCB 0x0 - timed out while idle, LASTPHASE == 0x1, SCSISIOI == 0x0 SEQADDR = 0x162 SCSISEQ = 0x12 SSTAT0 = 0x4 SSTAT1 = 0x8 (ahc0:0:0) Queueing an Abort SCB ahc0 board is not responding cmd failed (ahc0:0:0): SCB 0x1 timed out while recovery in progress cmd failed (ahc0:0:0): "unknown ????" type 13 fixed SCSI 0 uk0(ahc0:0:0):Unknowm ... .. I've set up my IRQ's fine: IRQ 5 for cdrom, and IRQ 0 for hard drive. Drive is on the Wide cable on the controller, and the cdrom on the regular SCSI cable. Terminator is set ON on cdrom. I am able to run DOS fine, as long as I don't try to install the drivers needed for the cdrom. I talked some hours to techs support that supported the controler, but couldn't come up with any help so far. Any ideas would be appreciated. tnx. robert tan. To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199805210246.TAA21446>