Date: Sat, 28 Mar 1998 00:20:25 +0000 From: Andreadakis Manolis <andread@stat5.civil.auth.gr> To: aic7xxx@FreeBSD.ORG Subject: Problems with aic7880 (AGAIN) Message-ID: <351C4248.8B51D811@struct.civil.auth.gr> References: <351BCF99.5481B032@struct.civil.auth.gr> <351C3963.FFA57485@struct.civil.auth.gr>
next in thread | previous in thread | raw e-mail | index | archive | help
Hello again, the problem with my aic7880 continues to torture me...
Here is the output of my boot sequence:
(scsi0) ?Adaptec AIC-7880 Ultra SCSI host adapter? found at PCI 10/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(***)(scsi0) BIOS disabled, IO Port 0xf800, IO Mem 0xfecff000, IRQ 11
(scsi0) Resetting channel
(scsi0) Downloading sequencer code... 418 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.0.0/3.2.2
?Adaptec AIC-7880 Ultra SCSI host adapter?
scsi : 1 host.
(scsi0:0:-1:-1) Scanning channel for devices.
(scsi0:0:0:0) Using wide (16 bit) transfers.
(scsi0:0:0:0) Synchronous at 20.0MHz, offset 8.
Vendor: HP Model: 4.26GB B 68-0854 Rev: 0854
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:1:0) Using wide (16 bit) transfers.
(scsi0:0:1:0) Synchronous at 20.0MHz, offset 8.
Vendor: SEAGATE Model: ST34572W Rev: 0784
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
scsi : detected 2 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8330543 [4067 MB] [4.1
GB]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 8888924 [4340 MB] [4.3
GB]
Both disks are wide and on the same cable and there is a termitator at
the end of it.
I cannot mkefs the second disk, when i try it, somewhere in the middle
of the
whole process i get messages about timeout's and bus resets.
Could anyone tell me about the correct jumper positions on the disks,
this is the one think
i suspect, the other is the message above that the BIOS is disabled. Is
this
normal, considering that in the SCSI utility at boot, the BIOS Enable
option is set to on?
I have checked the cable so that it doesnt make any twists, and the two
disks, as far as
i could figure out dont terminate them selves the bus.
Thanks in advance.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?351C4248.8B51D811>