Date: Mon, 20 Apr 1998 13:21:08 -0500 From: Doug Ledford <dledford@dialnet.net> To: Peter Pointner <peter@wuzel.m.isar.de> Cc: aic7xxx@FreeBSD.ORG Subject: Re: More problems with AIC-7861 Rev. 3 Message-ID: <353B9214.FBF1D69D@dialnet.net> References: <Pine.LNX.3.96.980420193712.267A-100000@wuzel.m.isar.de>
next in thread | previous in thread | raw e-mail | index | archive | help
Peter Pointner wrote:
>
> Hello,
>
> I still cannot get the new 2940AU stable on a Tyan PPro motherboard.
> Meanwhile I tried it in a different system: A DTK board with a 233 MHz
> AMD K6. Result: The slightly patched 2.0.29 kernel I normally use seems to
> work. At least it runs "bonnie -s 1000" without scsi timeouts.
>
> But Linux with 2.0.33 and aic7xxx 5.0.12 does not even detect the devices:
> Timeout on test unit ready, then continuously on reset. If I replace the
> adapter with an older one (with AIC-7861 Rev. 1), all is okay.
>
> Any ideas?
Sure, boot up the machine without any devices attached to the card, use the
command line aic7xxx=verbose:0xffff and then get me the output of the bootup
messages in their entirety and I'll see if I can figure out what's going
on. Also, send me a list of the devices that would normally be connected to
this controller, the output of /proc/scsi/scsi will be sufficient for this.
--
Doug Ledford <dledford@dialnet.net>
Opinions expressed are my own, but
they should be everybody's.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?353B9214.FBF1D69D>