From owner-freebsd-questions Thu Mar 2 23:18:18 1995 Return-Path: questions-owner Received: (from majordom@localhost) by freefall.cdrom.com (8.6.9/8.6.6) id XAA03593 for questions-outgoing; Thu, 2 Mar 1995 23:18:18 -0800 Received: from argon.chem.ucla.edu (argon.chem.ucla.edu [128.97.35.240]) by freefall.cdrom.com (8.6.9/8.6.6) with SMTP id XAA03587 for ; Thu, 2 Mar 1995 23:18:16 -0800 From: barkovich@uclac1.chem.ucla.edu Received: from UCLAC1 (uclac1.chem.ucla.edu) by argon.chem.ucla.edu (Sendmail 4.1/1.08) id AA10182; Thu, 2 Mar 95 23:08:34 PST Message-Id: <9503030708.AA10182@argon.chem.ucla.edu> Date: Thu, 2 Mar 1995 23:07:41 -0800 To: questions@FreeBSD.org Subject: installation X-Vms-To: SMTP%"questions@FreeBSD.org" Sender: questions-owner@FreeBSD.org Precedence: bulk I am trying to install FreeBSD 2.0 for Intel-based PCs and ran into a problem. My CD-ROM drive is attached to a Pro Audio Spectrum 16 sound card. My disk controller is an Adaptec 2842. When I tried to install FreeBSD from CD-ROM, the installation program cound not find my CD-ROM drive. Upon further inspection, I noticed the following message in the kernel "pas0 not probed due to i/o address conflict with ahc0 at 0x1f88". For ahc0 -- "ahc0 at 0x1000 - 0x1fff irq 11 on eisa". I could not manage to get FreeBSD to recognize my CD-ROM drive without disabling my disk controller (ahc0) which caused the panic message and reboot. If there is any solution to this I would appreciate if you could tell me. The only solution I can think of is to hook the CD-ROM directly to my Adaptec controller, but I would prefer other options as I would have to switch the SCSI cable any time I switched from DOS to BSD because I have programs already set for the previous configuration. Sorry about going off on this. I'd appreciate any help...Thanks... Robert Barkovich barkovich@uclach.chem.ucla.edu