From owner-freebsd-smp Sat Jun 24 5:48:48 2000 Delivered-To: freebsd-smp@freebsd.org Received: from paperboy.sixforty.co.uk (paperboy.sixforty.co.uk [195.10.242.11]) by hub.freebsd.org (Postfix) with ESMTP id 58B1A37B6B1 for ; Sat, 24 Jun 2000 05:48:30 -0700 (PDT) (envelope-from lawrence@epcdirect.co.uk) Received: from mail.shorewood-epc.co.uk (mail.shorewood-epc.co.uk [195.10.240.17]) by paperboy.sixforty.co.uk (8.9.3/8.9.3) with ESMTP id NAA31287 for ; Sat, 24 Jun 2000 13:48:07 +0100 (BST) (envelope-from lawrence@epcdirect.co.uk) Received: from lfarr (host-191.shorewood-epc.co.uk [192.168.15.191]) by mail.shorewood-epc.co.uk (8.9.3/8.9.3) with SMTP id NAA49280 for ; Sat, 24 Jun 2000 13:48:01 +0100 (BST) (envelope-from lawrence@epcdirect.co.uk) Reply-To: From: "Lawrence Farr" To: Subject: Revisited: HP Vectra XU Date: Sat, 24 Jun 2000 13:47:52 +0100 Message-ID: MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit X-Priority: 3 (Normal) X-MSMail-Priority: Normal X-Mailer: Microsoft Outlook IMO, Build 9.0.2416 (9.0.2910.0) X-MimeOLE: Produced By Microsoft MimeOLE V5.00.2919.6600 Importance: Normal Sender: owner-freebsd-smp@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org I posted this originally on the 7th June, and since then have had a bit of a play around with it. Upgrading to 4-STABLE a few days after this did not work, same error, but booting the same machine on the 4-CURRENT SMP kernel, it worked fine. Going back to 4-RELEASE again, I realised the machine was on Plug and Play. Turned it off, built a SMP kernel, and it was fine. Took it up to stable again, made world, made kernel, same result as below. I am assuming there is no hardware problem as it works OK on older code. Does anyone have any suggestions/patches I can try? -----Original Message----- From: Lawrence Farr [mailto:l.farr@epcdirect.co.uk] Sent: 07 June 2000 18:58 To: freebsd-smp@freebsd.org Subject: HP Vectra XU I have a HP Vectra XU, Dual PPro 200, 256Mb RAM, Internal Adaptec, that ran quite happily on a 4.0-CURRENT from mid January if I remember rightly. Upgraded to STABLE and it died on boot. Boots single processor OK, dual it wont. Blanked it, and put 4.0-RELEASE on there, same again. Single OK, Dual I get: (snip) avail memory = 257159168 (251132K bytes) Programming 16 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 Then stops. Any ideas anyone? Lawrence Farr EPC Direct Limited mailto:l.farr@epcdirect.co.uk T:01179666123 F:01179666111 M:07970780901 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-smp" in the body of the message