Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 26 Nov 2004 17:18:52 -0500
From:      "Michael G. Jung" <mikej@confluenttech.com>
To:        <freebsd-sparc64@freebsd.org>
Subject:   Re: 5.3 on ultra2: scsi disk not detected
Message-ID:  <9D7F0DF3FB16D41184010050DA90E0000181B881@neo.confluentasp.local>

next in thread | raw e-mail | index | archive | help
Apologies - this should have originated from a real email account....

I have had OpenBSD/NetBSD/Solaris on my Ultra2 and had no problems with=20
disk detection nor partitioning.  However, when I install 5.3 DA0 was=20
fine, DA1 was detected and I could partition it but when sysinstall went =

to run newfs it complained that the partitions on DA1 did not exist.  If =
I=20
went back and looked at the partitions on DA1 it indeed looked as if it=20
had not been partitioned.  I finally gave up and simply installed to=20
DA0 and once FreeBSD=20
was up and running manually partioned DA1 and ran newfs etc....

Other than this it has been very stable.  Just for reference here is my=20
system info:

#camcontrol devlist -v
scbus0 on esp0 bus 0:
<SEAGATE ST318203LC 0002>          at scbus0 target 0 lun 0 (pass0,da0)
<SEAGATE ST318203LC 0002>          at scbus0 target 1 lun 0 (pass1,da1)
<TOSHIBA XM5701TASUN12XCD 0997>    at scbus0 target 6 lun 0 (cd0,pass2)
<  >                               at scbus0 target -1 lun -1 ()
scbus1 on isp0 bus 0:
<  >                               at scbus1 target -1 lun -1 ()
scbus2 on isp1 bus 0:
<  >                               at scbus2 target -1 lun -1 ()
scbus-1 on xpt0 bus 0:
<  >                               at scbus-1 target -1 lun -1 (xpt0)
#

++++++++++++++++++++++++++++++++

#dmesg
stray vector interrupt 2033
cam: using minimum scsi_delay (100ms)
Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
 	The Regents of the University of California. All rights reserved.
FreeBSD 5.3-RELEASE #2: Mon Nov 15 18:13:25 EST 2004
     mikej@dual2.mikej.com:/usr/obj/usr/src/sys/DUAL2
real memory  =3D 939524096 (896 MB)
avail memory =3D 888422400 (847 MB)
cpu0: Sun Microsystems UltraSparc-II Processor (296.00 MHz CPU)
cpu1: Sun Microsystems UltraSparc-II Processor (296.00 MHz CPU)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
nexus0: <Open Firmware Nexus device>
sbus0: clock 25.000 MHz
sbus dvma: DVMA map: 0xfc000000 to 0xffffffff
sbus0: [FAST]
sbus0: [FAST]
initializing counter-timer
Timecounter "counter-timer" frequency 1000000 Hz quality 100
sbus0: <U2S UPA-SBus bridge> on nexus0
sbus0: <SUNW,CS4231>, type (unknown) (no driver attached)
sbus0: <auxio>, type (unknown) (no driver attached)
sbus0: <flashprom>, type (unknown) (no driver attached)
sbus0: <SUNW,fdtwo>, type block (no driver attached)
eeprom0: <EEPROM/clock> mem 0x1200000-0x1201fff on sbus0
eeprom0: model mk48t59
eeprom0: hostid 80935a58
puc0: <Zilog Z8530 dual channel SCC> mem 0x1100000-0x1100003 irq 2024 on =

sbus0
uart0: <z8530, channel A> on puc0
uart1: <z8530, channel B> on puc0
puc1: <Zilog Z8530 dual channel SCC> mem 0x1000000-0x1000003 irq 2024 on =

