Date: Wed, 24 Mar 2010 15:12:36 +0100 From: Andreas <andreas@cyberdelic.org> To: freebsd-sparc64@freebsd.org Subject: Dmesg sunblade 1000 Message-ID: <dad5e0661003240712h3225f8b9v30509104c3031770@mail.gmail.com>
next in thread | raw e-mail | index | archive | help
Copyright (c) 1992-2009 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 =A0 =A0 =A0 =A0The Regents of the University of California. All rights rese= rved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 8.0-RELEASE #0: Sat Nov 21 22:40:34 UTC 2009 =A0 =A0root@araz.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC real memory =A0=3D 2147483648 (2048 MB) avail memory =3D 2079744000 (1983 MB) cpu0: Sun Microsystems UltraSparc-III Processor (900.00 MHz CPU) cpu1: Sun Microsystems UltraSparc-III Processor (900.00 MHz CPU) FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs ispfw: registered firmware <isp_1000> ispfw: registered firmware <isp_1040> ispfw: registered firmware <isp_1040_it> ispfw: registered firmware <isp_1080> ispfw: registered firmware <isp_1080_it> ispfw: registered firmware <isp_12160> ispfw: registered firmware <isp_12160_it> ispfw: registered firmware <isp_2100> ispfw: registered firmware <isp_2200> ispfw: registered firmware <isp_2300> ispfw: registered firmware <isp_2322> ispfw: registered firmware <isp_2400> ispfw: registered firmware <isp_2400_multi> ispfw: registered firmware <isp_2500> ispfw: registered firmware <isp_2500_multi> kbd0 at kbdmux0 nexus0: <Open Firmware Nexus device> nexus0: <memory-controller> mem 0x40000400000-0x40000400047 type memory-controller (no driver attached) nexus0: <memory-controller> mem 0x40000c00000-0x40000c00047 type memory-controller (no driver attached) pcib0: <Sun Host-PCI bridge> mem 0x40004700000-0x40004717fff,0x40004410000-0x4000441004f,0x7ffee000000-0x7ff= ee0000ff irq 563,560,561,564,550 on nexus0 pcib0: Schizo, version 4, IGN 0x8, bus B, 33MHz pcib0: DVMA map: 0xc0000000 to 0xffffffff pcib0: [FILTER] pcib0: [FILTER] pcib0: [FILTER] pcib0: [FILTER] pci0: <OFW PCI bus> on pcib0 ebus0: <PCI-EBus3 bridge> mem 0x7d000000-0x7dffffff,0x7e000000-0x7e7fffff at device 5.0 on pci0 ebus0: <flashprom> addr 0-0x1fffff (no driver attached) ebus0: <bbc> addr 0x100000000-0x1000fffff (no driver attached) ebus0: <ppm> addr 0x10000000e-0x100000028,0x100728000-0x100728003,0x10030002e-0x10030002f,0x1= 00300600-0x100300607 (no driver attached) ebus0: <i2c> addr 0x10000002e-0x10000002f,0x10000002d irq 35 (no driver attached) ebus0: <i2c> addr 0x100000030-0x100000031 irq 35 (no driver attached) ebus0: <beep> addr 0x100000032-0x100000037 (no driver attached) ebus0: <audio> addr 0x100200000-0x1002000ff,0x100702000-0x10070200f,0x100704000-0x10070400f,0x1= 00722000-0x100722003 irq 32,33 (no driver attached) rtc0: <Real-Time Clock> addr 0x100300070-0x100300071 irq 36 on ebus0 ebus0: <gpio> addr 0x100300600-0x100300607 (no driver attached) ebus0: <pmc> addr 0x100300700-0x100300701 (no driver attached) ebus0: <floppy> addr 0x1003023f0-0x1003023f7,0x100706000-0x10070600f,0x100720000-0x100720003 irq 37 (no driver attached) ebus0: <parallel> addr 0x100300278-0x100300287,0x10030002e-0x10030002f,0x100700000-0x10070000f irq 28 (no driver attached) scc0: <Siemens SAB 82532 dual channel SCC> addr 0x100400000-0x10040007f irq 34 on ebus0 scc0: [FILTER] uart0: <SAB 82532 v3.2, channel A> on scc0 uart0: [FILTER] uart0: CTS oflow uart1: <SAB 82532 v3.2, channel B> on scc0 uart1: [FILTER] uart1: CTS oflow gem0: <Sun ERI 10/100 Ethernet> mem 0x100000-0x11ffff at device 5.1 on pci0 miibus0: <MII bus> on gem0 ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0 ukphy0: =A010baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto gem0: 2kB RX FIFO, 2kB TX FIFO gem0: Ethernet address: 00:03:ba:12:5f:f5 gem0: [ITHREAD] fwohci0: <Sun PCIO-2> mem 0x120000-0x1207ff,0x122000-0x1227ff at device 5.2 on pci0 fwohci0: [ITHREAD] fwohci0: OHCI version 1.0 (ROM=3D0) fwohci0: No. of Isochronous channels is 4. fwohci0: EUI64 00:03:ba:ff:fe:12:5f:f5 fwohci0: Phy 1394a available S400, 4 ports. fwohci0: Link S400, max_rec 2048 bytes. firewire0: <IEEE1394(FireWire) bus> on fwohci0 fwip0: <IP over FireWire> on firewire0 fwip0: Firewire address: 