Date: Fri, 26 May 2000 18:36:47 +0200 From: =?iso-8859-1?Q?Arve_R=F8nning?= <arve.ronning@thomson-csf.no> To: <shup@netzmarkt.de> Cc: <freebsd-isdn@FreeBSD.ORG> Subject: Re: i4b - nothing works Message-ID: <001501bfc72f$a80edd40$98dc049b@thomsoncsf.no> References: <20000525223036.A47048@sirius.hq.netzmarkt.de>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi Sven ! The following is pure speculation, may be I shouldn't stick my neck out on this, but since noone else has... It seems that interrupts from the Fritz!Card do not reach the driver. - are you sure it is configured for irq 5 ? - mybe the kernel config should read : device isic0 at isa? port 0x300 net irq 5 flags 4 (note the added "net") That's it, good luck ! -Arve ----- Original Message ----- From: <shup@netzmarkt.de> To: <freebsd-isdn@FreeBSD.ORG> Sent: Thursday, May 25, 2000 10:31 PM Subject: i4b - nothing works > hi there, > > i have got a prob with isdn4bsd. > > i tried to set it up on my freebsd 4.0 stable machine. > os is a snapshot from 04/24/2000. > > seems to recognize the Fritz!Card Classic on boot, but i can not use it anyway. > > i thought there should be any output if i ran isdntrace and call the isdn line, where the card is attached, but there is nothing (see below). > > you can see all debuging output i got so far below. the content of /var/log/messages was created by a run of isdntest -i my_number -o my_number. > > please help me, i need it urgent > > at the moment by only way to connect is winnt where the card works without probs. > > thanks a lot > sven > > ############################## > dmesg output: > > isic0 at port 0x1b00-0x1b1f,0x16e0-0x16ff,0x6e0-0x6ff,0xee0-0xeff,0x1300-0x131f,0x300-0x31 f,0xb00-0xb1f irq 5 flags 0x4 on isa0 > isic0: AVM A1 or Fritz!Card Classic > i4b: ISDN call control device attached > i4bisppp: 4 ISDN SyncPPP device(s) attached > i4bctl: ISDN system control port attached > i4bipr: 4 IP over raw HDLC ISDN device(s) attached (VJ header compression) > i4btel: 2 ISDN telephony interface device(s) attached > i4brbch: 4 raw B channel access device(s) attached > i4btrc: 4 ISDN trace device(s) attached > > ############################## > kernel config: > > # AVM A1 or AVM Fritz!Card > options AVM_A1 > device isic0 at isa? port 0x300 irq 5 flags 4 > # > # ISDN Protocol Stack > # ------------------- > # > # Q.921 / layer 2 - i4b passive cards D channel handling > pseudo-device "i4bq921" > # > # Q.931 / layer 3 - i4b passive cards D channel handling > pseudo-device "i4bq931" > # > # layer 4 - i4b common passive and active card handling > pseudo-device "i4b" > # > # ISDN devices > # ------------ > # > # userland driver to do ISDN tracing (for passive cards only) > pseudo-device "i4btrc" 4 > # > # userland driver to control the whole thing > pseudo-device "i4bctl" > # > # userland driver for access to raw B channel > pseudo-device "i4brbch" 4 > # > # userland driver for telephony > pseudo-device "i4btel" 2 > # > # network driver for IP over raw HDLC ISDN > pseudo-device "i4bipr" 4 > # enable VJ header compression detection for ipr i/f > options IPR_VJ > # enable logging of the first n IP packets to isdnd (n=32 here) > #options IPR_LOG=32 > # > # network driver for sync PPP over ISDN > pseudo-device "i4bisppp" 4 > pseudo-device sppp > > ############################## > output of isdntrace -i while incoming call: > > =========== isdntrace controller #0 =========== started Thu May 25 22:03:00 2000 > > ############################## > /var/log/messages after run of isdntest: > > May 25 22:06:51 /kernel: i4b-L1-ph_data_req: No Space in TX FIFO, state = F4 Awaiting Signal > May 25 22:06:53 /kernel: i4b-L1-timer3_expired: state = F4 Awaiting Signal > May 25 22:06:53 /kernel: i4b-L1-isic_recover: HSCX B: ISTA = 0x0 > May 25 22:06:53 /kernel: i4b-L1-isic_recover: ISAC: ISTA = 0x15 > May 25 22:06:53 /kernel: i4b-L1-isic_recover: ISAC: EXIR = 0x10 > May 25 22:06:53 /kernel: i4b-L1-isic_recover: ISAC: CISQ = 0x12 > May 25 22:06:53 /kernel: i4b-L1-isic_recover: HSCX B: IMASK = 0xff > May 25 22:06:53 /kernel: i4b-L1-isic_recover: HSCX A: IMASK = 0xf8 > May 25 22:06:53 /kernel: i4b-L1-isic_recover: ISAC: IMASK = 0x2a > May 25 22:06:53 /kernel: i4b-L2-i4b_T202_timeout: unit 0, N202 = 3 > May 25 22:06:53 /kernel: i4b-L1-ph_data_req: still in state F3! > May 25 22:06:53 /kernel: i4b-L1-ph_data_req: No Space in TX FIFO, state = F4 Awaiting Signal > May 25 22:06:55 /kernel: i4b-L3-T303_timeout: SETUP not answered, cr = 45 > May 25 22:06:55 /kernel: i4b-L3-next_l3state: FSM illegal state, state = ST_OW - Out Wait EST, event = EV_T303EXP - T303 timeout! > May 25 22:06:55 /kernel: i4b-L1-timer3_expired: state = F4 Awaiting Signal > May 25 22:06:55 /kernel: i4b-L1-isic_recover: HSCX B: ISTA = 0x0 > May 25 22:06:55 /kernel: i4b-L1-isic_recover: ISAC: ISTA = 0x4 > May 25 22:06:55 /kernel: i4b-L1-isic_recover: ISAC: CISQ = 0x2 > May 25 22:06:55 /kernel: i4b-L1-isic_recover: HSCX B: IMASK = 0xff > May 25 22:06:55 /kernel: i4b-L1-isic_recover: HSCX A: IMASK = 0xf8 > May 25 22:06:55 /kernel: i4b-L1-isic_recover: ISAC: IMASK = 0x2a > May 25 22:09:16 /kernel: i4b-L2-i4b_dl_data_req: unit 0 ERROR in state [ST_EST_AW_TEI], freeing mbuf > May 25 22:09:50 /kernel: i4b-L3-T305_timeout: DISC not answered, cr = 45 > May 25 22:09:50 /kernel: i4b-L2-i4b_dl_data_req: unit 0 ERROR in state [ST_EST_AW_TEI], freeing mbuf > May 25 22:09:50 /kernel: i4b-L3-T308_timeout: REL not answered, cr = 45 > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-isdn" in the body of the message > > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-isdn" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?001501bfc72f$a80edd40$98dc049b>