sbus0
uart2: <z8530, channel A> on puc1
uart3: <z8530, channel B> on puc1
sbus0: <sc>, type (unknown) (no driver attached)
sbus0: <SUNW,pll>, type (unknown) (no driver attached)
esp0: <Sun FAS366 Fast-Wide SCSI> mem=20
0x8810000-0x881003f,0x8800000-0x880000f irq 2016 on sbus0
esp0: [GIANT-LOCKED]
esp0: FAS366/HME, 40MHz, SCSI ID 7
hme0: <Sun HME 10/100 Ethernet> mem=20
0x8c07000-0x8c0701f,0x8c06000-0x8c07fff,0x8c04000-0x8c05fff,0x8c02000-0x8=
c03fff,0x8c00000-0x8c00107=20
irq 2017 on sbus0
miibus0: <MII bus> on hme0
nsphy0: <DP83840 10/100 media interface> on miibus0
nsphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme0: Ethernet address: 08:00:20:93:5a:58
hme0: if_start running deferred for Giant
hme0: [GIANT-LOCKED]
sbus0: <SUNW,bpp>, type (unknown) (no driver attached)
sbus0: <SUNW,rtvc>, type (unknown) (no driver attached)
isp0 mem 0x10000-0x1044f irq 1995 on sbus0
isp0: [GIANT-LOCKED]
hme1: <Sun HME 10/100 Ethernet> mem=20
0x8c07000-0x8c0701f,0x8c06000-0x8c07fff,0x8c04000-0x8c05fff,0x8c02000-0x8=
c03fff,0x8c00000-0x8c00107=20
irq 2004 on sbus0
miibus1: <MII bus> on hme1
qsphy0: <QS6612 10/100 media interface> on miibus1
qsphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme1: Ethernet address: 08:00:20:93:5a:58
hme1: if_start running deferred for Giant
hme1: [GIANT-LOCKED]
hme2: <Sun HME 10/100 Ethernet> mem=20
0x8c17000-0x8c1701f,0x8c16000-0x8c17fff,0x8c14000-0x8c15fff,0x8c12000-0x8=
c13fff,0x8c10000-0x8c10107=20
irq 2004 on sbus0
miibus2: <MII bus> on hme2
qsphy1: <QS6612 10/100 media interface> on miibus2
qsphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme2: Ethernet address: 08:00:20:93:5a:58
hme2: if_start running deferred for Giant
hme2: [GIANT-LOCKED]
hme3: <Sun HME 10/100 Ethernet> mem=20
0x8c27000-0x8c2701f,0x8c26000-0x8c27fff,0x8c24000-0x8c25fff,0x8c22000-0x8=
c23fff,0x8c20000-0x8c20107=20
irq 2004 on sbus0
miibus3: <MII bus> on hme3
qsphy2: <QS6612 10/100 media interface> on miibus3
qsphy2:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme3: Ethernet address: 08:00:20:93:5a:58
hme3: if_start running deferred for Giant
hme3: [GIANT-LOCKED]
hme4: <Sun HME 10/100 Ethernet> mem=20
0x8c37000-0x8c3701f,0x8c36000-0x8c37fff,0x8c34000-0x8c35fff,0x8c32000-0x8=
c33fff,0x8c30000-0x8c30107=20
irq 2004 on sbus0
miibus4: <MII bus> on hme4
qsphy3: <QS6612 10/100 media interface> on miibus4
qsphy3:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme4: Ethernet address: 08:00:20:93:5a:58
hme4: if_start running deferred for Giant
hme4: [GIANT-LOCKED]
isp1 mem 0x10000-0x1044f irq 2011 on sbus0
isp1: [GIANT-LOCKED]
creator0: <Creator3d> on nexus0
sc0: Unknown <16 virtual consoles, flags=3D0x200>
Timecounters tick every 10.000 msec
SMP: AP CPU #1 Launched!
da0 at esp0 bus 0 target 0 lun 0
da0: <SEAGATE ST318203LC 0002> Fixed Direct Access SCSI-2 device
da0: 20.000MB/s transfers (10.000MHz, offset 15, 16bit), Tagged Queueing =

Enabled
da0: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
da1 at esp0 bus 0 target 1 lun 0
da1: <SEAGATE ST318203LC 0002> Fixed Direct Access SCSI-2 device
da1: 20.000MB/s transfers (10.000MHz, offset 15, 16bit), Tagged Queueing =

Enabled
da1: 17366MB (35566480 512 byte sectors: 255H 63S/T 2213C)
cd0 at esp0 bus 0 target 6 lun 0
cd0: <TOSHIBA XM5701TASUN12XCD 0997> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: cd present [1295384 x 512 byte records]
Mounting root from ufs:/dev/da0a
#

--mikej



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?9D7F0DF3FB16D41184010050DA90E0000181B881>