Date: Wed, 30 May 2001 09:57:47 -0400 (EDT) From: Andrew Gallatin <gallatin@cs.duke.edu> To: Riccardo.Veraldi@fi.infn.it Cc: <freebsd-alpha@FreeBSD.ORG> Subject: Re: 100Mbps dc0 settings Message-ID: <15124.64603.281236.755524@grasshopper.cs.duke.edu> In-Reply-To: <Pine.NEB.4.33.0105301514520.3630-100000@nikita.fi.infn.it> References: <Pine.NEB.4.33.0105301514520.3630-100000@nikita.fi.infn.it>
next in thread | previous in thread | raw e-mail | index | archive | help
Riccardo.Veraldi@fi.infn.it writes:
>
>
> Hello, always the same Miata MX5:
> dc0: <Intel 21143 10/100BaseTX> port 0x9000-0x907f mem 0x81340000-0x8134007f irq 0 at device 3.0 on pci0
> dc0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> inet 192.84.146.216 netmask 0xffffff00 broadcast 192.84.146.255
> inet6 fe80::200:f8ff:fe75:81c0%dc0 prefixlen 64 scopeid 0x1
> ether 00:00:f8:75:81:c0
> media: 10baseT/UTP status: active
> supported media: autoselect 100baseTX <full-duplex> 100baseTX
> 10baseT/UT
> P <full-duplex> 10baseT/UTP 100baseTX <hw-loopback>
>
> How can I ru nit at 100Mbps full-duplex ??
> ACtually it is attached on a 100Mbps switch, how can I force it to 100Mbps ??
> Seems like the autosensing of speed is not working.
Yes, because you've disabled autoselecting. If it were
autoselecting, the media line would say so:
media: autoselect (100baseTX <full-duplex>) status: active
Note the world "autoselect"
Read the ifconfig(8) and dc(4) man pages to learn how to enable
autoselect.
BTW, autoselect is almost certainly disabled because FreeBSD/alpha
preserves the SRM console media settings when possible. So there are
2 ways to make it autoselect -- set the media option of ifconfig, or
set it to autoselect in the SRM console via the ewaX_mode variable.
Drew
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?15124.64603.281236.755524>