Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 30 May 2001 15:17:22 +0200 (CEST)
From:      Riccardo.Veraldi@fi.infn.it
To:        <freebsd-alpha@freebsd.org>
Subject:   100Mbps dc0 settings
Message-ID:  <Pine.NEB.4.33.0105301514520.3630-100000@nikita.fi.infn.it>

next in thread | raw e-mail | index | archive | help


Hello, always the same Miata MX5:
dc0: <Intel 21143 10/100BaseTX> port 0x9000-0x907f mem 0x81340000-0x8134007f irq 0 at device 3.0 on pci0
dc0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet 192.84.146.216 netmask 0xffffff00 broadcast 192.84.146.255
        inet6 fe80::200:f8ff:fe75:81c0%dc0 prefixlen 64 scopeid 0x1
        ether 00:00:f8:75:81:c0
        media: 10baseT/UTP status: active
        supported media: autoselect 100baseTX <full-duplex> 100baseTX
10baseT/UT
P <full-duplex> 10baseT/UTP 100baseTX <hw-loopback>

How can I ru nit at 100Mbps full-duplex ??
ACtually it is attached on a 100Mbps switch, how can I force it to 100Mbps ??
Seems like the autosensing of speed is not working.

thanks

Rick



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.NEB.4.33.0105301514520.3630-100000>