From owner-freebsd-questions Thu Apr 26 17: 1: 3 2001 Delivered-To: freebsd-questions@freebsd.org Received: from ns1.coastsight.com (ns1.coastsight.com [208.46.230.17]) by hub.freebsd.org (Postfix) with ESMTP id 380F837B422 for ; Thu, 26 Apr 2001 17:01:00 -0700 (PDT) (envelope-from maillist@coastsight.com) Received: from ns1.coastsight.com ([208.46.230.17]) by ns1.coastsight.com with esmtp (Exim 2.05 #1) id 14svgx-0009lA-00; Thu, 26 Apr 2001 17:00:59 -0700 Date: Thu, 26 Apr 2001 17:00:59 -0700 (PDT) From: Rick Duvall To: Mike Vierow Cc: freebsd-questions@FreeBSD.ORG Subject: Re: Networking information source In-Reply-To: Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG Is your FreeBSD box hooked directly to the frame-relay or point to point connection to your ISP, or do you have a router and the FreeBSD box is hooked to the router over ethernet? It could be that your router (the one hooked to the upstream provider) has the entire class c routed to it's ethernet interface, in which you can only put nodes on it. If you set up that router to do private IP on a crossover cable to your freebsd box (multihomed freebsd), then on do gateway_enable in /etc/rc.conf, and from the other router hooked to your ISP you set a static route to the private ip address of your freebsd box. Then, on the other Freebsd nic, set an IP address and netmask for the NIC, then that will work. Have I thoroughly confused you yet? If your freebsd box is hooked directly to your ISP, then you just need to set your IP address and netmask for your NIC on the ethernet network. 255.255.255.0 will be your netmask. That's 24 bits for network and 8 bits for host. Sincerely, Rick Duvall On Thu, 26 Apr 2001, Mike Vierow wrote: > I have a class c that I am attempting to route through a FreeBSD box, but with > little success. The class c is provided by my service provider and is available > on my local network. Would all I need is a static route, or do I need to run > routed to alert my Cisco router that that class c needs to go one hop further? > If this class c was xxx.yyy.zzz.0, and my interfaces were xl0 and xl1, what > would may config look like? > > I have searched for info regarding this, but all I have found is the man page of > routed, and several unhelpful mailing list posts. Can someone direct me to a > source where I can learn more information about this? TIA > > Mike > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-questions" in the body of the message > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message