Date: Sun, 2 Jan 2000 10:59:46 +0100 From: Bernd Walter <ticso@cicely.de> To: Gerard Roudier <groudier@club-internet.fr> Cc: freebsd-scsi@freebsd.org Subject: drive does not spinup using sym driver under FreeBSD-alpha Message-ID: <20000102105945.B33204@cicely8.cicely.de>
next in thread | raw e-mail | index | archive | help
I'm using the sym driver under FreeBSD alpha and I have two drives that
are configured to need a start command.
The drives in question are da6 and either da2 or da3.
Usually I would think it's a problem in a general layer but the drive on the
ahc0 apapter starts just fine.
Some interesting side point - SRM can't boot from from the sym1
controller even if it's alone in the host but ARC can.
The cards are nearly the same but sym1 already has the lsi logo and only sym0
has an external oszilator.
ahc0@pci0:5:0: class=0x010000 card=0x78819004 chip=0x81789004 rev=0x01 hdr=0x00
sym0@pci0:6:0: class=0x010000 card=0x00000000 chip=0x00011000 rev=0x12 hdr=0x00
sym1@pci0:7:0: class=0x010000 card=0x10001000 chip=0x00011000 rev=0x23 hdr=0x00
FreeBSD 4.0-CURRENT #5: Sat Jan 1 17:31:50 CET 2000
root@:/var/d2/src-1999-12-18-fschange/src/sys/compile/CICELY9
EB164
Digital AlphaPC 164 500 MHz, 500MHz
8192 byte page size, 1 processor.
CPU: EV56 (21164A) major=7 minor=2 extensions=0x1<BWX>
OSF PAL rev: 0x1000800020117
real memory = 64577536 (63064K bytes)
avail memory = 57901056 (56544K bytes)
Preloaded elf kernel "kernel" at 0xfffffc00005b8000.
cia0: ALCOR/ALCOR2, pass 3
cia0: extended capabilities: 21<DWEN,BWEN>
pcib0: <2117x PCI host bus adapter> on cia0
pci0: <PCI bus> on pcib0
ahc0: <Adaptec 2940 Ultra SCSI adapter> irq 2 at device 5.0 on pci0
ahc0: aic7880 Wide Channel A, SCSI Id=7, 16/255 SCBs
ahc0: interrupting at CIA irq 2
sym0: <810a> irq 0 at device 6.0 on pci0
sym0: No NVRAM, ID 7, Fast-10, parity checking
sym0: interrupting at CIA irq 0
sym1: <810a> irq 1 at device 7.0 on pci0
sym1: No NVRAM, ID 7, Fast-10, parity checking
sym1: interrupting at CIA irq 1
isab0: <Intel 82378IB PCI to ISA bridge> at device 8.0 on pci0
isa0: <ISA bus> on isab0
de0: <Digital 21143 Fast Ethernet> irq 3 at device 9.0 on pci0
de0: interrupting at CIA irq 3
de0: Cogent 21143 [10-100Mb/s] pass 2.1
de0: address 00:00:d1:19:de:1f
ata-pci0: <CMD 646 ATA controller (generic mode)> irq 5 at device 11.0 on pci0
ata-pci0: Busmastering DMA supported
ata0 at 0x01f0 irq 14 on ata-pci0
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A
sio0: interrupting at ISA irq 4
sio1: reserved for low-level i/o
fdc0: interrupting at ISA irq 6
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at ISA irq 1
vga0: <Generic ISA VGA> at port 0x3b0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
struct nfssvc_sock bloated (> 256bytes)
Try reducing NFS_UIDHASHSIZ
struct nfsuid bloated (> 128bytes)
Try unionizing the nu_nickname and nu_flag fields
Timecounter "alpha" frequency 500005500 Hz
ad0: <Conner Peripherals 1275MB - CFS1275A/0.28> ATA-0 disk at ata0 as master
ad0: 1219MB (2496816 sectors), 2477 cyls, 16 heads, 63 S/T, 512 B/S
ad0: 16 secs/int, 1 depth queue, PIO
Waiting 15 seconds for SCSI devices to settle
de0: enabling 100baseTX port
de0: enabling Full Duplex 100baseTX port
de0: link down: cable problem?
da0 at sym0 bus 0 target 0 lun 0
da0: <FUJITSU M1606S-512 6406> Fixed Direct Access SCSI-2 device
da0: 10.000MB/s transfers (10.000MHz, offset 8), Tagged Queueing Enabled
da0: 1041MB (2131992 512 byte sectors: 255H 63S/T 132C)
da2 at ahc0 bus 0 target 9 lun 0
da2: <SEAGATE ST318275LC 0001> Fixed Direct Access SCSI-2 device
da2: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da2: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da3 at ahc0 bus 0 target 10 lun 0
da3: <SEAGATE ST318275LC 0001> Fixed Direct Access SCSI-2 device
da3: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da3: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da1 at sym0 bus 0 target 1 lun 0
da1: <CDC 94191-15 0344> Fixed Direct Access SCSI-CCS device
da1: 3.300MB/s transfers
da1: 638MB (1308087 512 byte sectors: 64H 32S/T 638C)
da6 at sym1 bus 0 target 2 lun 0
da6: <DEC RZ55 (C) DEC 0900> Fixed Direct Access SCSI-CCS device
da6: 3.300MB/s transfers
da6: 316MB (649040 512 byte sectors: 64H 32S/T 316C)
da4 at sym0 bus 0 target 2 lun 0
da4: <IBM WDS-3100 !I S550> Fixed Direct Access SCSI-2 device
da4: 5.000MB/s transfers (5.000MHz, offset 7)
da4: 103MB (210944 512 byte sectors: 64H 32S/T 103C)
da5 at sym0 bus 0 target 4 lun 0
da5: <FUJITSU M2623S-512 0405> Fixed Direct Access SCSI-CCS device
da5: 3.300MB/s transfers
da5: 405MB (830340 512 byte sectors: 64H 32S/T 405C)
cd0 at sym1 bus 0 target 4 lun 0
cd0: <TOSHIBA CD-ROM XM-5401TA 3115> Removable CD-ROM SCSI-2 device
cd0: 4.237MB/s transfers (4.237MHz, offset 8)
cd0: cd present [314602 x 2048 byte records]
da7 at sym1 bus 0 target 3 lun 0
da7: <CDC 94221-5 5342> Fixed Direct Access SCSI-CCS device
da7: 3.300MB/s transfers
da7: 170MB (349770 512 byte sectors: 64H 32S/T 170C)
Mounting root from ufs:/dev/da0a
--
B.Walter COSMO-Project http://www.cosmo-project.de
ticso@cicely.de Usergroup info@cosmo-project.de
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20000102105945.B33204>