From owner-freebsd-questions@FreeBSD.ORG Fri Jun 13 07:36:54 2003 Return-Path: Delivered-To: freebsd-questions@freebsd.org Received: from mx1.FreeBSD.org (mx1.freebsd.org [216.136.204.125]) by hub.freebsd.org (Postfix) with ESMTP id 6D39337B401 for ; Fri, 13 Jun 2003 07:36:54 -0700 (PDT) Received: from smtp016.mail.yahoo.com (smtp016.mail.yahoo.com [216.136.174.113]) by mx1.FreeBSD.org (Postfix) with SMTP id E0D0943FDD for ; Fri, 13 Jun 2003 07:36:53 -0700 (PDT) (envelope-from rohitvis@rogers.com) Received: from cpe0002a5b30bb5-cm0000396edc60.cpe.net.cable.rogers.com (HELO raptor) (rohitvis@63.138.113.68 with plain) by smtp.mail.vip.sc5.yahoo.com with SMTP; 13 Jun 2003 14:36:53 -0000 From: Rohit To: Bill Moran Date: Fri, 13 Jun 2003 10:35:51 +0000 User-Agent: KMail/1.5 References: <200306131011.47302.rohitvis@rogers.com> <3EE9DCDB.20607@potentialtech.com> In-Reply-To: <3EE9DCDB.20607@potentialtech.com> MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Content-Disposition: inline Message-Id: <200306131035.51185.rohitvis@rogers.com> cc: questions@freebsd.org Subject: Re: Booting takes too long. Why? (/ was not properly dismounted) X-BeenThere: freebsd-questions@freebsd.org X-Mailman-Version: 2.1.1 Precedence: list List-Id: User questions List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , X-List-Received-Date: Fri, 13 Jun 2003 14:36:54 -0000 Here is the dmesg. However, I should tell you that this has been the case with all my FreeBSD boxes. I have two PC's running FreeBSD and a Compaq laptop running FreeBSd all have different types of harddrives. The main problem is that everytime I boot I get the message saying / was not dismounted properly and then it goes through and fixes all the drive block errors. (This is the case on all my computers) I shutdown using the shutdown -h now command or reboot using reboot now Rohit ---------------------------------------------------------------------------- opyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.8-RELEASE #8: Wed May 21 13:22:57 GMT 2003 ro@raptor.man.mn.charter.com:/usr/src/sys/compile/ROHIT_MAY11_2003 Timecounter "i8254" frequency 1193182 Hz CPU: Mobile AMD Athlon(tm) XP 1500+ (1325.14-MHz 686-class CPU) Origin = "AuthenticAMD" Id = 0x680 Stepping = 0 Features=0x383f9ff AMD Features=0xc0480000 real memory = 251658240 (245760K bytes) avail memory = 240287744 (234656K bytes) Preloaded elf kernel "kernel" at 0xc0465000. module_register_init: MOD_LOAD (vesa, c0310844, 0) error 6 netsmb_dev: loaded Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 11 entries at 0xc00fdf10 apm0: on motherboard apm0: found APM BIOS v1.2, connected at v1.2 npx0: on motherboard npx0: INT 16 interface pcib0: on motherboard pci0: on pcib0 pcib1: at device 1.0 on pci0 pci1: on pcib1 pci1: at 5.0 irq 10 ohci0: mem 0xf4014000-0xf4014fff irq 11 at device 2.0 on pci0 usb0: OHCI version 1.0, legacy support usb0: SMM does not respond, resetting usb0: on ohci0 usb0: USB revision 1.0 uhub0: AcerLabs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered isab0: at device 7.0 on pci0 isa0: on isab0 pcm0: port 0x8400-0x84ff mem 0xf4015000-0xf4015fff irq 5 at device 8.0 on pci0 pcm0: (id=0x41445363) pci_cfgintr_virgin: using routable interrupt 10 pci_cfgintr: ROUTE_INTERRUPT failed. pcic0: mem 0xffbfe000-0xffbfefff at device 10.0 on pci0 pci_cfgintr_virgin: using routable interrupt 10 pci_cfgintr: ROUTE_INTERRUPT failed. pcic0: No PCI interrupt routed, trying ISA. pcic0: Polling mode pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC serial isa irq] pccard0: on pcic0 rl0: port 0x8800-0x88ff mem 0xf4017800-0xf40178ff irq 11 at device 11.0 on pci0 ********************ROHIT**********************rl0: Ethernet address: 00:08:02:f3:d2:03 ********************ROHIT**********************miibus0: on rl0 rlphy0: on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pci0: (vendor=0x14f1, dev=0x2f00) at 12.0 irq 10 ohci1: mem 0xf4016000-0xf4016fff irq 11 at device 15.0 on pci0 usb1: OHCI version 1.0, legacy support usb1: on ohci1 usb1: USB revision 1.0 uhub1: AcerLabs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 4 ports with 4 removable, self powered atapci0: port 0x8080-0x808f irq 0 at device 16.0 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 alpm0: at device 17.0 on pci0 alpm0: driver is using old-style compatibility shims fwohci0: mem 0xf4010000-0xf4013fff,0xf4017000-0xf40177ff irq 10 at device 19.0 on pci0 fwohci0: PCI bus latency is 64. fwohci0: OHCI version 1.10 (ROM=1) fwohci0: No. of Isochronous channel is 4. fwohci0: EUI64 00:08:02:71:9b:f3:cb:d2 fwohci0: Phy 1394a available S400, 2 ports. fwohci0: Link S400, max_rec 2048 bytes. firewire0: on fwohci0 fwohci0: Initiate bus reset fwohci0: BUS reset fwohci0: node_id = 0xc000ffc0, CYCLEMASTER mode firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me) smbus0: on alsmb0 smb0: on smbus0 orm0: