Date: Fri, 15 Oct 2004 11:36:37 +0200 From: Kenneth Vestergaard Schmidt <kvs@binarysolutions.dk> To: freebsd-current@freebsd.org Subject: Re: Promise SATAII 150 TX4 Message-ID: <20041015093637.GM1126@binarysolutions.dk> In-Reply-To: <416EB73B.8040900@DeepCore.dk> References: <867jpt5lj2.fsf@borg.borderworlds.dk> <416EB73B.8040900@DeepCore.dk>
next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, Oct 14, 2004 at 07:28:27PM +0200, Søren Schmidt wrote: > >Adding their PCI id's to the existing driver didn't seem to be enough. > > > >Is support for this controller in the works? > > Not yet at least, but if you are in a hurry you could ship me one and > I'll look into it :) We might just do that. One quick question before, though: Adding the PCI ID's does get the card recognized, but it doesn't find any drives: atapci0: <Promise PDC40518 SATA150 controller> port 0xc400-0xc4ff,0xc000-0xc07f mem 0xe9000000-0xe901ffff,0xe9020000-0xe9020fff irq 11 at device 9.0 on pci1 atapci0: failed: rid 0x20 is memory, requested 4 atapci0: Reserved 0x20000 bytes for rid 0x20 type 3 at 0xe9000000 atapci0: Reserved 0x1000 bytes for rid 0x1c type 3 at 0xe9020000 atapci0: [MPSAFE] ata2: channel #0 on atapci0 ata2: reset tp1 mask=00 ostat0=ff ostat1=ff ata2: [MPSAFE] The last three lines are repeated for ata3-5 as well. Later, the following shows up: Interrupt storm detected on "irq11: atapci0"; throttling interrupt source ata0-slave: pio=0x0c wdma=0x22 udma=0x46 cable=80pin ata0-slave: setting PIO4 on Intel ICH4 chip ata0-slave: setting UDMA100 on Intel ICH4 chip ad1: <MAXTOR 6L040L2/A93.0500> ATA-5 disk at ata0-slave ad1: 38172MB (78177792 sectors), 77557 C, 16 H, 63 S, 512 B ad1: 16 secs/int, 1 depth queue, UDMA100 (ata0-slave/ad1 belongs to atapci1, which is just an onboard ICH4) Does this ring a bell and inspire a quick fix, or do you need the hardware to fix this? Thanks in advance.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20041015093637.GM1126>