00:03:ba:ff:fe:12:5f:f5 @ 0xfffe00000000, S400, maxrec 2048 dcons_crom0: <dcons configuration ROM> on firewire0 dcons_crom0: bus_addr 0xc1128000 fwe0: <Ethernet over FireWire> on firewire0 if_fwe0: Fake Ethernet address: 02:03:ba:12:5f:f5 fwe0: Ethernet address: 02:03:ba:12:5f:f5 fwohci0: Initiate bus reset fwohci0: fwohci_intr_core: BUS reset fwohci0: fwohci_intr_core: node_id=3D0x00000000, SelfID Count=3D1, CYCLEMAS= TER mode ohci0: <Sun PCIO-2 USB controller> mem 0x1000000-0x1007fff at device 5.3 on= pci0 ohci0: [ITHREAD] usbus0: <Sun PCIO-2 USB controller> on ohci0 sym0: <875> port 0x300-0x3ff mem 0x124000-0x1240ff,0x126000-0x126fff at device 6.0 on pci0 sym0: No NVRAM, ID 7, Fast-20, SE, parity checking sym0: [ITHREAD] sym1: <875> port 0x400-0x4ff mem 0x128000-0x1280ff,0x12a000-0x12afff at device 6.1 on pci0 sym1: No NVRAM, ID 7, Fast-20, SE, parity checking sym1: [ITHREAD] pcib1: <Sun Host-PCI bridge> mem 0x40004600000-0x40004617fff,0x40004410000-0x4000441004f,0x7ffec000000-0x7ff= ec0000ff irq 562,560,561,564,551 on nexus0 pcib1: Schizo, version 4, IGN 0x8, bus A, 66MHz Timecounter "pcib1" frequency 150000000 Hz quality 100 pcib1: DVMA map: 0xc0000000 to 0xffffffff pcib1: [FILTER] pci1: <OFW PCI bus> on pcib1 isp0: <Qlogic ISP 2200 PCI FC-AL Adapter> port 0x300-0x3ff mem 0x100000-0x100fff at device 4.0 on pci1 isp0: [ITHREAD] isp0: invalid NVRAM header isp0: invalid NVRAM header isp0: bad frame length (0) from NVRAM- using 1024 isp0: bad execution throttle of 0- using 16 upa0: <UPA bridge> mem 0x40004480000-0x4000448001f,0x40004706000-0x4000470600f,0x40004708000-0x400= 0470800f on nexus0 creator0: <Elite3D> mem 0x1c000000000-0x1c0000003ff,0x1c000400000-0x1c0005fffff,0x1c000600000-0x1c0= 007fffff,0x1c001000000-0x1c0013fffff,0x1c001400000-0x1c0017fffff,0x1c001800= 000-0x1c001bfffff,0x1c001c00000-0x1c001ffffff,0x1c002000000-0x1c002ffffff,0= x1c003000000-0x1c003ffffff,0x1c004000000-0x1c0043fffff,0x1c004400000-0x1c00= 47fffff,0x1c004800000-0x1c004bfffff,0x1c004c00000-0x1c004ffffff,0x1c0050000= 00-0x1c005ffffff,0x1c006000000-0x1c007ffffff irq 554 on upa0 creator0: console creator0: resolution 1152x900 schppm0: <Schizo power management> mem 0x40004410050-0x40004410057 on nexus= 0 syscons0: <System console> on nexus0 syscons0: Unknown <16 virtual consoles, flags=3D0x300> Timecounter "tick" frequency 900000000 Hz quality 10 Timecounters tick every 1.000 msec Waiting 5 seconds for SCSI devices to settle firewire0: 1 nodes, maxhop <=3D 0 cable IRM irm(0) =A0(me) firewire0: bus manager 0 usbus0: 12Mbps Full Speed USB v1.0 ugen0.1: <SUN> at usbus0 uhub0: <SUN OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0 uhub0: 4 ports with 4 removable, self powered ugen0.2: <vendor 0x0430> at usbus0 ukbd0: <vendor 0x0430 product 0x0005, class 0/0, rev 1.00/1.02, addr 2> on usbus0 kbd1 at ukbd0 (probe6:sym0:0:6:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 (probe6:sym0:0:6:0): CAM Status: SCSI Status Error (probe6:sym0:0:6:0): SCSI Status: Check Condition (probe6:sym0:0:6:0): UNIT ATTENTION asc:29,0 (probe6:sym0:0:6:0): Power on, reset, or bus device reset occurred (probe6:sym0:0:6:0): Retrying Command (per Sense Data) (probe6:sym0:0:6:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 (probe6:sym0:0:6:0): CAM Status: SCSI Status Error (probe6:sym0:0:6:0): SCSI Status: Check Condition (probe6:sym0:0:6:0): NOT READY asc:3a,0 (probe6:sym0:0:6:0): Medium not present (probe6:sym0:0:6:0): Unretryable error SMP: AP CPU #1 Launched! cd0 at sym0 bus 0 target 6 lun 0 cd0: <TEAC CD-ROM CD-516S 1.0G> Removable CD-ROM SCSI-2 device cd0: 10.000MB/s transfers (10.000MHz, offset 8) cd0: Attempt to query device size failed: NOT READY, Medium not present da0 at sym0 bus 0 target 0 lun 0 da0: <QUANTUM FIREBALL ST6.4S 0F0C> Fixed Direct Access SCSI-2 device da0: 20.000MB/s transfers (20.000MHz, offset 15) da0: Command Queueing enabled da0: 6180MB (12657717 512 byte sectors: 255H 63S/T 787C) GEOM: da0: adding VTOC8 information. Trying to mount root from ufs:/dev/da0a Invalid time in real time clock. Check and reset the date immediately!
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?dad5e0661003240712h3225f8b9v30509104c3031770>