Date: Wed, 15 Aug 2001 08:21:19 -0700 (PDT) From: "K. Greenwood" <k_greenwood1@yahoo.com> To: ringgo@rnpa-online.net, questions@freebsd.org Subject: Re: 3COM509B-UTP Message-ID: <20010815152119.10696.qmail@web14107.mail.yahoo.com> In-Reply-To: <20010813063044.24509.cpmta@c000.snv.cp.net>
next in thread | previous in thread | raw e-mail | index | archive | help
--- ringgo@rnpa-online.net wrote: > ep0: <3Com 3C509-TPO EtherLink III> at port > 0x300-0x30f irq 10 on isa0 > ep0: No irq?! > ep0: ep_alloc() failed! (6) > device_probe_and_attach: ep0 attach returned 6 > > Somebody can help for the right configuration for > 3COM509B-UTP for FresBsd 4.2 release kernel > configuration? > Because I always got up there when my box booting Since no one else has tried a response, I may as well... but take what I say with a grain of salt. First off, run the diagnostics that the card came with (specifically 3c5x9cfg.exe through dos). Allow it to configure (automatically set the resources) and run the test. Power down and bring BSD back up... If it still does not work go back into the diagnostic program and change the plug and play from one to the other. Cycle the power and see what bsd says. If it still doesn't work try manually selecting your resources. If, after all this, it still fails, did you know that breaking a circuit board is (if done correctly and under supervision) very stress relieving? K. Greenwood __________________________________________________ Do You Yahoo!? Make international calls for as low as $.04/minute with Yahoo! Messenger http://phonecard.yahoo.com/ To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010815152119.10696.qmail>