From owner-freebsd-questions Sun Mar 31 02:08:37 1996 Return-Path: owner-questions Received: (from root@localhost) by freefall.freebsd.org (8.7.3/8.7.3) id CAA14747 for questions-outgoing; Sun, 31 Mar 1996 02:08:37 -0800 (PST) Received: from riley-net170-164.uoregon.edu (cisco-ts10-line12.uoregon.edu [128.223.150.110]) by freefall.freebsd.org (8.7.3/8.7.3) with SMTP id CAA14741 for ; Sun, 31 Mar 1996 02:08:30 -0800 (PST) Received: (from dwhite@localhost) by riley-net170-164.uoregon.edu (8.6.12/8.6.12) id CAA01272; Sun, 31 Mar 1996 02:09:13 -0800 Date: Sun, 31 Mar 1996 02:09:13 -0800 (PST) From: Doug White Reply-To: dwhite@resnet.uoregon.edu To: Kanokphan Sangsuriya cc: questions@freebsd.org Subject: Re: Installation problem In-Reply-To: Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-questions@freebsd.org X-Loop: FreeBSD.org Precedence: bulk On Fri, 29 Mar 1996, Kanokphan Sangsuriya wrote: > > Hi there, > > Please help me to fix this problem as follows. I had try to install > > FreeBSD 2.1.0-RELEASE many time by ftp or nfs but the problems is I can't > > connect to my ethernet port thus i am using SMC8000 series that is > > supported. The installation program prompt to select eithet slip port to > > plip port , no ethernet port at all. I tried to use lp0 port but didn't > > work...it said can't configure this lp0 port. What should i do ??? Put "-c" on the Boot: prompt at startup, enter "visual" mode and reconfigure the proper driver (I can't remember which) and make sure the IRQ, base address, and shared memory addresses are set properly. Doug White | University of Oregon Internet: dwhite@resnet.uoregon.edu | Residence Networking Assistant http://gladstone.uoregon.edu/~dwhite | Computer Science Major