Date: Fri, 19 Sep 2014 04:49:44 -0700 From: Frank Mayhar <fmayhar@gmail.com> To: freebsd-hackers <freebsd-hackers@freebsd.org> Subject: Re: "Invalid partition table" on 10-stable. Solved. Ish. Message-ID: <1411127384.92654.9.camel@jill.exit.com> In-Reply-To: <1411013471.25791.52.camel@jill.exit.com> References: <1411013471.25791.52.camel@jill.exit.com>
next in thread | previous in thread | raw e-mail | index | archive | help
On Wed, 2014-09-17 at 21:11 -0700, Frank Mayhar wrote: > Someone please give me a hint of what's going on here. I just got a > Dell Precision M6800. It's not doing UEFI, it's all legacy. I pulled > the installed drive and dropped in a Seagate hybrid 1T drive, then tried > (and tried, and tried, and tried) to install 10-stable on it. I'm using > a memstick image, btw. > > No matter what I try and no matter whether I use bsdinstall or do the > gpart stuff by hand, everything goes fine until I try to boot the new > install when all I get is "Invalid partition table!" And nothing. > > Am I going to have to use a legacy MBR and disklabel rather than gpt? > Can anyone give me any hints as to what I might look for? I've googled > to no avail (just some stuff from 2010 that doesn't seem to apply). > > I really want to follow the setup outlined at > https://wiki.freebsd.org/RootOnZFS/GPTZFSBoot . Well, I got it going. In fact, when I got home last night I found that it was sitting there running FreeBSD off the disk. After some experimentation, I found that I had left it in legacy boot mode after strictly following the instructions in the above web page. And I think I had set the MBR to active, although I can't really remember. Even with that hack, however, UEFI just plain didn't work. It didn't find the bootable partition; when I tried to get it to look for it it claimed "Operating System not found" or something along those lines. It may well be looking for Windows only, I guess. Fortunately I can live with legacy boot. I reinstalled that way, following a slightly-modified version of the ZFS-root instructions above, and I'm installing ports as I write this. So, notwithstanding the lack of UEFI support, success! -- Frank Mayhar frank@exit.com
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?1411127384.92654.9.camel>