Date: Fri, 22 Aug 2003 17:59:33 +0700 From: "Oleg I. Pleshkov" <olegip@tcc.tomsk.ru> To: freebsd-questions@freebsd.org Subject: problem Raidtec and Qlogic 2312 Message-ID: <49178438734.20030822175933@tcc.tomsk.ru>
next in thread | raw e-mail | index | archive | help
Hello freebsd-questions, I have problem with SAN Raidtec and HBA Qlogic 2312 Appeared the problem with new Raidtec 2208. At copying of the files from Raidtec to local disk, as well as inwardly Raidtec, warning appear in log files both in FreeBSD 4.8. The speed herewith decreases in several times in contrast with copying from Raidtec to local disk. Was noticed that process of copying seasonly stops for several seconds and then lasts. However copying from local disk to Raidtec occurs always orderly and with good speed. That this for problem and as its possible solve. boot log: isp0: <Qlogic ISP 2312 PCI FC-AL Adapter> port 0x2000-0x20ff mem 0xf79f0000-0xf7 9f0fff irq 5 at device 2.0 on pci0 isp0: Board Type 2312, Chip Revision 0x2, loaded F/W Revision 3.1.20 isp0: Firmware Attributes = 0x17 isp0: Installed in 64-Bit PCI slot isp0: 744 max I/O commands supported isp0: NVRAM Port WWN 0x210000e08b0a4815 isp0: NVRAM: maxfrmlen 2048 execthrottle 16 fwoptions 0x6 loopid 0 isp0: Setting ICB Node 0x200000e08b0a4815 Port 0x210000e08b0a4815 isp0: isp_fibre_init: fwopt 0xc106 xfwopt 0x25 zfwopt 0x8000 isp0: ISPASYNC_LIP: freeze simq (loopdown) isp0: LIP Received isp0: ISPASYNC_LIP: mark frozen (loopdown) isp0: LIP Received isp0: Loop UP isp0: Port Database Changed isp0: kthread: checking FC state isp0: Firmware State <Config Wait->Ready> isp0: 2Gb link speed/s isp0: Loop ID 0, AL_PA 0xef, Port ID 0xef, Loop State 0x2, Topology 'Private Loo p' isp0: Target 0 (Loop 0x0) Port ID 0xef (role Initiator) Arrived Port WWN 0x210000e08b0a4815 Node WWN 0x200000e08b0a4815 isp0: Target 124 (Loop 0x7c) Port ID 0x2 (role Target) Arrived Port WWN 0x21000010e9034333 Node WWN 0x20000010e9034333 isp0: kthread: releasing simq isp0: freeze devq 0.0 cam sts 4a scsi sts 0 isp0: freeze devq 1.0 cam sts 4a scsi sts 0 ... isp0: freeze devq 123.0 cam sts 4a scsi sts 0 isp0: freeze devq 125.0 cam sts 4a scsi sts 0 ... isp0: (0.124.0): FIN dl20 resid 0 STS 0x2 SKEY 6 XS_ERR=0x0 isp0: freeze devq 124.0 cam sts cc scsi sts 2 ... isp0: freeze devq 252.0 cam sts 4a scsi sts 0 isp0: freeze devq 253.0 cam sts 4a scsi sts 0 da0 at isp0 bus 0 target 124 lun 0 da0: <RAIDTEC fs-cache 0245> Fixed Direct Access SCSI-2 device da0: 200.000MB/s transfers, Tagged Queueing Enabled da0: 350030MB (716861440 512 byte sectors: 255H 63S/T 44622C) da1 at isp0 bus 0 target 124 lun 1 da1: <RAIDTEC test-nocache 0245> Fixed Direct Access SCSI-2 device da1: 200.000MB/s transfers, Tagged Queueing Enabled da1: 350030MB (716861440 512 byte sectors: 255H 63S/T 44622C) messages.log: ... Aug 22 17:29:33 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147463167, status not marked) Aug 22 17:29:33 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 Aug 22 17:29:34 bill3 /kernel: isp0: freeze devq 124.1 cam sts 59 scsi sts 0 Aug 22 17:29:40 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147481599, status not marked) Aug 22 17:29:41 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 Aug 22 17:29:41 bill3 /kernel: isp0: freeze devq 124.1 cam sts 59 scsi sts 0 Aug 22 17:30:41 bill3 /kernel: isp0: command timed out for 0.124.1 Aug 22 17:30:42 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0xb Aug 22 17:30:43 bill3 /kernel: isp0: freeze devq 124.1 cam sts 4b scsi sts 0 Aug 22 17:30:53 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147465215, status not marked) Aug 22 17:30:54 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 Aug 22 17:30:55 bill3 /kernel: isp0: freeze devq 124.1 cam sts 59 scsi sts 0 Aug 22 17:31:48 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147481599, status not marked) Aug 22 17:31:49 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 Aug 22 17:31:50 bill3 /kernel: isp0: freeze devq 124.1 cam sts 59 scsi sts 0 Aug 22 17:31:51 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147481599, status not marked) Aug 22 17:31:51 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 Aug 22 17:31:52 bill3 /kernel: isp0: freeze devq 124.1 cam sts 59 scsi sts 0 Aug 22 17:31:59 bill3 /kernel: isp0: bad underrun for 124.1 (count 65536, resid 2147426303, status not marked) Aug 22 17:31:59 bill3 /kernel: isp0: (0.124.1): FIN dl65536 resid 0 STS 0x0 SKEY . XS_ERR=0x19 ..... -- Best regards, Oleg I. Pleshkov mailto:olegip@tcc.tomsk.ru
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?49178438734.20030822175933>